Installation of a Tosot LomoPlus Wall-Mounted Heat Pump in Brossard, South Shore
Experience the pinnacle of home comfort with AirGreen's expert installation of Tosot heat pumps in Brossard—quiet, efficient, and designed for you.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Tailored Cooling Solution That Beats the Heat and the Competition
Mastering the Challenge of Custom Installation
In the heart of Brossard on the South Shore, a remarkable installation story unfolded as AirGreen tackled one of its more complex HVAC projects. This tale isn't just about setting up a Tosot LomoPlus UltraHeat; it's a narrative of precision, planning, and customer satisfaction that sets AirGreen apart in the competitive landscape of HVAC solutions.
Our recent project involved a customized approach where the client desired not one but three separate Tosot LomoPlus heat pumps. This strategic decision, aimed at maximizing efficiency and reducing operational risk, underscores our commitment to delivering personalized solutions that genuinely reflect the unique needs of our customers.
The Advantages of Multiple Units Over Multi-Zone Systems
Opting for three individual units rather than a single triple-zone system, we ensured that each unit could operate independently. This setup minimizes the risk associated with potential unit failures—maintaining comfort in other zones without interruption. The customer's choice was influenced by several key factors:
- Reduced Risk of Complete Downtime: If one unit encounters an issue, the others continue functioning, ensuring continuous comfort.
- Enhanced Performance: Each unit operates optimally under the conditions it's specifically installed for, maximizing efficiency.
- Ease of Maintenance and Servicing: Individual systems simplify the servicing process, allowing for quicker, more efficient repairs.
Efficient and Silent: The Tosot LomoPlus UltraHeat
The Tosot LomoPlus UltraHeat model stands out for its remarkable efficiency and whisper-quiet operation. Here’s what makes this model a top choice for discerning clients:
- High Efficiency: With an impressive SEER rating of 30.5, this model is one of the most efficient on the market, drastically reducing electricity usage.
- Ultra-Quiet Operation: The indoor unit operates at a minimal 22 dB(A), ensuring a virtually silent environment, perfect for residential areas.
- Superior Heating Capacity: Even in the harsh Canadian winters, with temperatures dropping to -30°C, the LomoPlus continues to provide reliable and efficient heating.
Client Satisfaction: A Testament to Quality
The completion of this installation was not just about technical prowess but also about ensuring client satisfaction. The homeowner was particularly impressed with the seamless integration of the units into their home, the professional demeanor of our dual installation teams, and the significant economic benefits, including a substantial federal grant of $5,000. These aspects highlight our dual commitment to excellence and client satisfaction:
- Day-Same Installation: By coordinating two teams, we completed the installation of all three units in one day, minimizing disruption to the homeowner.
- Economic Benefit: Besides enjoying reduced energy bills, the client benefited from significant grants, making this investment even more rewarding.
A Commitment to Sustainability and Comfort
The Tosot LomoPlus UltraHeat isn't just a testament to advanced engineering but also to sustainable living. Certified by Energy Star and eligible for the $405 LogisVert grant from Hydro-Québec, this model aligns with our mission to support environmentally responsible heating and cooling solutions.
Key Features of the Tosot LomoPlus UltraHeat:
- Energy Star® Certified: Ensures efficient energy use.
- AHRI Certified: Guarantees performance reliability.
- Comprehensive Warranty: Offers a decade of peace of mind for compressor, parts, and labor.
- Smart Features: Includes WiFi connectivity and intelligent defrost systems for optimal performance.
In conclusion, our latest installation in Brossard not only challenged us but also allowed us to demonstrate our unparalleled ability to meet specific client needs with bespoke HVAC solutions. AirGreen remains committed to enhancing the comfort of your homes, one successful installation at a time, ensuring each client feels the unique benefit of our expertise and dedication.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).