Installation of a Sharp ZHU Wall-Mounted Heat Pump in Verdun, Montreal
Dive into AirGreen’s latest installation tale in Verdun, Montreal! Uncover the magic of the Sharp ZHU Heat Pump, a silent performer and efficient purifier bringing comfort and tranquility to homes.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Unveiling Superior Comfort and Efficiency: Another Stellar Installation by AirGreen!
The Verdun Installation Story
Nestled in the heart of Verdun, Montreal, a residence yearned for a transformation that would not only bring comfort but also breathe a wave of fresh, purified air into their living space. The client approached us with concerns about their existing HVAC system, which was not only noisy but also inefficient in maintaining optimal air quality. Enter the Sharp ZHU Wall-Mounted Heat Pump, a beacon of quiet operation, efficiency, and air purification.
Why Sharp ZHU?
- Quiet Operation: The Sharp ZHU is a whisperer, silently working in the background, providing a peaceful environment for the residents.
- Efficient Performance: With its R-32 Freon, it operates 10% more efficiently, ensuring that the home is heated even in the chilly winters without consuming excessive energy.
- True Air Purification: Unlike other systems that merely filter the air, the Sharp ZHU purifies it, eliminating airborne viruses, molds, and allergens, providing a safe haven for its occupants.
A Closer Look at Sharp ZHU
Plasmacluster Technology: Nature’s Gift
Sharp ZHU boasts Plasmacluster Technology, a unique feature that replicates natural air purification processes. This technology is exclusive to Sharp products, setting them apart from the competition. The benefits are manifold:
- Neutralizes airborne bacteria and viruses
- Eliminates mold and airborne microbes
- Combats odors and tobacco residue
- Addresses airborne allergens
- Removes sticky odors efficiently
Unparalleled Airflow Control
The long diffuser flap of the ZHU series contributes to unmatched airflow control, maximizing air intake while minimizing losses. The airflow is expertly directed to avoid discomfort to the occupants, providing a draft-free experience.
SHARP Connectivity: Smart Living
The ZHU series is not just about cooling and heating; it’s about intelligent living. With motion-sensor technology, it notifies the homeowner of movements, helping optimize energy usage and minimize waste. The accompanying app provides insights into energy consumption patterns, aiding in conscious energy usage.
Installation Highlights in Verdun
Our team at AirGreen meticulously handled the installation process in Verdun, ensuring that the Sharp ZHU seamlessly blended with the aesthetics of the home while providing top-notch functionality. The client’s concerns about air quality were addressed with the ZHU’s superior air purification features, bringing a noticeable change in the indoor environment.
Federal and Provincial Grants
The Sharp ZHU model qualifies for attractive Federal and Provincial Grants, making it an economical choice for homeowners looking for quality and efficiency without breaking the bank.
Choose AirGreen: Where Quality Meets Sustainability
At AirGreen, we don’t just install HVAC systems; we provide solutions that align with our core values of sustainability and responsibility. Our installations, including the Sharp ZHU series, are a testament to our commitment to offering products that not only serve our clients but also contribute positively to the environment.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).