Project

Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie

For this home in Rosemont–La Petite-Patrie, we installed a Gree wall-mounted heat pump above the bedroom door to optimize air circulation and year-round comfort. With its sleek finish, quiet operation, and efficient heating in winter, this compact solution completely transforms the occupants' quality of life.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
–chapters in this story
5 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

In this residential project in Rosemont–La Petite-Patrie, we were called in to solve a very common problem: an upstairs bedroom that was always too hot in the summer and difficult to heat evenly in the winter. The ideal solution in this type of situation? A Gree wall-mounted heat pump dedicated to the room—discreet, quiet, and extremely efficient in all seasons.


Tailor-made comfort for an upstairs bedroom

The room to be air-conditioned is a closed bedroom, accessible via a narrow corridor. In summer, fresh air from the ground floor did not reach this area properly; in winter, the temperature varied from one end of the floor to the other.

We therefore recommended the installation of a Gree wall-mounted heat pump of approximately 9,000 BTU , perfectly sized for an average-sized bedroom. This type of unit offers:

  • Excellent temperature control, degree by degree;

  • Very quiet operation, essential for a bedroom;

  • An efficient heating mode that reduces reliance on electric baseboard heaters;

  • Optimized power consumption thanks to frequency inversion technology.


Strategic positioning of the Gree wall-mounted head

The central element visible in the photo is the Gree wall-mounted interior head unit , installed just above the door frame leading to the bedroom. This positioning is not accidental:

  • It allows the treated air to diffuse both into the room and towards the corridor when the door is open;

  • It makes maximum use of the available ceiling height, which improves air circulation and avoids direct drafts on the bed;

  • It frees up the main walls of the room for furniture and decoration.

The finish around the door was meticulously executed, and the unit blends seamlessly with the existing woodwork. Visually, the heat pump remains discreet, while being ideally positioned to provide optimal comfort.


Careful management of refrigeration connections and drainage

On the right side of the unit, a white cover conceals the refrigerant lines, the communication cable, and the condensate drain. This finish choice allows for:

  • To maintain a clean and minimalist look inside;

  • To protect the ducts from shocks and dust;

  • To guide the lines directly towards the outside wall, without unnecessarily crossing the room.

The condensate drain is installed with an adequate slope to ensure the evacuation of water produced in air conditioning mode, thus avoiding any risk of leakage or damp smell in the room.


The Gree outdoor unit is discreet and well-positioned.

Outside (not visible in the photo), the Gree compressor is installed in such a way as to:

  • Minimize the transmission of vibrations to the structure of the house;

  • Facilitate seasonal maintenance (cleaning, inspection);

  • Protect the device from the accumulation of snow and ice typical of Montreal winters.

The whole system is connected to a dedicated electrical circuit, compliant with current standards, with an appropriate circuit breaker and an external circuit breaker for service interventions.


Four-season performance in the Montreal climate

A properly sized and installed Gree wall-mounted heat pump is a valuable asset in a neighbourhood like Rosemont–La Petite-Patrie, where buildings often combine multiple floors, closed rooms and significant heat gains in the summer.

For this family, the benefits are immediate:

  • Summer : a cool room, even during heat waves, with a low noise level allowing for peaceful sleep;

  • Autumn and spring : gentle, rapid heating without having to start up the entire house system;

  • Winter : an efficient supplemental heating system that reduces electricity bills compared to baseboard heaters, while maintaining a stable temperature during cold nights.

The remote control and programmable modes allow you to adjust the temperature for the night, start a preheating before bedtime or reduce the setting during hours of absence.


Air quality and everyday comfort

Beyond temperature control, this Gree installation also improves the overall comfort of the room:

  • Integrated filtration that traps dust and fine particles;

  • Improved air circulation, which reduces stagnant areas and the feeling of "heavy" air;

  • Precise control of relative humidity in air conditioning mode, for a healthier environment.

Thanks to the high positioning and orientation of the shutters, the air is blown towards the center of the room and then gently descends, eliminating the sensation of a direct draft on the occupants.


AirGreen: your Gree expert in Rosemont–La Petite-Patrie

At AirGreen, we install and maintain Gree wall-mounted heat pumps daily throughout Greater Montreal. Our approach is based on:

  • A precise analysis of the volumes to be processed and the configuration of the rooms;

  • A rigorous sizing of the capacity in BTU;

  • A meticulous installation , both technically and aesthetically;

  • An accessible and responsive after-sales service for annual maintenance and performance monitoring.

Whether you wish to air-condition a single room, an entire floor, or multiple areas of your home, we will assist you from equipment selection to commissioning, including information on available subsidy programs when applicable.


Conclusion: a small unit, a big impact on comfort

This Gree wall-mounted heat pump installation in Rosemont–La Petite-Patrie perfectly illustrates what we love to achieve: a simple, well-thought-out solution that tangibly transforms the comfort of a key room in the house. A discreet unit above a door, neatly concealed connections, a compressor conveniently positioned outside… and a bedroom that finally becomes comfortable year-round.

If you live in Rosemont–La Petite-Patrie or elsewhere in Greater Montreal and you have a room that is always too hot or too cold, our team will be happy to offer you a Gree solution tailored to your situation.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment