Installation of a Haxxair T2D Wall-Mounted Heat Pump in Saint-Laurent, Montreal
Dive into a story of comfort & reliability with AirGreen’s latest installation in Saint-Laurent! Discover why the Haxxair T2D is the epitome of efficiency & the perfect choice for your HVAC needs.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Unveiling Superior Comfort: A Tale of Expert Installation and Unmatched Efficiency
A Seamless Transition to Comfort
In the serene neighborhood of Saint-Laurent, Montreal, a residence experienced a significant upgrade in their HVAC system, marking a transition to unparalleled comfort and efficiency. AirGreen, your trusted HVAC partner, was at the forefront of this transformation, ensuring a seamless and professional installation of the Haxxair T2D Wall-Mounted Heat Pump.
The Haxxair T2D: A Symphony of Reliability and Performance
- Cooling Capacity: A robust 12,000 BTU ensures a cool and comfortable environment, even during the sweltering summer months.
- Heating Efficiency: With a heating capacity that remains steadfast at -25°C, the T2D is a reliable companion through chilly winters.
- Quiet Operation: At a sound pressure level ranging between 26 and 39 dB(A), the T2D operates whisper-quiet, providing comfort without the noise.
- Energy Efficiency: Boasting a 20.5 SEER rating and Energy Star® certification, the T2D is a testament to energy-saving brilliance.
- Warranty: With a comprehensive 10-10-10 warranty on compressor, parts, and labor, peace of mind is a given.
The Installation Saga: Precision Meets Expertise
Our journey began with a rooftop that housed an aging, defunct machine, a relic that had served its time providing warmth and cool air but had succumbed to electronic malfunctions. With over 15 years of service, finding spare parts for such a veteran was akin to searching for a needle in a haystack.
In situations like these, the cost of repairs often overshadows the value derived, making replacement a prudent choice. Our discerning customer recognized this and sought a solution that was reliable, efficient, quiet, and economically sensible. Enter the Haxxair T2D, a model that not only met but exceeded these expectations with flying colors.
Ensuring Longevity: It’s All in the Details
At AirGreen, we believe that a successful installation is not merely about replacing a unit but ensuring that the new system stands the test of time. Our meticulous technicians embarked on a mission to inspect and validate the integrity of the existing pipes, a crucial step often overlooked by many.
Through a rigorous process of cleaning and verification, we ascertained that the pipes were in optimal condition, ready to support the new installation without a hitch. This attention to detail, coupled with our commitment to excellence, resulted in a thrilled customer, another testament to AirGreen’s dedication to customer satisfaction.
Why the Haxxair T2D?
- Versatility: With its ability to function efficiently in both cold and warm climates, the T2D is a versatile choice for diverse weather conditions.
- WiFi Capability: Optional WiFi connectivity offers convenience at your fingertips, allowing for effortless control and monitoring.
- AHRI Certified: With certification number 204628475, the T2D’s performance and efficiency are verified and trustworthy.
Conclusion: A Tale of Success
This installation story is not just about replacing an old machine with a new one; it’s a narrative of expertise, precision, and commitment to quality. At AirGreen, we take pride in our work, ensuring that each installation is a tale worth telling, a saga of comfort and reliability brought to life by our skilled technicians and top-notch equipment.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).