Installation of a Sharp ZHU Wall-Mounted Heat Pump in Saint-Bruno
Experience unparalleled comfort with AirGreen's Sharp ZHU Heat Pump installation in Saint-Bruno: Where innovation meets sustainability.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Masterpiece of Modern Engineering and Comfort
At AirGreen, our commitment to enhancing indoor climates across Montreal, Laval, Longueuil, North Shore, and South Shore with precision, innovation, and sustainability has recently been exemplified through our latest project in Saint-Bruno. This endeavor wasn’t just about installing a heat pump; it was about redefining comfort, efficiency, and air quality in a residential setting.
The Challenge: Beyond Ordinary Installation
The heart of this installation story lies in the challenge it presented and how it transformed into an opportunity to demonstrate our unparalleled expertise and dedication to customer satisfaction. Installing a Sharp ZHU 18,000 BTU wall-mounted heat pump might sound straightforward, but this project was anything but typical.
Our client envisioned the indoor unit to occupy a central position in their home, ensuring even distribution of conditioned air throughout. This requirement necessitated an intricate route for piping and electrical wiring, demanding precision and creativity to ensure an aesthetically pleasing yet efficient setup.
Unveiling the Sharp ZHU: A Technological Marvel
Before diving into the intricacies of the installation process, let’s spotlight the star of the show: the Sharp ZHU wall-mounted heat pump. This model stands as a testament to Sharp’s commitment to innovation, energy efficiency, and environmental sustainability. Here are some of its standout features:
- Energy Star® certification and an impressive 25.0 SEER efficiency rating highlight its energy-saving capabilities.
- Integration of WiFi functionality and the revolutionary Plasmacluster air purification technology.
- The use of R-32 refrigerant, which significantly reduces the unit's environmental impact.
- An extensive 10-year warranty covering the compressor, parts, and labor.
- Advanced Coanda airflow control and Inverter technology, ensuring optimal temperature distribution and energy use.
The Installation Odyssey
The complexity of installing the indoor unit through another room to reach the desired central location in the house was a task that tested our mettle. We meticulously planned the pathway for the pipes and wires, ensuring they remained hidden within the walls to preserve the home’s aesthetic integrity.
Our team's skill in navigating these challenges not only met but exceeded our client's expectations. The installation was not just about placing a heat pump; it was about ensuring seamless integration into the living space, affirming our commitment to both functionality and design elegance.
Going Above and Beyond: Air Purification and Efficiency
What truly set this installation apart was the addition of Sharp's unique air purification feature, a testament to our promise to deliver more than just temperature control. The Plasmacluster technology in the ZHU model works to neutralize airborne bacteria and viruses, providing the homeowner with not only a comfortable but also a healthier living environment.
Moreover, the R-32 refrigerant plays a crucial role in enhancing the system's energy efficiency and reducing its carbon footprint, aligning with our sustainable values and the growing environmental consciousness of our clients.
Client Satisfaction: A Testament to Our Dedication
The culmination of this project was marked by the overwhelming satisfaction of our client. Their appreciation for the meticulous care, advanced technology, and the exceptional capabilities of the Sharp ZHU model reinforced our belief in going the extra mile to meet their needs. This installation was more than just a job completed; it was a statement of our dedication to quality, innovation, and customer satisfaction.
Why Choose AirGreen for Your HVAC Needs?
Choosing AirGreen means partnering with a team that:
- Prioritizes innovative solutions to heating and cooling, ensuring access to the latest technology in HVAC systems.
- Commits to sustainable practices, offering products like the Sharp ZHU that reduce environmental impact without sacrificing performance.
- Values aesthetics and functionality, ensuring that installations enhance the comfort and design of your home.
- Prides itself on customer satisfaction, going above and beyond to meet and exceed expectations.
Conclusion: A New Benchmark in HVAC Installation
Our recent project in Saint-Bruno sets a new standard for what homeowners can expect from HVAC installation. It's not just about ensuring your home remains at a comfortable temperature; it's about enhancing the air you breathe, the energy you consume, and the way you live. At AirGreen, we’re not just installing units; we’re crafting tailored environments that speak to the needs and desires of our clients.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).