Project

Installation of a Lennox wall-mounted air conditioner in Chomedey

Professional installation of a Lennox wall-mounted air conditioner in Chomedey, Laval: summer comfort, reduced consumption and discreet integration into a row building.

By AirGreen Climatisation & Chauffage Admin2 min read
Installation of a Lennox wall-mounted air conditioner in Chomedey
Installation of a Lennox wall-mounted air conditioner in Chomedey
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

A residential project requiring precision and discretion

At AirGreen , we understand that installing a wall-mounted air conditioner isn't just about plugging in a unit. Each project has its own unique technical constraints and must fit seamlessly into the client's lifestyle. In this case, our team worked in Chomedey, Laval , to equip a condominium with a high-performance, discreet, and durable Lennox wall- mounted system.

The context of the intervention

The client, living in a red brick townhouse-style building, wanted to maximize summer comfort without compromising the exterior aesthetics. The available space on the façade was limited and shared with other co-owners: a compact and harmonious installation was therefore required. In addition, access to the front door and garage had to remain unobstructed at all times, which required careful planning of the location of the outdoor units.

Equipment Choice: Lennox Reliability

The owner opted for a Lennox wall-mounted air conditioner , renowned for its energy efficiency and quiet operation. Lennox units are among the most reliable on the Quebec market, particularly for urban housing where performance must go hand in hand with discretion.

  • Brand: Lennox

  • Type: Wall-mounted air conditioner (single unit)

  • Installation: brick facade, on ground support with anti-vibration pads

  • Key benefit: guaranteed summer comfort with low noise impact

Technical details of the installation

External positioning

Our technicians fixed the unit to a ground support, slightly raised above the asphalt. This choice avoids any direct contact with moisture and reduces the transfer of vibrations to the structure. Precise alignment with other systems already installed (immediate neighbors) allows for careful visual integration .

Wiring and piping route

  • Direct drilling into the brick wall, with a short and optimized path.

  • Installation of neutral-colored protective capping to conceal refrigerant connections and ensure maximum durability.

  • Gravity routing of the condensation drain, avoiding the addition of a pump, thus limiting future maintenance.

Constraints and solutions

  • Limited space: the unit must be positioned without blocking the door or access to the recycling bin. This is resolved by precisely offsetting the support .

  • Co-ownership: installation compliant with standards and visually harmonized with the other condensers already in place.

Results obtained

Thanks to this installation, the owner now benefits from:

  • Optimal comfort during summer heat waves.

  • Reduced electricity consumption , thanks to a modern, Energy Star certified air conditioner.

  • A discreet system that blends in with the aesthetics of the building.

AirGreen expertise in Chomedey and beyond

This installation perfectly illustrates our approach: analyze, adapt and deliver impeccable work , even in restrictive contexts. Whether in Montreal, Laval, Longueuil, on the North Shore or the South Shore, our specialized HVAC installation teams always prioritize quality, compliance and customer satisfaction.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment