Project

Installation of a Gree Flexx central heat pump in Chomedey

AirGreen installed a Gree Flexx R32 central heat pump in Chomedey, Laval, under a parking garage. A technical installation optimized for comfort, durability, and energy efficiency in all seasons.

By AirGreen Climatisation & Chauffage Admin2 min read
Installation of a Gree Flexx central heat pump in Chomedey
Installation of a Gree Flexx central heat pump in Chomedey
Generic diagram: central heat pump, indoor module and ducts

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. It captures or rejects heat outside. It sits on a level base, above the snow, with free space all around.

  2. The insulated refrigerant lines enter the house through a sealed opening and run to the indoor coil.

  3. A shut-off switch near the outdoor unit isolates it safely for service.

  4. Sitting on the indoor module, it moves heat between the house air and the refrigerant.

  5. Electric furnace or air handler: its fan pushes air through the ducts. The electric backup takes over in extreme cold.

  6. Supply ducts bring air to the rooms; returns bring it back to the unit. Their condition matters as much as the unit's.

  7. It protects the coil and the fan. A dirty filter cuts airflow, so it gets checked regularly.

  8. It runs the heat pump and the backup heat. It must be compatible with the installed system.

A sheltered installation optimized for performance in all seasons

At AirGreen , we recently installed a Gree Flexx R32 central heat pump in a residential building in the Chomedey sector of Laval . This project was distinguished by an atypical configuration: the outdoor unit was installed under a parking shelter , requiring careful planning to ensure adequate air circulation and the safety of the vehicle parked nearby .


Context and choice of system

The client wanted to upgrade their existing HVAC system to a more energy-efficient solution that could provide year-round heating and cooling . After analyzing the building's layout and space constraints, our team recommended the Gree Flexx Ultra R32 – 3 tons , known for its inverter compressor technology , performance down to -30°C , and compatibility with Quebec grant programs .

Features of the installation

The outdoor unit was suspended from a concrete slab , with a threaded rod support and anti-vibration dampers to eliminate sound resonances. This type of mounting, often used in covered parking lots, allows for optimizing floor space while maintaining ventilation of the condenser.

We also have:

  • added reinforced insulating sleeves on the refrigeration ducts;

  • fixed a defrost guard under the unit to prevent any ice build-up;

  • installed metal-sheathed wiring for maximum durability;

  • checked the minimum clearance required around the fan for optimal performance.

Technical challenges met

The main challenge was the ceiling height limitation . To address this, our technicians adjusted the length of the suspension rods and chose a precise drainage angle for gravity condensation . The installation was thus carried out without altering the concrete structure, while respecting Gree standards and the building code.

Final result

The client now benefits from stable, quiet, and economical comfort . Thanks to R-32 technology, this heat pump reduces the carbon footprint while offering energy efficiency greater than 18 SEER. This project perfectly illustrates our ability to adapt each AirGreen installation to the specificities of the Greater Montreal residential environment.


Why choose AirGreen for your HVAC installation in Laval?

Our teams are distinguished by their technical rigor , their field experience and their respect for the highest standards in the HVAC field. Whether for a wall-mounted, central or multi-zone heat pump, we provide:

  • a complete analysis of your building;

  • a clean, compliant and durable installation;

  • attentive and responsive after-sales follow-up.

Each AirGreen project combines local expertise, energy performance and long-term comfort .

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the ducts, the current indoor module, the electrical panel and the planned spot for the outdoor unit.

  1. The on-site estimateWe look at the ducts, the current indoor module, the electrical panel and the planned spot for the outdoor unit.
  2. The quoteThe equipment combination, capacity and price, in writing. We check whether the combination qualifies for assistance programs.
  3. Getting readyAccess protected, old unit disconnected and removed when it is being replaced.
  4. The indoor moduleElectric furnace or air handler, with its coil, connected to the supply and return ducts.
  5. The outdoor unitOn a level base, raised above the snow, with free space all around.
  6. The refrigerant linesInsulated, they enter through a sealed opening and run to the indoor coil.
  7. Electrical and thermostatDedicated circuits, accessible disconnect, a thermostat that works with the heat pump and the backup heat.
  8. Tests and start-upLeak test, vacuum, start-up, airflow check and a test of both modes.
  9. The walkthroughFilter, thermostat, backup heat in extreme cold: what to know before winter.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour electric furnace, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Check the indoor module's filter.
    • Clear winter debris from the outdoor unit.
    • Test cooling before the heat arrives.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    11 questions
    Can I keep my current ducts?
    Often, yes: the central heat pump connects to the existing ducts. We check their condition and size during the estimate.
    What happens in extreme cold?
    The indoor module (furnace or air handler) works with the central heat pump and takes over in extreme cold.
    Furnace, air handler, ducted: what is the difference?
    The furnace or air handler is the indoor module of the central system. A ducted system hides in the ceiling: all you see are small supply grilles.
    Are there grants?
    Depending on the equipment and your situation, assistance programs may apply. AirGreen checks the exact combination before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city. See permits and by-laws, and we check for your address.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Will my current thermostat work?
    Not always: the thermostat has to run the heat pump and the backup heat. We check compatibility during the estimate.
    Central or wall units: which one?
    If the house has ducts in good shape, a central system heats and cools every room at once. Without ducts, wall units or a multi-zone are often simpler. We compare on site.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment