Project

Installation of a Gree (Inverter wall-mounted range) wall-mounted heat pump in Chomedey (Laval)

AirGreen installs a Gree Inverter wall-mounted heat pump in Chomedey (Laval): careful installation, gravity drain, bracketed condenser, 4-season comfort. HVAC installation and maintenance service in Greater Montreal.

By AirGreen Climatisation & Chauffage Admin7 min read
Installation of a Gree (Inverter wall-mounted range) wall-mounted heat pump in Chomedey (Laval)
Installation of a Gree (Inverter wall-mounted range) wall-mounted heat pump in Chomedey (Laval)
–chapters in this story
7 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

Precise comfort and careful integration into a busy living room

At AirGreen , we design each HVAC installation as a project in its own right. In this condo in Chomedey (Laval) , our client wanted a solution that would heat up quickly upon returning from work, cool efficiently in the evening, and remain discreet on a daily basis. We recommended a Gree wall-mounted heat pump (Inverter residential range), known for its stable performance over four seasons and its excellent value for money in Greater Montreal.

Machine choice: why a wall-mounted Gree here?

Our recommendation is based on three priority criteria for this type of Laval apartment:

  • Energy efficiency and cold stability : Gree wall-mounted ranges offer high seasonal coefficients and maintain good heating capacity below zero, a crucial point for our winters.

  • Quiet and compact : the indoor unit fits above the back of the sofa without creating an unpleasant draft; the low noise level benefits open living spaces.

  • Simplified maintenance : accessible filters, clear diagnostics, availability of parts on the local market in Montreal and Laval — advantages for simple and quick annual preventive HVAC maintenance .

In Chomedey, the typical layout is a central living room opening onto the kitchen. A well-sized wall-mounted heat pump covers the living area and relieves the pressure on adjacent rooms, while avoiding oversizing.

Installation process: precision, cleanliness, safety

Scouting and preparation

We position the interior head approximately 2.10 m from the floor, with sufficient clearance at the ceiling for optimal airflow. The chosen wall, load-bearing and straight, allows:

  • a direct drilling towards the outside with controlled slope for evacuation by gravity drain (no condensate pump, therefore less maintenance and zero parasitic noise);

  • the shortest possible refrigeration path, limiting pressure losses and maximizing seasonal efficiency;

  • preservation of the interior aesthetics: no visible conduit in the living room; the alignment is centered above the sofa for even diffusion.

Drilling, refrigeration lines and supply

  • Making a 65 mm hole through the casing, with a sleeve and vapor barrier seal to maintain the watertightness.

  • Installation of white capping on the exterior to protect the insulated refrigeration pair and the communication cable; the choice of white matches the light brick of the rear facade (balcony side).

  • Dedicated power supply from the home's electrical panel, with a calibrated circuit breaker and cut-off device near the condenser, in accordance with RBQ/CSA requirements.

Installation of the outdoor unit

On the rear balcony, the Gree outdoor unit is installed on galvanized wall brackets with silent blocks to reduce vibrations. A free space is maintained for air circulation and defrosting in winter. We add:

  • Retention tank and defrost pipe directed away from the pedestrian crossing;

  • Removable snow guard for accumulations, practical on the North Shore ;

  • Stainless steel anchor points and anti-corrosion protection of the fixings.

Commissioning and balancing

After vacuum extraction to <500 microns, stabilization, and leak testing, we proceed:

  • to weighing/additional load according to the actual length (to remain within the performance window of the Inverter compressor);

  • to delta-T measurements in cold and heat;

  • to the vertical sweep configuration to avoid blowing directly onto the sofa and favor soft stratification in space.

Measurable result: comfort, savings and discretion

  • Efficient additional heating for the open area (living room-kitchen-entrance); the temperature rises quickly and smoothly thanks to the inverter compressor.

  • Even air conditioning in summer: the vent speed is automatically adjusted to avoid the sensation of drafts.

  • Very low noise : the internal head operates at low speed most of the time, ideal for television, teleworking and evenings.

  • Controlled energy bill : the heat pump covers a large portion of degree days at reduced operating costs compared to electric baseboard heaters.

What we look for in this type of salon

Air circulation and furniture placement

We validate the absence of major obstacles in front of the blower outlet (paintings, high bookcases, thick curtains). Here, the leather sofa is set back ~40 cm , which allows the flow to spread out and reach the kitchen.

Summer Humidity Management

Gree regulation allows for an intelligent Dry mode that lowers humidity without overcooling. We recommend:

  • aim for 45–50% RH in summer;

  • to program an Auto speed in the evening for a silence/drying compromise;

  • to keep room doors ajar to assist with transfer.

Winter: defrosting and snow removal

  • The balcony area is clear to avoid cold air recycling during defrosting;

  • the snow guard limits burial during windy episodes typical of Laval ;

  • a simple weekly glance is enough to confirm the free evacuation of condensate.

HVAC Use and Maintenance Tips

  • Filters : monthly rinsing during periods of intensive use; replacement/thorough cleaning during annual maintenance.

  • Fins : gentle dusting of the interior coil; no harsh products.

  • Remote control/thermostat : favor a stable setting (e.g. 22°C in comfort), because frequent variations harm the inverter's performance.

  • Annual AirGreen Maintenance : Electrical inspection, insulation testing, leak testing, refrigeration readings, chemical cleaning if necessary. This service extends the lifespan and maintains warranty eligibility.

Realistic sizing and expectations

In a standard Laval condo living room (25–35 m²), the 9,000–12,000 BTU/h range covers most needs if the envelope is correct. We always perform a rough load estimate (orientation, glazing, airtightness) to confirm capacity. For deep heating, the wall-mounted heat pump is considered the main source up to a threshold; baseboards take over occasionally when the mercury drops, depending on the building's actual insulation.

Grants and Compliance

Many Gree residential inverter models meet local program criteria. We support our customers in Montreal, Laval, Longueuil, North Shore, and South Shore to verify:

  • Energy Star eligibility and low temperature performance;

  • installation requirements (electrical equipment, clearances);

  • supporting documents for detailed invoices and installation photos requested by certain programs.

What makes the AirGreen difference

  • Honest and calibrated advice on site (thermal load, noise, aesthetics).

  • Clean execution : clean drilling, careful sealing, protected wiring and connections.

  • After-sales service : parts available and technicians trained in Gree , Fujitsu , Sharp , Midea , Zephyr , etc. ranges.

  • Greater Montreal coverage : rapid interventions in Montreal , Laval , Longueuil , North Shore and South Shore .

Chomedey project review

The customer gains stable comfort all year round , imperceptible noise at low speeds and a significant reduction in consumption compared to all-electric. The integration above the sofa frees up space and respects the aesthetics of the living room. Mission accomplished, with performance that will remain sustainable thanks to regular HVAC maintenance carried out by our teams.

Do you have a similar salon in Laval or Montreal?

We quickly assess feasibility: line routing, condenser position (balcony, flat roof, side wall), co-ownership constraints, and precise sizing. We then propose a turnkey HVAC installation , transparent about costs, deadlines, and applicable subsidies.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment