Project

Installation of a Gree wall-mounted heat pump in Brossard

AirGreen installed a Gree wall-mounted heat pump in the living room of a Brossard home, near the patio door leading to the backyard. The result: quiet and efficient comfort in both air conditioning and heating, perfectly suited to the winters and summers of Greater Montreal.

By AirGreen Climatisation & Chauffage Admin6 min read
Installation of a Gree wall-mounted heat pump in Brossard
Installation of a Gree wall-mounted heat pump in Brossard
–chapters in this story
6 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

When this Brossard family contacted us, their goal was clear: to improve comfort in their main living room year-round, while preserving the room's aesthetics. They opted for a Gree wall-mounted heat pump , the ideal solution for a single-family home on the South Shore that experiences both the heat waves of July and the biting cold of January.

Our AirGreen team therefore carried out the complete installation of a Gree wall unit in the living room overlooking the backyard, for a result that is efficient, discreet and perfectly adapted to the climatic reality of Greater Montreal.


Context of the residency in Brossard

The residence is typical of Brossard's residential neighborhoods:

  • Single-family home with backyard and wooden deck

  • Large patio door leading outside

  • Main living area with standard ceiling, light and uncluttered walls

These characteristics directly influence the design of a comfort system. The patio door lets in a lot of light… and heat in the summer, but also heat loss in the winter. Therefore, it was necessary to:

  • A system capable of rapidly cooling the volume of the room during heat waves;

  • An efficient low-temperature heating technology, to reduce dependence on the main heating system;

  • A visually discreet installation, without visible pipes or bulky floor-standing appliances.

The Gree wall-mounted heat pump perfectly met these requirements.


Why choose a Gree wall-mounted heat pump?

Gree wall systems are known for:

  • Their high energy efficiency , thanks to Inverter technology;

  • Their ability to ensure stable heating even in very cold weather is a major issue on the South Shore;

  • Their quiet operation makes them ideal for a living room or family area;

  • Their simple and compact design blends easily into a light-colored wall, as seen in the photo.

For this project, we opted for a Gree wall-mounted heat pump from the recent residential range , around 12,000 BTU , perfectly sized for a medium-sized open-plan living room, while offering some leeway during temperature extremes.


Strategic positioning of the wall unit

The photo shows the Gree indoor unit installed high up, near the ceiling , centered on the main wall and close to the patio door:

  • This position allows the blown air to sweep across the entire room , then descend naturally, ensuring a homogeneous distribution of temperature.

  • Placed away from obstacles (high furniture, beams, protrusions), the unit benefits from optimal air circulation .

  • The proximity of the patio door also facilitates the management of heat gain in summer: fresh air is directed to where the sun hits the most.

We have also ensured sufficient clearance above the device , which improves performance and simplifies future maintenance (filter cleaning, inspection).


Passage through conduits and meticulous finishing

Behind this clean, minimalist result lies meticulous work:

  • The refrigerant lines (insulated copper), condensation drain and wiring were run directly behind the unit , through the exterior wall, to join the Gree condenser installed in the yard.

  • The drilling was carried out with a slight controlled slope to allow the natural drainage of condensate , avoiding any risk of water backing up into the house.

  • All penetrations have been carefully sealed and insulated to eliminate air and moisture infiltration.

Outside, the conduit route is protected by a cover (gutter) harmonized with the color of the coating, ensuring a clean finish that respects the aesthetics of the rear facade.


Electrical connections and commissioning

A high-performance wall-mounted heat pump requires flawless connections. Our certified technicians have:

  • Verified the electrical panel capacity and installed the dedicated circuit breaker required by the Gree heat pump's power.

  • Connected the power supply in accordance with the standards in force in Quebec.

  • A complete vacuum was performed on the refrigeration circuit before opening the valves, in order to eliminate residual moisture and air in the lines.

  • Pressurization process, leak tests and verification of operating parameters (pressure, current, blown temperatures).

The final commissioning was accompanied by a training session with the occupants : basic settings, use of heating, air conditioning, dehumidification modes, programming, and best practices to maximize the lifespan of the heat pump.


Four-season comfort for a Brossard family

Thanks to this installation, the family now enjoys:

  • Fast and quiet cooling during hot days on the South Shore, without relying solely on a noisy and energy-intensive window air conditioner.

  • It provides very efficient supplementary heating in spring and autumn, and is a valuable support in winter to reduce reliance on the main heating system.

  • Improved air quality thanks to the filters in the wall unit and the constant air circulation in the living room.

The unit's unobstructed position on the main wall prevents direct drafts on the sofa or dining table, while ensuring a consistent temperature. The room, previously prone to temperature fluctuations due to the large patio door, is now stable, comfortable, and inviting at all times .


AirGreen: Your Gree heat pump specialist in Brossard and on the South Shore

At AirGreen, we support homeowners in Brossard, Saint-Lambert, La Prairie and throughout Greater Montreal with their wall-mounted and central heat pump projects.

Our approach:

  • Analysis of your needs (surface area, insulation, house orientation)

  • Recommendation of the right Gree heat pump model or another recognized brand

  • Professional installation, compliant with standards and subsidy program requirements where applicable.

  • After-sales service, maintenance and long-term technical support

If you, like this Brossard family, wish to improve your comfort and reduce your energy costs with a Gree wall-mounted heat pump, our team is ready to advise you and carry out a turnkey, reliable and durable installation.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment