Installation of a Gree Clivia R32 wall-mounted heat pump in Villeray–Saint-Michel–Parc-Extension
AirGreen installed a Gree Clivia R32 wall-mounted heat pump in a condo in Villeray. It features a short path, gravity drain, wall brackets, and rigorous commissioning for four-season comfort in Montreal and the surrounding area. ≤275 characters.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Precise comfort in a Montreal condo, without compromising on aesthetics
At AirGreen , we design each HVAC installation as an engineering project applied to everyday life. In this condo located in Villeray–Saint-Michel–Parc-Extension , we installed a Gree Clivia R32 wall-mounted heat pump to provide reliable heating in the winter and gentle cooling in the summer, with discreet integration near a patio door. The goal: performance, silence, and visual sobriety, without encroaching on the living space.
Why the Clivia R32 range?
Gree 's Clivia R32 series combines inverter technology with a new generation R-32 refrigerant, with a lower global warming potential, while ensuring high performance in cold weather. It meets three common expectations of co-owners in Greater Montreal:
-
Superior energy efficiency to reduce electricity bill;
-
4-season comfort with fine power modulation;
-
Quiet and compact design that fits into living spaces.
Context and constraints of the site
The housing has a typical urban layout: large glass opening, short wall corner, direct access to a terrace where the condenser is installed. These parameters require precise planning of passages and clearances.
Choosing an interior location
We positioned the wall head high and in a corner , a few centimeters from the ceiling, so as to:
-
Maximize air stratification and diffusion to the open area;
-
Free up the main walls for furniture;
-
Facilitate a short route of connections to the outside (crossing the side wall near the patio door).
Route and finishing of the connections
-
Estimated length of refrigeration connections: approximately 1 to 1.5 m, limiting pressure losses.
-
Discreet white capping , laid vertically then horizontally to join the drilling; fixings at regular center distance for a durable finish.
-
Gravity condensate drain with continuous slope (~2%), avoiding a pump and therefore additional noise/maintenance.
-
Crossing made with sheath and vapor barrier to preserve the building's watertightness.
Installation of the outdoor condenser
Visible from the patio door, the outdoor unit is mounted on wall brackets with anti-vibration pads . This anchor:
-
clears the ground and preserves the flow of defrost water;
-
ensures proper rear and side clearance ;
-
reduces the risks associated with frequent snow accumulation in Montreal .
Sizing and expected performance
We always size the heat pump based on the room's usage, orientation, and building envelope. Here, a 12,000 BTU configuration proved optimal for the main living area, with:
-
Competitive SEER/SEER2 and HSPF/HSPF2 for R-32 appliances;
-
useful heating capacity in negative temperatures, suitable for Greater Montreal winters;
-
intelligent defrosting limiting cycles and improving thermal stability.
Expected result: a significant reduction in costs versus electric baseboards and a low interior noise level , ideal for teleworking and condo living.
AirGreen methodology: rigor and cleanliness
Our signature is clean, verifiable and sustainable execution.
Key technical steps
-
Site protection , tracing and verification of center distances.
-
Drilling to the correct diameter , installation of an insulated sleeve and watertight sealing.
-
Installation of insulated copper lines , bending radii respected.
-
Nitrogen brazing or flared fittings to range specification, with torque controls.
-
Nitrogen pressure test (high stage) and deep vacuum (≈ 500 microns ).
-
Fluid release, leak check and functional measurements (intensity, supply/return temperatures, ΔT).
-
Finishing: capping , caulking, repainting if required, instructions for use and maintenance.
Electrical management
-
Dedicated condenser circuit according to the nameplate;
-
Compliant circuit breaker and properly sheathed communication cable between units;
-
Installation of an external disconnect switch within easy reach for maintenance.
Daily comfort: what occupants feel
-
Rapid temperature rise in the off-season then gentle modulation.
-
In summer, laminar airflow directed along the ceiling to avoid direct currents on the sofa/dining table.
-
Silent night mode and dimmable display on the front.
-
Effective dehumidification during the humid waves of July-August in Montreal , Laval and Longueuil .
Aesthetics and integration
The Clivia R32 features a smooth white facade that blends into the light colors of the living room. The short passage to the outside allows for a minimalist cable channel , without an oversized box. On the terrace side, the brackets leave space for movement and avoid traces of corrosion on the floor.
Recommended maintenance (prevention > repair)
Light but regular HVAC maintenance extends the lifespan of:
-
Filters : gentle vacuuming every 1 to 2 months; washing with warm water if necessary.
-
Internal battery : periodic professional cleaning to maintain thermal exchange.
-
Outdoor unit : leaf/snow clearance (at least 30–60 cm on each side).
-
Annual inspection by our technicians for pressure and electronic checks.
Grants and Compliance
High-efficiency R-32 wall-mounted heat pumps are generally eligible for assistance programs in Quebec. We support our customers in Greater Montreal—including the North Shore and South Shore —in gathering the required technical documents (performance sheet, certification number, proof of installation) and optimizing the application .
AirGreen Tips for Condominiums and Plexes
-
Favor a gravity drain when the configuration allows it; reliability is superior.
-
Provide a wall support with buffers if the terrace is small or subject to snow.
-
Respect clearances to maintain optimal seasonal performance and limit noise.
-
Request a refrigeration charge check and documented vacuum draw upon commissioning.
-
Consider a second head if natural air distribution does not cover one wing of the dwelling.
What this installation says about our approach
Every AirGreen project is designed to combine performance and ease of use . Here, the Gree Clivia R32 provides four-season comfort with a clean, short, and reversible installation, perfect for a condo in Villeray–Saint-Michel–Parc-Extension . Our teams master the details that make the difference: choice of route, slopes, tightening torques, testing, and finishing—all elements that ensure a reliable and economical system for many years.
Ready to modernize your comfort?
We operate in Montreal , Laval , Longueuil , and on the North Shore and South Shore . Our team guides you from sizing to grant application , with quick installation slots and clear maintenance advice.
Useful keywords: heat pump , wall-mounted heat pump , wall-mounted air conditioner , HVAC installation , HVAC maintenance , Montreal , Laval , Longueuil , North Shore , South Shore .
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).