Installation of a SHARP ZHU1 Ductless Heat Pump in Blainville
Discover the unmatched performance of the SHARP ZHU1 Heat Pump! Installed in Blainville by AirGreen, it’s energy-efficient, ultra-quiet, and eligible for a $2,268 Hydro-Québec grant!
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Experience Superior Comfort: SHARP ZHU1 Ductless Heat Pump in Blainville
A Perfect Installation for Blainville’s Unique Climate Needs
AirGreen proudly completed the installation of a SHARP ZHU1 12,000 BTU Ductless Heat Pump in a charming residential property in Blainville. Designed to handle the extremes of Québec’s weather, this state-of-the-art unit is a game-changer for homeowners looking to combine energy efficiency, reliable performance, and unmatched indoor comfort.
Why the SHARP ZHU1 Stands Out
Exceptional Cooling and Heating Capabilities
This mini-split heat pump boasts 12,000 BTU cooling power and a heating capability rated for temperatures as low as -27°C. Whether it’s the blazing heat of summer or the frigid depths of winter, the SHARP ZHU1 delivers consistent, energy-efficient climate control.
Certified for Hydro-Québec’s LogisVert Grant
The SHARP ZHU1 qualifies for the highest LogisVert grant of $2,268, offered by Hydro-Québec for any 12,000 BTU machine in Québec. Not only does this unit provide exceptional comfort, but it also makes eco-friendly living more accessible for Blainville residents.
The Installation Story: Seamless Integration in Blainville
When our team arrived on-site, we were met with the typical challenges of installing a modern heat pump in a home that blends traditional architecture with contemporary needs. Our mission was to ensure that the indoor and outdoor units were positioned for optimal performance and aesthetic appeal.
Custom Mounting for the Outdoor Unit
To ensure durability and efficiency, the outdoor unit (measuring 30.72 x 10.59 x 21.25 inches) was securely mounted on a specialized platform, elevating it off the gravel-covered rooftop. This placement protects the unit from snow buildup in winter and allows maximum airflow for peak efficiency.
A Discreet and Efficient Indoor Setup
The sleek indoor unit, with dimensions of 41.42 x 9.80 x 12.44 inches, was installed to complement the home’s interior design. Its near-silent operation, with noise levels as low as 22 dB(A), ensures a peaceful atmosphere, whether it’s placed in a bedroom, living room, or study.
Advanced Refrigerant System
This installation featured R-32 refrigerant, a modern, eco-friendly alternative that reduces greenhouse gas emissions and enhances energy efficiency by up to 10% compared to older systems.
What Makes the SHARP ZHU1 the Right Choice for Québec Homes
Energy Star® Certified for Maximum Savings
This unit’s impressive 25.0 SEER rating makes it one of the most energy-efficient models available today. The Energy Star® certification guarantees reduced electricity bills while maintaining peak performance.
Designed for Durability
With an anti-corrosion coating on the outdoor unit and WiFi connectivity for real-time monitoring, this model represents a perfect balance of cutting-edge technology and robust engineering.
Plasmacluster™ Air Purification
SHARP’s proprietary Plasmacluster™ technology ensures superior indoor air quality by neutralizing airborne viruses, mold, and allergens. This added health benefit is a unique selling point for families prioritizing clean air.
Customer-Centric Details
A Grant-Friendly Choice
The Hydro-Québec LogisVert grant ensures significant savings, making this high-performance unit more accessible to homeowners looking to upgrade their HVAC systems.
Long-Term Warranty Coverage
With an impressive 10-10-10 warranty (10 years on the compressor, parts, and labor), homeowners can trust in the durability and reliability of their investment.
Noise-Free Comfort
The indoor unit’s ultra-quiet operation at just 22 dB(A) ensures minimal disruption, whether you’re enjoying a family movie night or working from home.
AirGreen: Your Partner in HVAC Excellence
At AirGreen, we pride ourselves on delivering solutions tailored to the unique needs of Québec residents. From consultation to installation, our team ensures every step is handled with care and expertise. Choosing the SHARP ZHU1 means choosing an HVAC solution that delivers comfort, efficiency, and peace of mind.
Contact Us Today
If you’re ready to elevate your home’s comfort with the SHARP ZHU1, don’t hesitate to reach out to us. AirGreen proudly serves Blainville, Montreal, Laval, Longueuil, and the North and South Shores. Let us help you find the perfect HVAC solution for your needs!
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).