Installation of a Gree R-32 wall-mounted heat pump in Laval-des-Rapides
Installation of a Gree R-32 wall-mounted heat pump in Laval-des-Rapides. AirGreen delivers a residential project combining comfort, energy performance, and available subsidies in Greater Montreal.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A residential project where comfort and energy efficiency meet
At AirGreen , we recently installed a Gree wall-mounted heat pump in a residential home located in Laval-des-Rapides . The choice of this recent model with R-32 refrigerant perfectly illustrates the evolving needs of our customers: increased efficiency, performance in Quebec's cold climate and compatibility with available grant programs.
The chosen unit, a new-generation wall-mounted Gree , is specially designed to provide consistent comfort, even during the harsh winters of Greater Montreal. Its compact and discreet design blends harmoniously into the interior, while maximizing air circulation.
Technical details of the installation
Device selection
-
Brand: Gree
-
Type: wall-mounted heat pump (mini-split)
-
Technology: R-32 refrigerant (new ecological standard)
-
Available capacities: 9,000 to 24,000 BTU depending on room needs
-
Energy efficiency: High SEER and HSPF optimized for northern climates
Features of the installation
-
Installation height: installation at the top of the wall, allowing optimal air diffusion.
-
Drilling: discreet, ensuring direct passage of refrigerant pipes to the outside.
-
Condensate management: simple gravity drainage, reducing the risk of additional maintenance.
-
Aesthetic integration: the unit is fixed perfectly aligned to the ceiling, ensuring a clean and professional appearance.
Challenges encountered and solutions implemented
The installation space was located in a room with limited headroom due to the ceiling molding. Our team adjusted the alignment and optimized the drilling to ensure both the device's performance and flawless aesthetic integration.
In addition, we ensured that the refrigerant pipes were routed directly out of the system to limit piping length and thus reduce performance losses. This approach ensures optimal performance while minimizing energy costs for the customer.
Benefits for the customer
-
Four-season comfort : efficient heating down to -25°C and rapid cooling in summer.
-
Energy savings : thanks to the R-32 refrigerant, more efficient and environmentally friendly.
-
Accessible subsidies : this installation is eligible for Quebec's energy transition programs.
-
Fast and careful installation : a single day of work was enough to deliver a turnkey system.
AirGreen Expertise: A Guarantee of Peace of Mind
Every project carried out by our teams in Laval, Montreal and on the South Shore is based on the same approach: analysis of the client's needs, selection of the right equipment and rigorous implementation. Our goal is not just to install a machine, but to offer a complete, sustainable HVAC solution adapted to Quebec's realities.
By entrusting your project to AirGreen, you have the assurance of RBQ-certified work, carried out by qualified installers, and supported by reliable after-sales service.
Do you live in Laval, Longueuil, Montreal or on the North Shore or South Shore?
We support you from the choice of the device to its annual maintenance so that your home remains comfortable all year round.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
