Installation of a Gree wall-mounted heat pump in a condo in Saint-Laurent
Installation of a Gree wall-mounted heat pump in a condo in Saint-Laurent. AirGreen, HVAC experts in Montreal and the surrounding area, offers comfort, savings, and grants.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A discreet installation, perfectly suited to urban spaces
In the Saint-Laurent neighborhood, many homeowners are looking for efficient heating and cooling solutions that blend seamlessly into their interior spaces. At AirGreen , we recently installed a Gree wall-mounted heat pump , a choice that combines energy efficiency, discretion, and everyday comfort.
The main challenge in this type of urban project is often space optimization. Condos and apartments rarely have large open wall areas, and the installation must take into account the existing layout while complying with electrical safety and energy efficiency standards.
Why a Gree wall-mounted heat pump is ideal for a condo in Montreal
The wall-mounted heat pump has become essential for condominiums. It provides both air conditioning in the summer and heating in the winter , while consuming much less energy than a traditional electric heating system.
The model installed here, from the Gree range , is recognized for:
-
Its ability to operate efficiently down to -25°C , an essential asset for Montreal winters.
-
Its quiet operation makes it ideal for tight spaces.
-
Its sleek design fits perfectly into modern interiors.
-
Its eligibility for energy subsidies from the LogisVert program and other government incentives.
Installation process by AirGreen
Strategic positioning of the indoor unit
The unit was installed high up, close to the ceiling and in a corner , which allows:
-
Even distribution of air throughout the room.
-
A gain in wall space, leaving the possibility of freely arranging the furniture.
-
Aesthetic discretion, the device blending perfectly into the decor.
Management of conduits and connections
-
The routing of refrigerant pipes and electrical cables has been optimized to minimize visible length and ensure a neat finish.
-
White capping was installed, matching the wall color for a discreet appearance.
-
Condensate drainage is carried out by gravity , avoiding the need for a pump, thus reducing noise and maintenance costs.
Coordination with the electrical panel
Our technicians have provided a secure connection that complies with RBQ standards, with a dedicated circuit breaker, guaranteeing maximum reliability.
Benefits for the customer
Following this installation, the owner benefits from several concrete advantages:
-
4-season comfort : stable heating in winter, efficient air conditioning in summer.
-
Energy savings : significant reduction on the electricity bill compared to basic heating.
-
Peace of mind : a system guaranteed for 10 years on parts and compressor.
-
Condo valuation : the presence of a modern wall-mounted heat pump is an asset on the real estate market.
Why choose AirGreen for your HVAC installation in Montreal
At AirGreen , we don't just sell and install equipment: we analyze each project taking into account space, technical constraints, and the client's needs. Our RBQ-certified technicians ensure:
-
A clean and durable installation.
-
Personalized advice on choosing the capacity (BTU) based on the area to be air conditioned or heated.
-
Support for obtaining government subsidies .
-
Responsive and efficient after-sales service.
Conclusion: a sustainable and smart investment
This Gree wall-mounted heat pump installation in Saint-Laurent perfectly illustrates the importance of precise work adapted to Montreal's urban realities. Thanks to a discreet and optimized installation, the client benefits from superior comfort and real energy savings, while enhancing the value of their home.
If you live in Montreal, Laval, Longueuil, the North Shore or the South Shore , and you are considering installing a wall-mounted air conditioner or a wall-mounted heat pump , our team at AirGreen will be happy to assist you at every stage of your project.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
