Home » AirGreen's Outstanding HVAC Projects in Greater Montreal, Laval, Longueuil, South Shore and North Shore » Installation of a Sharp Eco Inverter wall-mounted heat pump in Rosemont–La Petite-Patrie
Project

Installation of a Sharp Eco Inverter wall-mounted heat pump in Rosemont–La Petite-Patrie

AirGreen installed a Sharp Eco Inverter wall-mounted heat pump in Rosemont–La Petite-Patrie. An efficient, aesthetically pleasing, and durable HVAC solution for year-round comfort in Montreal.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a Sharp Eco Inverter wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Sharp Eco Inverter wall-mounted heat pump in Rosemont–La Petite-Patrie
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

A successful HVAC installation project in a typical Montreal brick building

In the Rosemont–La Petite-Patrie neighborhood, we recently installed a Sharp Eco Inverter wall-mounted heat pump . This project perfectly illustrates our AirGreen team's ability to integrate a modern heating and air conditioning (HVAC) system into a brick-facade Montreal building, while respecting space and aesthetic constraints.

Installation context

The client, owner of a plex in Rosemont, wanted to modernize his home comfort system to reduce his energy costs and improve indoor air quality. After analyzing his needs, we recommended the installation of a Sharp Eco Inverter wall-mounted heat pump , a model known for its stable performance, its Plasmacluster Ion technology for air purification, and its ability to maintain optimal efficiency even during Montreal's cold winters.

Technical details of the Sharp heat pump

  • Brand : Sharp

  • Model : Eco Inverter (wall-mounted series)

  • Technology : Plasmacluster Ion for healthier air

  • Type : Wall-mounted heat pump (mini-split)

  • Support : Fixing on sturdy wall brackets

  • Power supply : Direct connection to the panel via a secure junction box

  • Benefits : High energy efficiency, quiet operation, built-in purification technology

This system is eligible for certain grant programs available to residents of Montreal, Laval, Longueuil, the North Shore and the South Shore , because it meets the energy efficiency criteria required by Hydro-Québec and Transition Énergétique Québec.

Installation Steps

  1. Site preparation :
    After inspecting the rear brick facade, we identified the optimal location for the outdoor unit to ensure good airflow and easy maintenance.

  2. Installation of the outdoor unit :
    The Sharp unit was mounted on reinforced wall brackets to ensure long-term stability, even in Montreal's weather conditions (snow, frost, wind).

  3. Electrical connection :
    Metal conduit was used to secure the cables to the junction box, ensuring an installation that complies with electrical safety standards.

  4. Passage of refrigerant pipes :
    The connections were carefully insulated and installed in a discreet manner to preserve the aesthetics of the building.

  5. Commissioning and testing :
    Once the connections were checked, we proceeded to the performance tests: air circulation, temperature regulation and energy efficiency.

Constraints and solutions provided

  • Space constraints : The rear facade being narrow, it was necessary to limit the footprint. Solution: installation on wall brackets.

  • Building aesthetics : The client wanted to preserve the harmony of its facade. The solution: discreet routing of conduits and electrical boxes painted tone on tone.

  • Winter Protection : We've incorporated reinforced fasteners and adequate clearance to prevent snow buildup and facilitate drainage.

Results obtained

Thanks to this installation, the customer now benefits from:

  • Four-season comfort (heating in winter, air conditioning in summer).

  • A reduction in energy bills thanks to inverter technology.

  • Purified air thanks to the Plasmacluster system.

  • A discreet and durable installation , adapted to the realities of a Montreal plex.

Why choose AirGreen for an HVAC installation in Montreal?

At AirGreen , we focus on:

  • Reliable and certified equipment such as Sharp, Fujitsu, Gree or Midea.

  • Facilities that comply with RBQ standards .

  • Personalized advice to maximize your available grants .

  • Fast, careful and guaranteed installation service.

Whether you live in Montreal, Laval, Longueuil, on the North Shore or the South Shore , our team will come to you to offer you modern, efficient HVAC solutions adapted to your building.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    GrantsAssistance programs in effectAirGreen checks your model before quoting an amount.PermitsYour city’s rulesLocation, distances, noise: what changes from city to city.InstallationOur installation serviceGreater Montréal and Montérégie.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    Book my free estimate514 316-2973
    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment