Installation of a Sharp ZU1 wall-mounted heat pump in Rosemont–La Petite-Patrie (Montreal)
Installation of a Sharp ZU1 wall-mounted heat pump in Rosemont–La Petite-Patrie, Montreal: R-32 efficiency, Plasmacluster air purification and harmonious finish by AirGreen.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Careful installation of a Sharp heat pump from AirGreen
In a typical duplex in the Rosemont–La Petite-Patrie district of Montreal , our AirGreen team carried out the complete installation of a Sharp ZU1 wall-mounted heat pump — a new generation model operating with R-32 refrigerant , known for its energy efficiency and performance at very low temperatures .
The project involved offering the client four-season comfort in a dense urban space, while maintaining aesthetic discretion on the building's traditional red brick facade.
Exemplary external integration
The Sharp Eco Inverter condenser has been securely mounted on galvanized wall brackets , above ground level to ensure optimum protection against snow and moisture .
The installation includes a CSA approved electrical disconnect box , mounted directly near the unit for quick access during maintenance.
The refrigeration connections were carefully sheathed using brick-colored capping , blending perfectly with the existing facade. The result: a complex that is both robust, aesthetically pleasing and compliant with RBQ standards .
Sharp ZU1: performance and PlasmaCluster technology
The Sharp ZU1 series is distinguished by its Japanese Inverter compressor and its Plasmacluster Ion system, a patented technology that purifies the ambient air by eliminating particles, allergens and bacteria.
This wall-mounted heat pump combines efficient heating in winter and gentle air conditioning in summer , while improving indoor air quality — a much-appreciated asset in Montreal's urban environments.
Key features of the Sharp ZU1:
-
Capacity : 12,000 BTU
-
Eco-friendly refrigerant R-32
-
Energy efficiency : SEER2 23 / HSPF2 11
-
Operation down to −25°C
-
Plasmacluster technology for healthier air
-
Quiet mode (<22 dB) ideal for bedrooms and small spaces
A high-energy-efficiency residential project
The client, owner of a Montreal duplex, was looking for a replacement solution for his old air conditioner operating on R-410A.
Our team suggested the Sharp ZU1 , a smart choice offering:
-
reduced energy consumption ,
-
compatibility with LogisVert subsidy programs ,
-
and increased durability thanks to high-end components.
This installation now provides stable and economical heating , even during the bitter cold of January, while ensuring rapid cooling during heatwaves.
An installation that complies with the standards and aesthetics of the building
The typical residential environment of Rosemont–La Petite-Patrie —with its brick facades and green alleys—required a careful approach.
Our technicians planned the refrigeration duct route to minimize their visibility, while respecting the mandatory technical clearances to ensure optimal airflow around the condenser.
The result is a functional, silent and visually harmonious installation, faithful to the AirGreen philosophy: performance and design go hand in hand .
Why choose Sharp with AirGreen
Sharp heat pumps stand out for their precision Japanese technology and their design for northern climates .
Combined with AirGreen expertise, they guarantee:
-
perfect sizing according to the building configuration,
-
a clean and RBQ certified installation ,
-
and responsive after-sales service covering all of Greater Montreal , including Laval, Longueuil, the North Shore and the South Shore .
A sustainable and subsidized solution
Thanks to its high efficiency and use of R-32 refrigerant , the Sharp ZU1 is eligible for several provincial financial assistance programs , reducing the total cost of the project.
The customer will thus benefit from reduced energy bills while contributing to the reduction of the residential carbon footprint .
AirGreen: Your Trusted HVAC Partner in Montreal
At AirGreen , each project is unique.
We combine technical expertise , quality materials and exceptional customer service to ensure lasting comfort in every home.
Our mission: to offer reliable, aesthetic and energy-efficient HVAC installations adapted to Quebec's climate.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What the unit delivers when it is cold
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).