Installation of a Sharp wall-mounted heat pump in Sainte-Rose (Laval)
In Sainte-Rose, Laval, our AirGreen team installed a Sharp ZU1 wall-mounted heat pump on a raised wall bracket, freeing up floor space while providing 4-season heating and cooling comfort perfectly suited to the Quebec climate.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
In this residential project in Sainte-Rose, Laval, we were tasked with optimizing the comfort of a brick house while respecting space constraints at the rear facade. Our team installed a Sharp wall-mounted heat pump , model Sharp ZU1 Inverter 12,000 BTU , on a raised wall bracket above the patio door to free up access and protect the unit from snow accumulation.
The context: a typical suburban house, 4-season needs
The residence is a single-family home built of red brick, typical of Sainte-Rose: backyard, large patio door, and pronounced eaves. The owners wanted:
-
A reliable 4-season heating and air conditioning system for Laval's climate.
-
Free up floor space for movement and terrace layout.
-
Reduce noise and vibration near outdoor living areas.
The chosen solution: a Sharp ZU1 wall-mounted heat pump installed high up, under the eaves, on a robust galvanized steel support.
Why a Sharp ZU1 wall-mounted heat pump?
The Sharp ZU1 series is renowned for its inverter technology, precise power modulation, and excellent balance between performance and acoustic comfort. For this home in Sainte-Rose, the 12,000 BTU model perfectly meets the needs of a main living area encompassing a living room, dining room, and open-plan kitchen.
Key benefits for occupants:
-
Efficient heating and air conditioning for our Quebec climate.
-
Inverter technology allows for maintaining a stable temperature, without large fluctuations.
-
Improved air filtration , ideal for reducing dust and allergens.
-
A recognized, reliable brand, with available parts and after-sales service provided by AirGreen.
A raised wall-mounted installation: safety, comfort and aesthetics
The photo clearly shows the Sharp condenser mounted on a triangular metal wall bracket , securely anchored in the brick. This installation choice is not merely aesthetic; it serves several technical purposes.
-
Protection against snow and ice
By raising the heat pump, we protect it from snow accumulation, snow removal on the patio, and ice puddles that form on the ground. This significantly reduces the risk of damage and blockage of the fan. -
Freeing up floor space
The area under the unit remains clear for traffic, setting up a BBQ area or patio furniture. Nothing encroaches on the patio door or the walkway. -
Vibration reduction
We installed anti-vibration pads on the support to limit the transmission of vibrations to the masonry and the interior of the house. The result: quieter operation, both for the occupants and the neighbors. -
Compliance with clearances and ventilation
The unit is positioned under the eaves, but with sufficient clearance at the rear, sides, and front to ensure optimal airflow . This provides partial protection from direct rain while preventing the recirculation of hot air.
Technical details of the outdoor installation
Beyond the wall mount, several technical elements are visible on the installation:
-
Anchoring in brick : the support is fixed with mechanical anchors adapted to the masonry, sized to support the weight of the unit and additional loads (wind, snow, vibrations).
-
Outdoor electrical box : in the immediate vicinity of the heat pump, we can see the outdoor safety circuit breaker (disconnect), which complies with the electrical code and is easily accessible for maintenance.
-
Refrigeration connections and power supply : the refrigeration pipes and power cable are routed discreetly to the rear and side of the unit, minimizing the visual impact on the brick.
-
Defrost management : the elevated location facilitates the drainage of defrost water under the unit, away from passageways.
All these steps are carried out by our certified technicians, respecting industry standards and municipal regulations in force in Laval.
Indoor comfort: gentle warmth in winter, coolness in summer
The Sharp wall-mounted heat pump installed in Sainte-Rose supplies a perfectly positioned indoor unit to circulate the air in the main living area. For the occupants, this translates to:
-
Gentle and constant warmth in winter , reducing reliance on traditional electrical systems.
-
Consistent coolness in summer , without direct cold drafts on the occupants.
-
Energy cost reduction thanks to Inverter operation and the high efficiency of the heat pump compared to electric baseboard heaters.
-
A low noise level , both inside and outside, which is essential in a quiet residential area like Sainte-Rose.
Maintenance and longevity: our AirGreen support
To ensure the performance and durability of this Sharp ZU1 wall-mounted heat pump , we have developed a regular maintenance plan with the customers:
-
Annual cleaning and inspection of the outdoor unit: fan, coils, drainage tray, supports.
-
Cleaning of the internal head filters and verification of the proper functioning of the flaps and probes.
-
Checking electrical connections, refrigerant level and operating parameters.
Regular maintenance not only prolongs the life of the device, but also maintains high performance and optimal air quality in the home.
AirGreen: your HVAC partner in Laval and throughout Greater Montreal
At AirGreen, we support each customer from the choice of brand – here Sharp – to the custom installation , including financing, advice on subsidies where available, and after-sales service.
Whether you are in Laval, Montreal, on the North Shore or the South Shore , our team is there to:
-
Analyze your actual needs (surface area, insulation, lifestyle habits).
-
Suggest the most suitable wall-mounted heat pump (Sharp or other major brands).
-
Designing a robust, safe and discreet installation , like this project in Sainte-Rose.
-
Ensuring professional support throughout the entire lifespan of your equipment.
If you too would like to enjoy the comfort of a Sharp wall-mounted heat pump installed according to best practices, contact us: we will be happy to assess your project and offer you a turnkey solution.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).