Job sheet · Project

Installation of a Gree Clivia wall-mounted heat pump in Duvernay, Laval

Installation of a Gree Clivia R32 heat pump in Duvernay, Laval by AirGreen. An energy-efficient and quiet solution for optimal comfort in Montreal, Laval, Longueuil, North Shore, and South Shore.

By AirGreen Climatisation & Chauffage Admin4 min read
City
Region
Equipment
Brand
Challenges
Published
–chapters, to open one by one
4 minto read the whole story
–type of installation
2026year published
At a glance

The job on one screen

Installation of a Gree Clivia wall-mounted heat pump in Duvernay, Laval
Installation of a Gree Clivia wall-mounted heat pump in Duvernay, Laval
The full story

The article, chapter by chapter

An elegant and efficient solution for four-season comfort

At AirGreen , we recently installed a Gree Clivia R32 wall-mounted heat pump in a residence located in Duvernay, Laval . This residential area, known for its modern homes and bright spaces, is an ideal environment for this type of device, designed to offer energy performance, discretion and aesthetics .

The indoor unit, with its glossy white finish and clean lines, blends seamlessly into the customer's living space, while ensuring consistent thermal comfort—summer and winter alike.


An installation designed for performance and durability

Our RBQ-certified technicians carried out the complete installation of this Gree Clivia R32 system, an energy-efficient and quiet model equipped with Inverter technology. This technology automatically adjusts the compressor power according to the actual heating or cooling demand, thus reducing electricity consumption and extending the life of the system.

The chosen model — 12,000 BTU — adapts perfectly to the layout of the home, optimizing air distribution in the main rooms while maintaining a stable temperature, even during winter colds reaching −25°C .


Technical details and installation configuration

  • Brand: Gree

  • Model: Clivia R32

  • Capacity: 12,000 BTU

  • Type: Wall-mounted heat pump (mini-split)

  • Location: Duvernay, Laval

  • Special features of the installation:

    • Wall-mounted head positioned at a strategic height for uniform air diffusion

    • Discreet hole through the wall to the outside

    • Wiring and refrigerant pipes carefully concealed under white capping to match the wall

    • Optimized gravity drainage to the exterior, eliminating the need for a condensate pump

    • Complete leak test and pressure calibration with digital pressure gauge

The entire route was planned to minimize visual impact and maximize thermal performance. Thanks to the precision of AirGreen's teamwork, this installation combines efficiency, reliability and aesthetics .


Choosing R-32 refrigerant: a step towards a greener future

The Clivia model operates with R-32 refrigerant , recognized for its low global warming potential (GWP) compared to the old R-410A. This choice demonstrates our commitment to a sustainable energy transition that complies with the strictest environmental standards.

In addition, this heat pump is eligible for certain subsidies offered under Quebec programs, notably for high-performance Energy Star® certified devices.


Quiet comfort and discreet design

Another major advantage of the Gree Clivia model is its ultra-quiet operation . The indoor unit, installed in a corner of the living room, emits barely 19 dB , allowing the customer to enjoy absolute comfort without background noise. Its minimalist design harmonizes perfectly with the pale gray walls of the room, creating a modern yet discreet ensemble.


An installation by AirGreen: expertise and satisfaction

At AirGreen, we believe that a successful HVAC installation is based on three pillars: careful selection of equipment, meticulous installation and impeccable customer service .

Our team supported the project owner from the first call to full commissioning of the device, including:

  • A personalized thermal assessment of the space

  • Technical recommendations on capacity and optimal location

  • Post-installation monitoring to ensure performance and comfort

The result: a more comfortable, more efficient and more environmentally friendly residence.


Why choose AirGreen for your HVAC installation in Laval

Our company is distinguished by:

  • A team certified and continuously trained on new R-32 and R-454B technologies

  • Fast and careful installations , adapted to each type of residence

  • Recognized expertise throughout Greater Montreal, from the North Shore to the South Shore

  • Attentive after-sales service , guaranteeing peace of mind for our customers

Each project is a showcase of our expertise for us - and this installation in Duvernay is a prime example.


In conclusion

The Gree Clivia R32 heat pump embodies the perfect blend of design, efficiency, and ecology. Its installation by AirGreen in Duvernay, Laval, demonstrates our ability to deliver high-performance HVAC solutions perfectly suited to the Quebec climate.

For any similar project in Laval, Montreal, Longueuil, on the North Shore or the South Shore , our team is ready to support you with the same level of excellence.


AirGreen – Heat Pumps, Air Conditioning and Heating in Montreal and Laval
Your comfort, our specialty for over a decade.

Your numbers

The job tools

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    The steps

    How the job unfolds

    The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

    Step 1 of 9The on-site estimate

    We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

    1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
    2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
    3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
    4. The wall openingA single opening, with the slope the drain needs to flow outside.
    5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
    6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
    7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
    8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
    9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
    The tour

    What we check on a job like this one

    Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

    Generic diagram: wall-mounted heat pump, indoor and outdoor units

    In summer, the outdoor unit rejects the house's heat outside.

    Generic illustration of this type of installation, not a survey of this job site. Tap a number.

    1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

    2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

    3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

    4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

    5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

    6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

    7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    Maintenance

    Good habits, once the unit is in place

    Six simple habits that keep the unit going. Your list stays on this device.

    0 / 6 checked
    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    For your project

    The right pages, at the right time

    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    An on-site estimate, the right capacity, the right equipment.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment