Project

Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie (Montreal)

Discover how AirGreen installed a Sharp ZU1 wall-mounted heat pump in a Rosemont–La Petite-Patrie condo, providing four-season comfort, excellent energy efficiency, and discreet interior integration.

By AirGreen Climatisation & Chauffage Admin7 min read
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie (Montreal)
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie (Montreal)
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

In this bright condo in Rosemont–La Petite-Patrie, our team installed aSharp wall-mounted heat pump to provide year-round comfort perfectly suited to Montreal's climate. This project perfectly illustrates what we love to achieve at AirGreen: discreet, high-performance integration designed with both energy efficiency and interior aesthetics in mind.


Context: a city condo that needed four-season comfort

The client lives in a typical Rosemont–La Petite-Patrie condo: relatively high ceilings, very clean white walls, and an open-plan main living area. The main challenge was twofold:

  • To effectively cool the home during the intense summer heat, particularly at the end of the day when the sun is beating down on the facade.

  • To heat economically during the off-season and enhance comfort in winter, in addition to the existing system.

The client wanted a solution:

  • silent;

  • compact;

  • with low visual impact on the main wall of the living room;

  • using a more modern refrigerant that has less impact on the environment.

This is what led us to choose a Sharp ZU1 wall-mounted heat pump of approximately 12,000 BTU , operating on R-32 refrigerant (A2L classification) .


Why a Sharp ZU1 wall-mounted heat pump?

The Sharp ZU1 series is a line of R-32 wall-mounted heat pumps very well suited to the realities of Greater Montreal. For this project, it ticked all the boxes:

1. Performance and energy efficiency

  • Ideal capacity for a medium-sized condo with an open concept layout.

  • Inverter technology to modulate power according to actual needs.

  • Excellent performance coefficients, allowing for reduced electricity consumption compared to a simple air conditioner or purely resistive heating.

2. Modern R-32 (A2L) Refrigerant

In the photo, the A2L marking is clearly visible on the lower part of the wall-mounted unit. This indicates the use of a new generation refrigerant.

  • Global warming potential (GWP) significantly reduced compared to R-410A.

  • Optimized charging, with a lower overall environmental impact.

  • Compliance with safety and ventilation standards related to A2L refrigerants.

3. Acoustic comfort

The Sharp wall-mounted unit is designed for low noise operation, which is essential in a condo where the living area, dining area, and sometimes a home office are all located in the same room. The fan and outdoor compressor work together to provide very quiet operation, even in the evening or at night.


Interior installation details: a clean integration on a white wall

The photo shows an installation perfectly aligned with the wall , placed high up, a few centimeters from the ceiling. This position is not accidental:

  • It allows for better air circulation , with fresh or warm air naturally descending into the room.

  • It leaves the wall free for furniture, picture frames, or a television.

  • It facilitates uniform diffusion in the open area.

A minimalist wall line

The Sharp heat pump stands out for its very understated design : a white casing with rounded corners, a smooth front panel, and a discreet air vent. We have:

  • Centered the wall head on the most unobstructed section of wall.

  • Ensure that the access hatch and the area for writing safety instructions remain visible for maintenance.

The horizontal louvers visible in the photo allow for precise control of the airflow, whether it be:

  • towards the lounge area in air conditioning mode;

  • towards the dining area or circulation in heating mode.


Outdoor installation details: performance and winter protection

Even though the outdoor unit isn't visible in the photo, it's an integral part of the project. In this Rosemont–La Petite-Patrie condo, we installed the Sharp compressor:

  • on sturdy wall brackets , at a sufficient height for snow removal;

  • with anti-vibration pads to minimize noise transmission;

  • while respecting the necessary clearances for air circulation and access to the service.

We also have:

  • sized and insulated the refrigeration lines according to the manufacturer's specifications;

  • protected the wiring and piping with a decorative cover on the outside;

  • adequate drainage of condensate is planned, essential in air conditioning mode as well as in defrosting mode in winter.


Managing condo constraints: silence, security and compliance

Installing a wall-mounted heat pump in a condo requires taking into account:

  • the condominium regulations;

  • the immediate neighbors;

  • structural constraints (slab, load-bearing walls, facade).

Our team has:

  • validated the locations to avoid noise disturbances for the neighbors;

  • chose a refrigerant line passage that limits penetrations while maintaining an interior aesthetic without visible ducts in the living room;

  • complied with current electrical standards, with a dedicated circuit breaker and compliant wiring.


The result for the customer: year-round comfort in Rosemont–La Petite-Patrie

In use, the Sharp wall-mounted heat pump offers several immediate benefits:

Summer: controlled coolness, reduced humidity

  • Rapid cooling of open areas, even during Montreal heat waves.

  • Dehumidification function that improves comfort without overcooling.

  • Simple programming via remote control, with the option of a silent night mode.

Winter: stable and economical heat

  • The heat pump provides gentle and constant heat , particularly pleasant in a condo with large glass surfaces.

  • The customer can reduce the load on their electric auxiliary heater , thereby lowering their energy bill.

  • The defrost cycles are optimized to limit the loss of comfort, even in very cold weather.

Mid-season: maximum flexibility

In spring and autumn, the heat pump allows you to:

  • Heat it up slightly in the morning;

  • Cool down a little in the afternoon if the sun is making the room too hot.

All this with very moderate electricity consumption .


Sharp Heat Pump Maintenance and Durability

To maximize the lifespan of the device, we provided the client with a simple plan:

  • Regular cleaning of the wall head filters ;

  • Annual check of the outdoor unit (accumulation of leaves, snow, ice);

  • Periodic professional maintenance , recommended every 2–3 years, to check the refrigerant charge, the condition of electrical connections and overall performance.

Sharp heat pumps are designed to last for many years in a harsh climate like Montreal's, provided they are properly maintained.


Why choose AirGreen for your Sharp wall-mounted heat pump in Montreal?

As a company specializing in residential HVAC in Greater Montreal , we support our clients at every stage:

  • Needs analysis and sizing : choosing the right capacity (BTU) based on surface area, orientation and insulation.

  • Selection of the most suitable Sharp range (ZU1, ZHU1, TU, THU, multi-zone, etc.).

  • Careful installation respecting Quebec standards, manufacturer requirements and condominium rules.

  • Support for applicable financial assistance programs when relevant.

  • After-sales service and maintenance to ensure the longevity of the system.

This installation in Rosemont–La Petite-Patrie perfectly illustrates our approach: four-season comfort , a minimal visual footprint and modern technology, all designed by Sharp and implemented by AirGreen.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment