Installation of a Gree FreeMatch heat pump in Rosemont–La Petite-Patrie
AirGreen installed a Gree FreeMatch multi-zone heat pump in Rosemont–La Petite-Patrie, providing four-season comfort and a solution perfectly suited to Montreal's urban spaces.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
As part of a residential project carried out in Rosemont–La Petite-Patrie , our AirGreen team installed a Gree FreeMatch multi-zone wall-mounted heat pump , a choice perfectly suited to the realities of the plexes and urban dwellings typical of this area of Montreal.
This district, characterized by its brick buildings, compact interior spaces, and well-known planning constraints, demands HVAC solutions that are discreet, efficient, and flexible . This is precisely what Gree's FreeMatch range delivers.
A multi-zone heat pump designed for Montreal spaces
The installed system is a Gree FreeMatch series MultiZone (mini-split multi-zone) heat pump . This technology allows several indoor wall units to be powered by a single outdoor compressor, while offering independent temperature control in each zone.
In a context like Rosemont–La Petite-Patrie, where each room may have different thermal needs (kitchen, living room, office, bedroom), this type of configuration provides customized comfort without compromising aesthetics or living space.
Why the Gree FreeMatch range is an excellent choice
The Gree FreeMatch series is renowned for its versatility and reliability in northern climates. It integrates perfectly into Montreal residential projects, whether for renovations or existing construction.
Among its notable advantages:
-
Compatible with 2 to 5 indoor units
-
Excellent heating performance even during Quebec winters
-
Inverter technology for optimized energy consumption
-
Quiet operation, ideal for dense living environments
-
Different power levels can be installed depending on the room.
Even when the exact model is not visible to the naked eye, the installed configuration corresponds to a Gree FreeMatch R32 multi-zone heat pump , consistent with the brand's current standards.
Installation details observed on the construction site
The internal installation reveals several important technical elements:
-
Compact wall unit , installed high up for optimal air distribution
-
Refrigeration lines are concealed within a vertical molding, ensuring a clean and discreet finish.
-
The piping is routed to the outside through a side wall, minimizing the visual impact.
-
Installation carried out in a space with a suspended ceiling , requiring increased precision for positioning.
-
Compliance with Gree's recommended clearances for maintenance and performance
This type of environment requires rigorous planning. At AirGreen, we adapt each installation to the actual constraints of the building, whether it is a duplex, triplex or renovated dwelling.
Four-season comfort, summer and winter
Thanks to the Gree FreeMatch heat pump, the occupants benefit from:
-
Effective cooling during the summer months , even during Montreal's heat waves
-
Stable and economical heating during the winter, reducing dependence on auxiliary electric systems
-
Precise temperature control by zone, improving overall comfort
-
Improved energy efficiency, resulting in savings on bills.
AirGreen's expertise serving Rosemont–La Petite-Patrie
Every project undertaken by AirGreen is based on a clear approach: analyze, adapt, and optimize . In this area of Montreal, we are well aware of the challenges related to existing buildings, load-bearing walls, brick facades, and local regulations.
Our team handles the entire process:
-
Technical evaluation
-
Recommendation of the appropriate system
-
Neat installation
-
Full commissioning
-
Usage and maintenance instructions
With a Gree FreeMatch heat pump, installed correctly, you are investing in a sustainable, high-performance solution perfectly suited to the urban reality of Montreal.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
