Installation of a Sharp ZU1 Wall-Mounted Heat Pump in Terrebonne
Discover how the Sharp ZU1 transforms a Terrebonne home with silent operation and advanced air purification – a perfect blend of comfort and technology!
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Harmonious Blend of Comfort and Innovation
Exceeding Expectations with the Sharp ZU1
At AirGreen, we're not just about installing HVAC systems; we're about enhancing lifestyles with state-of-the-art technology and sustainable solutions. Our recent installation in Terrebonne perfectly exemplifies this ethos, featuring the Sharp ZU1, an 18,000 BTU wall-mounted heat pump renowned for its efficiency and quiet operation.
Customer-Centric Installation Approach
Nestled in the residential heart of Terrebonne, this project was driven by our client's desire for a system that could effectively manage the temperature of their second floor, which had been uncomfortably hot during the summers. The challenge was to install a powerful unit like the 18,000 BTU Sharp ZU1 without disrupting the tranquility of the home environment, especially at night.
Strategic Placement for Optimal Comfort
Our expert team at AirGreen carefully selected the installation site within the home to maximize comfort and efficiency. The unit was placed to ensure even distribution of air, making the entire second floor a haven of comfort year-round, regardless of the external temperatures.
Technical Superiority of the Sharp ZU1
The Sharp ZU1 heat pump stands out with its impressive features:
- Energy Efficiency: With a SEER rating of 24.0, the ZU1 is designed to optimize energy use, significantly lowering electricity bills while being eco-friendly.
- Whisper-Quiet Operation: The indoor unit operates at a mere 25 dB, quieter than a whispered conversation, ensuring undisturbed sleep and daily activities.
- Advanced Air Purification: Equipped with Plasmacluster technology, the ZU1 goes beyond standard filtration, actively neutralizing airborne bacteria and allergens, providing a healthier living environment.
- Innovative R-32 Freon: Ahead of its time, the ZU1 uses R-32 freon, set to become the standard in Canada by 2025 due to its lower environmental impact.
Aesthetic and Practical Installation
Understanding the importance of aesthetics in home design, our installation ensured that all pipes and electrical wiring were neatly concealed behind the unit, maintaining the interior décor. The clean, unobtrusive setup not only complements the home’s aesthetic but also highlights the minimalist design of the Sharp ZU1.
Customer Satisfaction: A Testament to Quality
The feedback from our Terrebonne client was overwhelmingly positive, praising the silent operation and the perfect temperature control achieved by the Sharp ZU1. The generous provincial grant under the LogisVert Program by Hydro-Québec, which recognized the ZU1 as an exceptionally energy-efficient model, was also a significant satisfaction point.
Why Choose AirGreen for Your HVAC Needs?
Choosing AirGreen means opting for a partner who understands the intricate balance between technology, comfort, and design. Our commitment to providing high-quality installations with meticulous attention to detail and customer needs sets us apart in the HVAC industry.
- Expertise and Experience: With years of experience in HVAC solutions, AirGreen is a trusted name in Montreal and surrounding areas.
- Quality and Reliability: We only choose the best products, like the Sharp ZU1, ensuring that our installations deliver both performance and durability.
- Customer-Centric Solutions: We tailor every installation to meet the specific needs and preferences of our customers, ensuring satisfaction and comfort.
Innovative Features for Modern Homes
The Sharp ZU1 is not just a heat pump; it's a step into the future of home climate control. Its multifunctional capabilities allow it to adapt to varying indoor conditions automatically, ensuring consistent comfort without manual intervention. Moreover, the incorporation of WiFi connectivity allows homeowners to manage their home environment remotely, adding a layer of convenience and control.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What the unit delivers when it is cold
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).