Project

Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie

AirGreen installed a Gree wall-mounted heat pump in a condo in Rosemont–La Petite-Patrie. A high-performance HVAC solution adapted to Montreal's climate.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

An HVAC installation project in the heart of an urban condo

At AirGreen , we are regularly called upon for projects in dense urban environments, where architectural and technical constraints require a precise approach. This Gree wall-mounted heat pump installation in a condo in Rosemont–La Petite-Patrie, Montreal, perfectly illustrates our expertise in HVAC solutions adapted to multi-unit buildings .

The outdoor unit is installed on a stable metal structure directly against a brick wall, typical of Montreal buildings. The location—a narrow balcony overlooking the rear of a building—required careful organization of the available space, while respecting safety and air circulation standards.


Why choosing a Gree heat pump is a good idea in Montreal

The Gree brand is increasingly establishing itself as a key player in the Quebec wall-mounted heat pump market. Thanks to their high energy performance, Gree units offer excellent performance even in periods of intense cold, down to -25°C for some models. This means:

  • Comfort in all seasons : efficient heating in winter, efficient air conditioning in summer.

  • Energy savings through competitive SEER and HSPF ratings.

  • Compatibility with grant programs such as LogisVert or the Federal Energy Renovation Program.

For this project, the client wanted to replace an energy-intensive portable air conditioner with a permanent, reliable, and quiet system. The Gree wall-mounted heat pump emerged as the optimal solution, both in terms of performance and value for money.


The technical challenges of the installation

Managing restricted space

The balcony had limited depth, so we opted for a raised galvanized steel support , allowing the floor slab to be clear and ensuring sufficient clearance for ventilation of the unit. This configuration also facilitates future maintenance.

Drilling and crossing the brick wall

The solid brick facade requires rigorous engineering. Precise core drilling allowed the refrigeration and electrical conduits to be routed to the indoor unit, ensuring a perfect seal. Discreet white capping was installed inside for an aesthetically pleasing appearance, and professional sealing protected the exterior from water infiltration.

Condensate management

Given the height, we opted for natural gravity drainage , avoiding the addition of a condensate pump which would have generated additional costs and maintenance.


A project carried out according to the rules of the art

The work was carried out in a single day by a team of two certified technicians. Each step, from drilling cores into the masonry to the electrical connection , was carried out in accordance with RBQ and Canadian Electrical Code standards.

Before commissioning, we carried out:

  • A complete vacuum to eliminate all moisture in the refrigeration ducts.

  • A pressure test to ensure the circuit is watertight.

  • Calibration of the indoor unit to optimize the thermal comfort of the condo.

The customer immediately noticed the difference: silence, consistent freshness, and above all the prospect of reduced electricity bills in the medium term.


Concrete benefits for the customer

  • Four-season comfort : heating and air conditioning integrated into a single unit.

  • Available grants : The installed Gree heat pump is eligible for provincial and federal programs.

  • Respected aesthetics : careful installation, discreet capping, robust but compact support.

  • Simplified maintenance : direct access to the outdoor unit on the balcony.


Conclusion: an exemplary HVAC installation in Rosemont

This project illustrates how a Gree wall-mounted heat pump installation in Rosemont–La Petite-Patrie can transform the comfort of an urban condo. Despite space and masonry constraints, the AirGreen team was able to deliver an efficient, sustainable solution adapted to Montreal's climate.

Whether you own a condo, a plex or a house, we offer turnkey HVAC solutions throughout Montreal, Laval, Longueuil, on the North Shore and the South Shore.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment