Service Call & Repair for Daikin Wall-Mounted Heat Pump in the Sud-Ouest Area
AirGreen repairs and maintains wall-mounted heat pumps, including Daikin, in the Sud-Ouest area of Montréal. Our skilled technicians provide efficient solutions to improve system performance and restore comfort to your home.
- City
- Region
- Equipment
- Brand
- Challenges
- Published
The job on one screen
The article, chapter by chapter
A Comprehensive Repair Experience by AirGreen for a Daikin Wall-Mounted Heat Pump in the Sud-Ouest of Montréal
At AirGreen, we pride ourselves on our professionalism and expertise when it comes to repairing and maintaining HVAC systems. Recently, we had the opportunity to perform a detailed service call and repair for a Daikin wall-mounted heat pump in the Sud-Ouest area of Montréal.
The Challenge: Troubleshooting the Heat Pump’s Issue
Our customer in the Sud-Ouest reached out to us with concerns about their Daikin wall-mounted heat pump. The system wasn’t performing efficiently and was failing to maintain the desired temperature in the home. AirGreen technicians arrived promptly to diagnose the issue.
Upon inspection, our experts identified that the heat pump was experiencing some cooling inefficiency and wasn’t providing the expected air circulation. This could be due to clogged filters, a refrigerant leak, or potential problems with the internal components such as the evaporator coil.
The Solution: AirGreen’s Expert Repair Approach
After our initial diagnostic, we decided on a step-by-step approach to restore the system to full functionality. Here is a detailed breakdown of the repair process:
-
Inspection and Diagnostics: We started by thoroughly inspecting the Daikin heat pump to assess the condition of all major components. Our technician checked the refrigerant levels and inspected the filters and airflow.
-
Refrigerant Recharge: The refrigerant levels were found to be low, likely due to a leak in the system. We proceeded with a refrigerant recharge, ensuring the proper balance to optimize cooling efficiency.
-
Filter Cleaning: Our team removed and cleaned the air filters, which had accumulated dust and dirt, hindering the system’s airflow. Cleaning the filters ensured that the system could function at its highest capacity.
-
Component Testing: Finally, we tested the internal components, including the compressor and evaporator coil, to ensure everything was functioning as expected. A quick check of the thermostat settings was also performed to ensure the temperature settings were accurate.
The Result: A Fully Restored Heat Pump and Satisfied Customer
Once the necessary repairs and maintenance were completed, the Daikin heat pump was restored to full functionality. Our customer was pleased to experience improved cooling performance and more efficient energy usage. Thanks to AirGreen’s prompt and professional service, the home was comfortable once again, and the heat pump was operating as it should.
Our expert technicians not only solved the immediate problem but also provided the customer with valuable insights into proper heat pump maintenance to avoid future issues. As always, AirGreen is committed to delivering top-tier service and ensuring that your HVAC system remains in perfect working condition.
Why Choose AirGreen for Your Heat Pump Repairs?
At AirGreen, we repair and maintain a range of HVAC systems, including Daikin heat pumps. Our technicians are highly trained to diagnose and fix all types of issues, ensuring that your system runs efficiently year-round.
If you’re experiencing issues with your Daikin wall-mounted heat pump or any other HVAC system, don’t hesitate to contact us. We take service calls throughout Montréal, Laval, Longueuil, and the Rive Nord and Rive Sud areas. Our goal is to provide top-quality service with a focus on customer satisfaction and system performance.
How the job unfolds
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
The symptoms, since when, the model (on the unit's label) and the error code if there is one.
We look for the cause, not just the symptom: readings, components, installation.
Repair, part to order or replacement, depending on the failure. We explain what we found.
The repair is done and parts replaced as needed.
The unit is restarted and checked in its operating modes.
What caused the failure and what can keep it from coming back.
- Your callThe symptoms, since when, the model (on the unit's label) and the error code if there is one.
- On-site diagnosisWe look for the cause, not just the symptom: readings, components, installation.
- The optionsRepair, part to order or replacement, depending on the failure. We explain what we found.
- The workThe repair is done and parts replaced as needed.
- TestsThe unit is restarted and checked in its operating modes.
- AdviceWhat caused the failure and what can keep it from coming back.
What we check on a job like this one
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Good habits, once the unit is in place
Six simple habits that keep the unit going. Your list stays on this device.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
The right pages, at the right time
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
What should I have ready before calling?
Repair or replace?
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
An on-site estimate, the right capacity, the right equipment.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).