Project

Installation of a Gree (R32 range) wall-mounted heat pump in Rosemont–La Petite-Patrie

AirGreen installs a Gree wall-mounted heat pump (R-32) in Rosemont–La Petite-Patrie: short wall-to-wall path, gravity drain, white capping and fine adjustments for lasting comfort. Greater Montreal HVAC Service.

By AirGreen Climatisation & Chauffage Admin6 min read
Installation of a Gree (R32 range) wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Gree (R32 range) wall-mounted heat pump in Rosemont–La Petite-Patrie
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

A precise construction site in a compact living space: four-season comfort without compromise

At AirGreen , we work weekly in Montreal homes where space matters. In this project located in Rosemont–La Petite-Patrie , we installed a Gree wall-mounted heat pump (R-32 refrigerant) in a bedroom-office overlooking the street. The client's goal: to significantly improve summer comfort, benefit from stable heating support in mid-season and reduce the electricity bill, all without invasive work .


Context and diagnosis: a room exposed to the sun, marked temperature variations

The room has side windows that provide significant solar gain in the afternoon. In winter, the air stratifies and the temperature drops near the floor. After our technical visit, we recommended a wall-mounted heat pump with modulated airflow : the blower automatically adjusts its speed, ensuring even circulation in a small space without unpleasant drafts.

Why Gree's R-32 range?

  • High efficiency in air conditioning and low temperature heating.

  • Reduced environmental impact compared to R-410A, with an optimized refrigerant charge.

  • Quiet and discreetly designed units, ideal for a bedroom-office.


Choice of location: performance, aesthetics and easy maintenance

We positioned the interior head above a wardrobe , a few centimeters below the ceiling and in the immediate vicinity of the window (exterior wall). This positioning meets three requirements:

  1. Optimal air diffusion : the flow runs along the ceiling before spreading across the entire depth of the room.

  2. Short path to the outside : a single through-hole allows the refrigeration lines , electrical supply and condensate drain to be grouped together.

  3. Maintenance : access to the filter and the shutter remains clear despite the presence of the furniture.

We systematically respect the recommended clearances around the unit to avoid any air recirculation that would affect performance. The horizontal alignment has been electronically verified to ensure gravity flow of the drain (no pump required, guaranteeing silence and reliability).


Installation details that make the difference

  • Wall-to-wall route : insulated refrigeration lines, discreet white capping matching the window surround.

  • Estimated length of the connections : 2 to 3 meters , sufficient to reach the external condenser on the facade without unnecessary loops.

  • 65 mm drilling with bulkhead and vapor barrier seal to maintain watertightness.

  • Dedicated power supply with circuit breaker in accordance with the Quebec Electrical Code ; cable marked and attached.

  • Air draft check : orientation of the horizontal flaps to sweep the occupied area of ​​the room while avoiding blowing directly towards the workstation.

Immediate result: a drop of 6 to 8°C in the room on hot days, and a stable maintenance around 21–22°C in mid-season, without over-ventilation.


Everyday performance and comfort

The Gree wall-mounted heat pump (R-32) installed here was sized for a 10–15 m² room typical of Montreal plexes. Its inverter compressor finely adjusts the power:

  • Quick air conditioning on returning home then ultra-low speed to maintain the setpoint with minimal consumption .

  • Efficient heating down to -25°C (depending on range configuration), ideal for covering the mid-seasons and reducing the need for electric baseboard heaters.

  • Low noise level : perfect for working or sleeping in the same room.


AirGreen Best Practices for Bedroom-Offices

1) Airflow management. We pre-set the blowing angle so that the air follows the ceiling before falling gently.
2) Anti-vibration and fixings. The brackets are anchored to the uprights ; we add spacers when the wall requires it.
3) Simplified maintenance. The customer receives a maintenance schedule : filter washing every 4 to 8 weeks during periods of use, annual inspection of the refrigeration circuit by our technicians.
4) Humidity management. In summer, Dry mode helps stabilize humidity and reduce the feeling of heaviness typical of Montreal heat waves.
5) Integration with existing heating. Programming to prioritize the heat pump up to the desired switching threshold, avoiding double operation with baseboards.


Security, compliance and sustainability

Our facilities comply with RBQ and CSA standards. Each brazing operation is carried out under nitrogen to prevent internal oxidation. We carry out:

  • Nitrogen leak test ,

  • Deep vacuum with vacuum gauge,

  • Weighing and validation of the load according to the actual length of the lines,

  • Control of superheating and subcooling at commissioning.

These steps ensure seasonal performance and equipment longevity .


Possible grants and savings

High-performance wall-mounted heat pumps with R-32 refrigerant are generally eligible for assistance in Quebec. We assist our customers in verifying the criteria (power, COP/HSPF, minimum heating temperature, certification) and in preparing the files . The savings don't stop at the purchase: judicious use and regular HVAC maintenance consolidate the savings on the bill.


Common Pitfalls to Avoid (and How We Get Around Them)

  • Head placed too close to the ceiling : risk of recirculation and loss of capacity. We maintain sufficient clearance and orient the shutters accordingly.

  • Poorly designed drain : backflow, odors, pump noise. Here, gravity drainage with controlled slope.

  • Lines that are too long or looped : excess consumption and compressor wear. We optimize the route to remain within the range's tolerances.

  • Noise reduction : we insert anti-vibration strips and ensure perfect leveling of the support.


What the Rosemont–La Petite-Patrie customer gains

  • Immediate comfort in summer and mid-season.

  • Reduced consumption thanks to inverter control .

  • Neat aesthetics : aligned capping, no unnecessary visible sheath.

  • Peace of mind : manufacturer's warranty (parts/compressor) and AirGreen service for annual maintenance.


Our commitment to Greater Montreal

Whether you are in Montreal, Laval, Longueuil, on the North Shore or the South Shore , our teams plan, install and maintain HVAC systems adapted to local architecture: plexes, condominiums, single-family homes and extensions. We bring method , attention to detail and rigorous monitoring for lasting results.


In short

This Gree wall-mounted heat pump installation (R-32) in a bedroom-office in Rosemont–La Petite-Patrie demonstrates that careful and thoughtful work can achieve four-season comfort in a small space, while preserving aesthetics and energy consumption. AirGreen supports each client from sizing to maintenance , for a simple and efficient experience.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment