Installation of a Coaire wall-mounted air conditioner in Rosemont–La Petite-Patrie
AirGreen installs a Coaire wall-mounted air conditioner in Rosemont–La Petite-Patrie. An efficient and discreet HVAC solution for condos and apartments in Montreal.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
An HVAC installation adapted to urban comfort
At AirGreen , we recently installed a Coaire wall-mounted air conditioner in a condo located in Rosemont–La Petite-Patrie , a lively and dense neighborhood in Montreal where space optimization is essential. The client wanted to modernize their interior comfort by opting for a discreet, efficient wall-mounted system adapted to the constraints of urban housing.
Project background
The apartment featured a typical Montreal condo layout: large bay windows letting in plenty of natural light, but also significant heat in the summer. The main challenge was to provide a quiet and efficient HVAC system , while integrating the installation aesthetically, without encroaching on the limited wall space.
Technical details of the installation
-
System type : wall-mounted air conditioner (mini-split).
-
Brand : Coaire.
-
Interior location : fixed high up in the main living area, to optimize air distribution.
-
Piping Route : The refrigeration connections were carefully routed to the exterior using a discreet finishing cover, matching the color of the walls for an aesthetic finish.
-
Condensate management : drainage is carried out by gravity, avoiding the use of a pump and thus reducing future maintenance.
-
Working height : installation at the top, requiring precise fixing to ensure perfect alignment.
Benefits for the customer
-
Immediate comfort : a stable and pleasant temperature, even on hot July days.
-
Respected aesthetics : discreet integration of the interior unit without harming the wall decoration.
-
Energy Savings : Coaire wall-mounted air conditioner technology allows for lower consumption compared to older portable or window systems.
-
Quiet operation : ideal for working from home and movie nights in a condo.
Why a wall-mounted air conditioner in Rosemont?
In urban areas like Rosemont–La Petite-Patrie , installing a wall-mounted air conditioner is a great solution:
-
Little space available for central systems.
-
Facades and load-bearing walls are often narrow.
-
Need a compact, quiet and efficient device, suitable for Montreal condos and multiplexes.
AirGreen Expertise
Our RBQ certified technicians always ensure to offer:
-
Installations that comply with Quebec HVAC standards .
-
Precise planning of drilling and technical routes to minimize visual impact.
-
Comprehensive support, including maintenance advice and performance optimization.
Maintenance tips to extend the lifespan
-
Regularly clean air filters to maintain efficiency.
-
Annual check of electrical and refrigerant connections.
-
Professional inspection recommended before each summer.
By choosing AirGreen for this project, the Rosemont client benefits not only from a high-performance wall-mounted air conditioner, but also from a tailor-made service , designed for sustainable comfort in an urban environment.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
