Installation of a Haxxair T2D Mini Split in Côte Saint-Luc, Montreal
Elevate your home's climate control with the ultra-efficient Haxxair T2D Mini Split – expertly installed by AirGreen in Côte Saint-Luc.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Innovating Comfort with Precision: A Closer Look at the Haxxair T2D Mini Split Installation
When it comes to enhancing home comfort with advanced heating and cooling solutions, AirGreen stands at the forefront, especially in the vibrant community of Côte Saint-Luc, Montreal. Our recent installation of the Haxxair T2D Mini Split system not only underscores our commitment to delivering top-tier HVAC solutions but also highlights the unique aspects of this model, favored by many for its efficiency and innovative features.
A Detailed Overview of the Haxxair T2D Mini Split
The Haxxair T2D is a standout model in the world of mini split systems, boasting an impressive 18,000 BTU capacity that can handle both the sweltering summers and chilly winters of Montreal. One of the key highlights of this system is its remarkable 23.2 SEER efficiency rating, which ensures substantial energy savings throughout its lifecycle. The unit's ability to operate effectively down to -25°C makes it an invaluable asset during Montreal's harsh winter months.
Equipped with 3D inverter technology and an optimized inner air duct, the Haxxair T2D maximizes airflow and minimizes noise, ensuring a quiet environment conducive to relaxation and sleep. Its ultra-quiet mode, leveraging advanced acoustics and airflow principles, significantly reduces noise levels to a mere whisper, making it an ideal choice for families seeking peace and tranquility.
Furthermore, the installation incorporates advanced features such as R-410A gas for eco-friendliness and a sophisticated heating element in the compressor’s condensation tray. This feature is crucial for preventing ice accumulation during winter, thereby enhancing the unit’s durability and performance.
Strategic Installation for Optimal Performance
The installation process at a charming residence in Côte Saint-Luc was meticulously planned and executed by our skilled technicians. The Haxxair T2D was strategically placed to ensure optimal performance and ease of maintenance. Given the unit's sleek design—measuring 33.88 x 12.19 x 25.56 inches for the exterior component—it blends seamlessly with the property's aesthetics without compromising on functionality.
Our team took special care to install the unit with high-quality 1/4 - 1/2 inch pipes and a 220V connection, adhering to the highest standards of safety and efficiency. This setup not only enhances the overall energy efficiency but also ensures a smoother operation with minimal environmental impact.
Enhanced Features for Montreal’s Climate
The Haxxair T2D comes with a special 8°C heating mode, which is particularly beneficial for homeowners in Montreal. This mode prevents the indoor environment from dropping below a certain temperature, thus protecting the premises from the risks associated with freezing temperatures, such as burst pipes or structural damage during extended absences in winter.
Moreover, the LogisVert Grant by Hydro-Québec acknowledges this model’s energy efficiency by offering a substantial rebate, making the Haxxair T2D an even more attractive option for eco-conscious consumers.
Customer Satisfaction and Future Outlook
The homeowners were thoroughly impressed with the swift and professional installation process and the immediate improvement in their home’s climate control. The Haxxair T2D’s ability to maintain consistent temperatures and its user-friendly interface have greatly enhanced their daily comfort and convenience.
AirGreen continues to be a leader in providing cutting-edge HVAC solutions that not only meet but exceed client expectations. This installation exemplifies our commitment to delivering quality, reliability, and innovation in every project we undertake.
For those residing in Montreal and its surrounding areas, including Laval, Longueuil, and the North and South Shores, choosing AirGreen means opting for expertise, efficiency, and exceptional customer service.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).