Project

Installation of a Sharp wall-mounted heat pump in Chomedey (Laval)

AirGreen installs a Sharp wall-mounted heat pump in Chomedey (Laval): high installation, sloped drilling, clean finishes, and complete HVAC testing. Ideal for quiet in-room comfort. Serving Greater Montreal.

By AirGreen Climatisation & Chauffage Admin8 min read
Installation of a Sharp wall-mounted heat pump in Chomedey (Laval)
Installation of a Sharp wall-mounted heat pump in Chomedey (Laval)
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

Four-season comfort without compromise: careful interior installation that makes all the difference

At AirGreen , we're working in Laval for a couple looking to stabilize the comfort of their master bedroom year-round. The space is bright, with a south-facing window, a curtain rod under the future unit, and a standard ceiling. The need is clear: a quiet, energy-efficient Sharp wall-mounted heat pump installed with impeccable finishes to prevent drafts on the bed and preserve the room's aesthetics.

Why a Sharp wall-mounted heat pump here?

Sharp is one of the residential brands we regularly recommend for the greater Montreal area . The recent wall-mounted units with R-32 refrigerant combine high efficiency, low environmental impact and low noise levels. In a bedroom, these criteria are decisive: the night mode lowers the fan speed, the regulation maintains a stable temperature, and consumption remains controlled during the off-season. In our climates of Montreal, Laval, Longueuil, North Shore and South Shore , this type of equipment provides an excellent comfort/savings ratio when the HVAC installation is rigorous.


Our method of installing HVAC in a bedroom

Implementation and clearances: precision above all

We position the head at the highest point of the wall to promote a wide sweep of air without hitting the ceiling (risk of air short circuit ). In this room, the presence of a rod and a window under the device requires:

  • Sufficient vertical clearance for upper air intake;

  • A horizontal sweep that does not directly hit the curtains;

  • Discreet access for maintenance (filter and shutters).

Result: the unit is centered in relation to the load-bearing wall, above the window , which allows for uniform diffusion, including towards the opposite alcove.

Drilling and condensate management: controlled gravity

We make a single hole of suitable diameter (≈ 65 mm) with a gravity slope towards the outside. This slope secures the natural evacuation of condensates in air conditioning mode and limits the demands on a pump (not necessary here). We install a watertight bulkhead, a vapor barrier and an insulating sleeve to prevent any moisture infiltration.

Refrigerant lines and fittings: guaranteed performance

  • Brazing under nitrogen and pressure testing with dry nitrogen to detect the slightest leak;

  • High vacuum ≤ 500 microns until stabilization;

  • Continuously insulated connections to prevent condensation in the partition;

  • Anti-vibration drops behind the head to eliminate any nighttime buzzing.

On the exterior (facade), we favor a discreet cladding matching the color of the house, with soft radii to respect the minimal curves of the pipes. The communication cable follows the same route under the trunking, which simplifies any future HVAC maintenance .

Power supply and protections

We check the dedicated circuit breaker and the cable section according to the unit's nominal current. Our teams systematically recommend:

  • An external circuit breaker near the compressor for maintenance;

  • Surge protection on the panel when the site allows it, useful during storms.

Functional tests and interior finishing

Before delivery, we validate: hot/cold inversion, defrosting, fan speed, noise level , and drain sealing. The wall fixings are checked (anchors adapted to the type of wall). The covers and trims are adjusted for a clean integration above the window , without interfering with the rod or hindering the opening of the curtains.


Result: precise comfort, silence and energy efficiency

In a bedroom, the goal is not to produce a powerful blast, but a homogeneous airflow at low speed. Thanks to the high positioning and fine adjustment of the flaps, the air does not fall on the occupants: this avoids the sensation of cold air currents in summer and stratification in winter. The compressor-fan modulation algorithm maintains a stable temperature and reduces frequent starts , which reduces noise and consumption.

In terms of bills, the heat pump covers summer air conditioning and a large part of the heating in the off-season. In a typical bungalow or cottage in Chomedey , we often observe a drop in the load on electric baseboards, particularly in the mid-seasons of April-May and September-October.


Room layout advice (AirGreen feedback)

The 5 golden rules

  1. Avoid direct airflow onto the bed: aim for diffusion parallel to the ceiling, with the shutters slightly raised.

  2. Respect the clearances around the head: suction and blowing without obstacles (curtains, boxes).

  3. Preserve the facade : continuous cladding, stainless steel fixings, drain slope respected.

  4. Secure the electricity : suitable circuit breaker, correctly sized cable, external circuit breaker.

  5. Provide for maintenance : access to filters and temperature sensor, minimal space above the unit.

Common pitfalls to avoid

  • Install the device too close to the ceiling : the return air would “recirculate”, penalizing the efficiency.

  • Drilling above a concrete lintel without marking: risk of drain diversion and water stagnation.

  • Undersize the unit for a suite opening onto a hallway: the compressor will cycle too much, generating noise and wear.

  • Neglecting the anti-vibration treatment of the anchors: audible at night, precisely when you are looking for silence.


HVAC Maintenance: Simple and Essential

Annual HVAC maintenance extends unit performance and cleanliness:

  • Clean filters every 4 to 8 weeks in season (easy front access);

  • Drain and slope inspection;

  • Checking refrigerant parameters , blown temperatures and defrost cycle;

  • Gentle dusting of the exchanger to avoid loss of efficiency.

We offer tailored maintenance plans for Montreal, Laval, Longueuil, North Shore, South Shore , with seasonal reminders and preferential rates for AirGreen customers.


Grants and Eligibility (Overview)

Recent high-efficiency R-32 wall-mounted heat pumps are often eligible for Quebec programs when they meet the performance criteria for heating in cold weather. Our team verifies the eligibility of the chosen model (certificates, program lists, temperature criteria) and assists the client in putting together the file (proof of installation, AHRI , detailed invoices).


Why AirGreen for your installation in Laval and Greater Montreal?

  • Local expertise : we know the buildings and climatic characteristics of Chomedey, Vimont, Sainte-Dorothée and all of Laval .

  • Quality of execution : strict HVAC procedures (nitrogen, deep vacuum, complete tests), sober finishes inside and out.

  • Complete support : help choosing power (BTU), electrical verification, usage advice, scheduled HVAC maintenance .

  • Transparency : detailed quote, end-of-project photos, personalized recommendations (orientation of shutters, eco modes).


Construction site technical sheet (summary)

  • Type : Sharp wall-mounted heat pump (recent residential series with R-32 ).

  • Room treated : master bedroom, standard ceiling, window under the appliance.

  • Location : top of wall, above the window , clearances respected, blowing not directed towards the bed.

  • Drilling : single, gravity slope, watertight bulkhead, continuous insulation.

  • Refrigeration : brazing under nitrogen, pressure test, vacuum ≤ 500 microns , anti-condensation insulation.

  • Electrical : dedicated circuit breaker, compliant cable, external circuit breaker on the condenser side.

  • Finish : discreet exterior cover, anti-vibration mountings, clean integration with the existing rod.


And after installation: our recommendations for use

  • Auto mode in the off-season, moderate heat in winter, cool with low fan speed at night;

  • Flaps slightly upwards for optimal air mixing;

  • Window closed in air conditioning mode to maintain dehumidification;

  • Filters : regular cleaning; annual maintenance by our technicians to maintain original performance.


Conclusion

This Sharp installation in Chomedey (Laval) illustrates our requirements: correct sizing , a clean refrigeration path , reliable condensate management and finishes adapted to a room. The result is tangible: stable comfort , silence and energy savings all year round. For a similar project in Montreal, Laval, Longueuil, on the North Shore or the South Shore , our team guides you from the choice of equipment to recurring HVAC maintenance .

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment