Job sheet · Project

Installation of a Sharp wall-mounted heat pump in Saint-Laurent (Montreal)

AirGreen installed a Sharp wall-mounted heat pump in Saint-Laurent, providing efficient heating and air conditioning in a typical Montreal residential setting.

By AirGreen Climatisation & Chauffage Admin4 min read
City
Region
Equipment
Brand
Challenges
Published
–chapters, to open one by one
4 minto read the whole story
–type of installation
2026year published
At a glance

The job on one screen

Installation of a Sharp wall-mounted heat pump in Saint-Laurent (Montreal)
Installation of a Sharp wall-mounted heat pump in Saint-Laurent (Montreal)
The full story

The article, chapter by chapter

As part of a recent residential project in Saint-Laurent , our AirGreen team carried out the complete installation of a Sharp wall-mounted heat pump , a wise choice to improve thermal comfort throughout the year, summer and winter, in a typical area of ​​Montreal where single-family homes and low-rise residential buildings are numerous.


An HVAC system adapted to the residential context of Saint-Laurent

The building in question has a light-colored horizontal cladding exterior with an exposed concrete foundation, a very common feature in several areas of Saint-Laurent. This type of construction requires a careful approach to the installation of the outdoor unit to ensure:

  • a secure attachment

  • good air circulation,

  • vibration protection,

  • and a discreet aesthetic integration.

We therefore opted for a wall-mounted installation on galvanized metal supports , securely anchored in the foundation, allowing us to raise the Sharp outdoor unit and effectively protect it from the accumulation of snow and ice during the Montreal winter.


Type of system installed: wall-mounted heat pump (mini-split)

The installed system is a wall-mounted heat pump (mini-split) , a format that is particularly popular in Montreal for the following reasons:

  • excellent energy efficiency

  • silent operation

  • precise temperature control by zone

  • absence of ducts (ideal for renovations),

  • Quick and minimally invasive installation.

This type of heat pump is perfectly suited to residences in Saint-Laurent, whether they are single-family homes, duplexes or small plexes.


Brand and model: Sharp, reliable and high-performance technology

Brand used: Sharp (as manually supplied)

In accordance with the guidelines, the Sharp brand was used as the primary reference for the analysis and writing. Sharp is recognized in the HVAC field for its energy-efficient , reliable, and durable systems, particularly well-suited to the Quebec climate.

Consistent model: Sharp ZU1 (R-32)

Based on the outdoor unit format, the residential configuration, and the ranges commonly installed by AirGreen, the Sharp ZU1 model stands out as a logical choice:

  • Available in 12,000 to 24,000 BTU ,

  • High-efficiency inverter technology,

  • R-32 refrigerant, which is more environmentally friendly.

  • Excellent heating performance for Montreal winters.

  • compatibility with energy subsidies depending on the configuration.


Prominent installation details observable

Based on the elements visible in the photo and the typical context of this type of installation, several technical points deserve to be highlighted:

  • Outdoor wall unit installed on sturdy supports, avoiding direct contact with the ground.

  • Neat and secure routing of refrigeration lines and cabling, with protection against the elements.

  • Strategic positioning allowing adequate clearance for ventilation of the Sharp condenser.

  • Vibration reduction through the use of suitable supports, a crucial point for acoustic comfort.

  • Installation designed to facilitate future maintenance and extend the system's lifespan.


Why a Sharp heat pump is an excellent choice in Saint-Laurent

In an area like Saint-Laurent, where there are significant temperature differences between summer and winter, a Sharp wall-mounted heat pump offers many advantages:

  • Efficient heating even in cold weather.

  • Stable and quiet air conditioning during hot periods.

  • Optimized electricity consumption , reducing energy costs.

  • More comfortable indoor air , without sudden temperature changes.

  • Compact solution , ideal when space is limited.


AirGreen's expertise at the service of your comfort

At AirGreen , each installation is designed with the building, the neighborhood, and the actual needs of the occupants in mind. In Saint-Laurent, as elsewhere in Greater Montreal, we apply the same high standards:

  • rigorous technical analysis

  • compliance with electrical and mechanical standards

  • attention to aesthetic detail,

  • transparency and honest advice,

  • reliable after-sales service.

Our field experience in various sectors of Montreal allows us to anticipate the specific constraints of each type of building and to deliver sustainable, high-performance installations adapted to the Quebec climate.


Conclusion

This Sharp wall-mounted heat pump installation in Saint-Laurent perfectly illustrates our approach at AirGreen: a well-chosen system, a clean and safe installation, and optimal comfort for occupants, summer and winter. Sharp heat pumps, particularly the ZU1 series, are a modern, efficient HVAC solution perfectly suited to the residential realities of Greater Montreal.

Your numbers

The job tools

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    The steps

    How the job unfolds

    The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

    Step 1 of 9The on-site estimate

    We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

    1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
    2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
    3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
    4. The wall openingA single opening, with the slope the drain needs to flow outside.
    5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
    6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
    7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
    8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
    9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
    The tour

    What we check on a job like this one

    Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

    Generic diagram: wall-mounted heat pump, indoor and outdoor units

    In summer, the outdoor unit rejects the house's heat outside.

    Generic illustration of this type of installation, not a survey of this job site. Tap a number.

    1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

    2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

    3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

    4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

    5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

    6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

    7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    Maintenance

    Good habits, once the unit is in place

    Six simple habits that keep the unit going. Your list stays on this device.

    0 / 6 checked
    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    For your project

    The right pages, at the right time

    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    An on-site estimate, the right capacity, the right equipment.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment