Project

Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie

In this Rosemont–La Petite-Patrie duplex, AirGreen installed a Gree wall-mounted heat pump above the stairwell window. This strategic placement, combined with the existing ceiling fan, distributes heat and coolness across two floors, while reducing energy consumption and improving everyday comfort.

By AirGreen Climatisation & Chauffage Admin6 min read
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

In this Rosemont–La Petite-Patrie duplex, the owner was looking for an efficient solution to heat and cool both the upper floor and the stairwell leading to the ground floor. Temperature variations were significant: too hot in the summer, too cold in the winter, and a constant draft near the stairs.

We recommended the installation of a Gree wall-mounted heat pump in the strategic space of the stairwell, above the window, in order to distribute air evenly over both levels.


Project context in Rosemont–La Petite-Patrie

The dwelling is typical of this Montreal neighborhood: narrow interior staircase, relatively high ceiling, central window providing some natural light, and a ceiling fan already in place.

This type of configuration presents several challenges:

  • Hot air tends to rise and accumulate at the top of the stairs.

  • The ground floor often remains cooler, especially at the beginning and end of the season.

  • Existing heating systems (baseboard or aging central system) do not always allow for fine temperature regulation according to zones.

Our objective was therefore twofold: to stabilize comfort on both levels and to reduce energy consumption thanks to a high-performance wall-mounted heat pump.


Choosing a Gree wall-mounted heat pump

For this project, we installed a new generation Gree wall-mounted heat pump , with a capacity adapted to the area served (approximately 12,000 BTU to cover the stairwell, the upper floor and part of the ground floor).

Why Gree for this Rosemont client?

  • High energy efficiency : inverter technology allows power to be modulated according to the actual need, instead of operating in on or off mode.

  • Winter heating performance : the heat pump is designed to offer good performance even during Quebec's cold weather, down to about -25°C.

  • Quiet operation : ideal for a circulation area such as a staircase where noise would be particularly disturbing.

  • Reliability and durability : Gree is one of the brands we regularly install, with a very positive history in terms of service and longevity.

By combining the device's capacity, the staircase configuration, and the presence of a ceiling fan, we were able to offer a complete solution for home comfort.


An optimized installation in the stairwell

Strategic positioning above the window

We installed the indoor unit above the window overlooking the staircase , perfectly centered on the wall. This positioning offers several advantages:

  • Ideal vertical and horizontal diffusion : the blown air naturally descends along the staircase and is then distributed upwards and downwards.

  • Maximum use of ceiling height : the heat pump captures the warmer air accumulated at the top to redistribute it efficiently.

  • Refined aesthetics : the white Gree wall head blends into the light wall, without visually overloading this already narrow space.

As you can see from the photo, the area behind the unit has been prepared and leveled, ensuring a clean, stable and durable installation.

Management of refrigeration connections and drainage

Behind the wall unit are:

  • The refrigeration lines that connect the indoor unit to the outdoor compressor.

  • The condensation drain , essential for removing the water produced in air conditioning mode.

  • Electrical communication and power cabling .

We transported these items discreetly to the outside, respecting:

  • the slopes necessary for reliable gravity drainage,

  • Insulating the pipes to prevent energy loss and condensation formation,

  • The electrical standards in force in Quebec.

The Gree compressor is installed outside, on a support adapted to the Montreal climate, clear of snow and with easy access for maintenance.

Synergy with the ceiling fan

A key feature of this project is the presence of a ceiling fan in the stairwell . Combined with the Gree heat pump, this configuration allows for:

  • to circulate warm air downwards in winter, reducing stratification;

  • to improve the circulation of cold air in summer, for a more uniform feeling of coolness;

  • to reduce the number of cycles of the heat pump, which helps to extend its lifespan and reduce electricity consumption.

We advised the client on the best fan speed and rotation direction settings depending on the season, in order to take full advantage of this synergy.


Comfort, performance and energy savings

In practice, this type of installation offers several concrete benefits for the owner:

  • Consistent comfort between the upper floor and the ground floor: no more rooms that are too hot upstairs and too cold downstairs.

  • Precise temperature control : the Gree remote control allows adjustment to within half a degree, with several modes (heating, air conditioning, dehumidification, ventilation).

  • Potential reduction in heating costs : the wall-mounted heat pump uses electricity to move heat rather than produce it, which is much more efficient than traditional baseboard heaters.

  • Dehumidification in summer : in addition to cooling, the device removes excess humidity, significantly improving comfort during heat waves.

  • Quiet operation : ideal for a staircase often adjacent to bedrooms and living spaces.

We took the time to show the customer how to use the different functions, washable filters, eco modes and time programs in order to maximize savings.


Why entrust your heat pump project to AirGreen?

At AirGreen, we don't just put a machine on a wall. We analyze your home, your lifestyle and the specific characteristics of each room to offer the right heat pump, in the right place, with the right configuration .

For this Rosemont–La Petite-Patrie project, this translated into:

  • an on-site assessment of heating and air conditioning needs;

  • a sizing adapted to the surface area served by the stairwell;

  • the careful installation of the Gree wall-mounted heat pump above the window, with discreet management of the lines to the outside;

  • operational tests in heating and air conditioning;

  • Maintenance tips to ensure the longevity of the device.

Whether you are in Rosemont, another Montreal neighbourhood, Laval, on the North Shore or the South Shore, we can offer you a Gree solution or another brand adapted to your reality, always in compliance with the standards and best practices of the residential HVAC sector.


Do you have a stairwell that's difficult to heat or cool? Do you want to reduce your bills while increasing comfort? We can help you find the ideal wall-mounted heat pump for your house, condo, or duplex.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment