Project

Installation of a Sharp Eco Inverter wall-mounted heat pump in Laval (Laval-des-Rapides)

Sharp Eco Inverter wall-mounted heat pump installed in Laval-des-Rapides : head above the patio door, short run and compliant clearances, outdoor unit on balcony with anti-vibration pads. A neat HVAC installation by AirGreen.

By AirGreen Climatisation & Chauffage Admin7 min read
Installation of a Sharp Eco Inverter wall-mounted heat pump in Laval (Laval-des-Rapides)
Installation of a Sharp Eco Inverter wall-mounted heat pump in Laval (Laval-des-Rapides)
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

Four-season comfort, careful finishing and discretion in co-ownership

Context: a bright condo just steps from the metro

At AirGreen , we were commissioned to equip a condo in Laval-des-Rapides with a Sharp Eco Inverter wall-mounted heat pump . The living space opens onto a large patio door giving access to a balcony, with a blue bay window characteristic of the buildings in the area. The owner was looking for rapid cooling in the summer , comfortable additional heating in the spring and fall, and above all, a discreet integration that respected the rules of the co-ownership.

Choosing the right device: a Sharp wall-mounted unit is a sure bet

The Sharp Eco Inverter perfectly meets the constraints of an urban condo:

  • Inverter modulation to maintain a stable temperature without jolts;

  • Low noise levels , appreciated in co-ownership;

  • Sharp's own air treatment technology , practical for improving perceived comfort;

  • Compatibility with the climatic requirements of Greater Montreal .

Depending on the layout and insulation, we typically size between 9,000 and 18,000 BTUs for a living room open to the kitchen. Accurate sizing prevents over-equipment, reduces short cycles , and improves seasonal efficiency.

Interior integration: head above the patio door, homogeneous diffusion

We positioned the head above the patio door , clear of any obstacles, in order to sweep the air along the ceiling and then naturally return it to the living area. This layout:

  • optimizes air stratification and mixing;

  • frees up useful walls for furnishings;

  • simplifies crossing the wall to the balcony.

The refrigeration path takes a short route to the right of the unit. The connections are insulated and properly sheathed , the bend radius is respected, and the drilling is carried out at a controlled slope to allow gravity flow of condensate to the outside when the configuration lends itself to it. This detail avoids the addition of a pump, limits noise and reduces maintenance .

Finishing and protection of connections

In apartments, aesthetics count. We protect the lines with a tight, clean, and continuous white sheath , then—when required by regulations or the client—with rigid decorative capping that standardizes the finish and protects the insulation from impacts. The fasteners are distributed to eliminate hard points and prevent any vibration noise on the partition.

Outdoor installation: accessibility, discretion and clearances

The outdoor unit is installed on the balcony , directly above the wall crossing to shorten the lengths and limit the bends . We prefer a raised support in aluminum or galvanized steel with anti-vibration pads , in order to:

  • detach the device from the structure;

  • protect from meltwater and snow;

  • maintain compliant rear and side clearances , essential for air conditioning performance and defrosting in winter.

The air supply is oriented to prevent air from flowing back onto the façade and to preserve the peace and quiet of the neighbors. The external electrical disconnect switch is installed within easy reach, as required for safety and ease of maintenance.

Power supply, control and safety

The heat pump is powered by a dedicated circuit with the recommended circuit breaker rating . The connections are crimped , tested and protected in the provided boxes. We check the polarity , grounding , currents at different speeds and voltage stability before delivery to the customer.

Commissioning: the steps that make the difference

Our standard commissioning protocol includes:

  1. Nitrogen leak test and leak detection;

  2. Deep vacuum to remove moisture and residual air;

  3. Opening of valves and stabilization, control of pressures and temperatures ;

  4. Measurement of delta T when blowing in cold/heat modes, verification of sweeping and speeds;

  5. Thawing and restart settings and explanations of use to the customer.

These steps guarantee reliability , efficiency and longevity of the compressor.

Result: perceived comfort and controlled silence

  • Uniform cooling of the open area, including the kitchen area;

  • Rapid temperature rise in the off-season, ideal during late frosts in Laval;

  • Very low noise level , both inside and on the balcony;

  • Easy maintenance thanks to direct access to the filters and the outdoor unit.

Best practices for condos and co-ownerships

We regularly work in co-ownerships in Montreal, Laval, Longueuil, on the North Shore and the South Shore . Before work, we validate:

  • the position of the devices (distance from guardrails, clearances);

  • the method of condensate evacuation (gravity prioritized, pump if necessary);

  • permissible noise levels and working hours ;

  • visual harmony (capping colors, installation height).

AirGreen Technical Advice

  • Size right : Excessive capacity creates short cycles and humidity discomfort;

  • Reduce lengths and elbows to preserve cooling capacity ;

  • Anti-vibration devices are mandatory on balconies to prevent transmission through the structure;

  • Defrosting : preserve rear clearances, do not enclose the unit;

  • HVAC maintenance : periodic cleaning of filters, visual inspection of connections and the disconnector .

Maintenance and monitoring: maintaining performance

Annual HVAC maintenance is recommended:

  • dusting and gentle washing of filters ;

  • cleaning the internal exchanger ;

  • control of capping and fasteners ;

  • checking the condensate drainage ;

  • inspection of the support and the pads outside.

We offer maintenance packages tailored to high-rise residences, with quick turnaround times and intervention without disturbing neighbors.

Subsidies and energy efficiency

Recent, high-performance wall-mounted heat pumps are generally eligible for assistance programs, subject to performance criteria. We support our clients in Greater Montreal to document the installation , gather the necessary evidence , and optimize the file when the chosen equipment meets the required thresholds.

Pitfalls to avoid (feedback)

  • Drilling without sufficient slope towards the outside: risk of droplets and odors;

  • Ignore accessibility to the outdoor unit (cleaning, service);

  • Underestimate the impact of sound reflections on balcony windows;

  • Overtighten the sheath clamps: noise and localized wear;

  • Position the head in a lateral air corridor which short-circuits the diffusion.

Why AirGreen

Our team is adept at addressing the urban constraints specific to condos in Laval-des-Rapides : elevator access, delivery windows, time slot management, and compliance with trustee regulations. We deliver clean, documented , and durable HVAC systems , with accessible after-sales service and tracked parts .


Achievement Sheet – Highlights

  • Type : Sharp Eco Inverter wall-mounted heat pump

  • Location : Laval (Laval-des-Rapides)

  • Interior installation : head above the patio door , wide diffusion; clean and continuous white sheath

  • Route : short route to the balcony, controlled slope drilling (gravity condensates)

  • Outdoor installation : unit on balcony , raised support with anti-vibration pads , clearances respected

  • Electrical : dedicated circuit + accessible disconnect switch

  • Objective : four-season comfort , silence , preserved aesthetics , easy HVAC maintenance


Do you have a similar project?

We support co-owners and managers in Montreal, Laval, Longueuil, on the North Shore and the South Shore : thermal study , equipment selection , installation , grant assistance and maintenance . Contact us for a solution adapted to your condo and your co-ownership regulations.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment