Project

Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie

In this Rosemont–La Petite-Patrie home, AirGreen installed a Sharp wall-mounted heat pump above the patio door to provide efficient heating in winter and quiet air conditioning in summer, while respecting the aesthetics of the ground floor.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
–chapters in this story
5 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

When this homeowner in Rosemont–La Petite-Patrie contacted us, he wanted a more comfortable heating and cooling solution than his electric baseboard heaters , but without losing floor space or sacrificing the aesthetics of his living area. We recommended the installation of aSharp wall-mounted heat pump , a perfect solution for typical homes in the neighborhood with living and dining rooms open onto a patio door.


The project: to modernize the comfort of a typical Rosemont ground floor

The main room opens directly onto a large sliding patio door leading to a glazed extension. In winter, this area was particularly cool; in summer, the sunlight made the space feel heavy and uncomfortable.

Our objectives:

  • Ensuring efficient heating even in the depths of Montreal's coldest weather .

  • Provide quiet air conditioning for the living room and dining area.

  • Integrate the device discreetly and harmoniously into an already furnished setting (furniture, painting, wooden moldings).

  • Reduce your electricity bill by replacing a significant portion of your direct electric heating with a high-efficiency heat pump .


The chosen solution: a new generation Sharp wall-mounted heat pump

We installed a Sharp residential R-32 wall-mounted heat pump , sized to cover the open-concept main floor. This type of mini-split system is ideal for:

  • Townhouses and plexes in Rosemont.

  • Areas where ventilation ducts are to be avoided .

  • Customers who want an excellent comfort/fuel consumption ratio .

The compact, neutrally designed interior module blends seamlessly with the pale walls and wooden frames. Positioned high above the patio door, it optimizes airflow to the living room, dining room, and glazed extension.


Indoor unit positioning: performance and aesthetics

The choice of location is crucial for the performance of a wall-mounted heat pump. In this project, we have:

  • Center the Sharp wall-mounted head above the patio door, at a good distance from the ceiling to allow for optimal air intake .

  • Orient the supply louvers so as to direct the treated air towards the main living area , without blowing directly on the occupants.

  • Respect the necessary clearances for future maintenance (cleaning of filters, inspection of coils, etc.).

Visually, the device is discreet: it fits between a decorative painting and the wooden molding of the patio door, without encroaching on the furniture or passageways.


Refrigerant line routing and condensate drainage

Behind this clean and minimalist installation lies significant technical work:

  • Neat wall penetration : refrigerant lines, communication cable and drainage line pass through the wall to the outside in a single hole, protected by a sleeve and sealed to prevent any air or moisture infiltration.

  • External cable tray : Outside, the pipes are grouped in a rigid, UV-resistant cable tray, matched to the color of the facade to minimize visual impact .

  • Gravity drainage : the condensate pipe is laid with a constant slope to avoid any stagnation of water, an essential point for the durability of the installation and the prevention of odors.


Sharp outdoor unit: discreet and reliable in winter

The Sharp outdoor unit (not visible in the photo) was installed near the patio door, in a location:

  • Sufficiently open to allow good air circulation .

  • Raised on suitable supports to remain above the snow accumulation.

  • Located away from traffic areas, to reduce perceived noise and facilitate snow removal.

Before commissioning, we carried out the following:

  • A nitrogen pressure test to check the tightness of the refrigeration circuit.

  • A thorough vacuuming process to eliminate residual moisture and air.

  • A complete check of the connections, refrigerant charge and electrical protections.

The result: a system ready to face Quebec winters, with stable performance during defrost cycles.


Electrical connection and controls

To power the Sharp heat pump, our partner electricians have:

  • Run a dedicated line from the electrical panel, with a circuit breaker adapted to the power of the appliance.

  • Installed an outdoor circuit breaker (disconnect) near the compressor, in accordance with the Quebec Electrical Code.

The customer now benefits:

  • From an intuitive wall-mounted or portable remote control for everyday use.

  • With adapted operating modes: heating, air conditioning, dehumidification and ventilation.

  • Fine temperature settings, time programming and modulated ventilation for customized comfort .


Everyday comfort: summer and winter in Rosemont

Thanks to this installation, the owner now benefits from:

  • For efficient heating during the biting cold typical of January and February.

  • Gentle and quiet air conditioning during summer heat waves.

  • A substantial reduction in energy consumption , because the heat pump transfers heat instead of producing it solely by electrical resistance.

The location above the patio door also allows for better management of:

  • Solar heat gain from glazed surfaces.

  • The areas that were previously colder near the openings are now uniform thanks to the constant air circulation.


Why choose AirGreen for a Sharp wall-mounted heat pump in Montreal?

At AirGreen, we regularly install Sharp wall-mounted heat pumps in homes and condos in Rosemont–La Petite-Patrie and Greater Montreal. Our approach:

  • Detailed analysis of needs (surface area, insulation, lifestyle habits).

  • Selecting the right Sharp model based on the room and the desired level of comfort.

  • Careful installation, designed to last: solid fixing, noise management, easy maintenance.

  • Accessible after-sales service, with a team that knows the product as well as the realities of Montreal's climate .

Are you considering installing a Sharp wall-mounted heat pump for your home in Rosemont or elsewhere in Greater Montreal? We can offer you a turnkey solution, from choosing the capacity to commissioning and assistance with available subsidies.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment