Installation of a Sharp ZU1 Wall-Mounted Heat Pump in Saint-Bruno
Discover the comfort and energy efficiency of the Sharp ZU1 15,000 BTU heat pump, installed by AirGreen in Saint-Bruno. Eco-friendly, quiet, and powerful, it's the perfect solution for Quebec’s climate!
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Bringing Comfort to New Heights with Sharp ZU1 Mini-Split in Saint-Bruno
At AirGreen, we’re proud to serve clients across Greater Montreal, Laval, Longueuil, the North Shore, and the South Shore with high-quality HVAC solutions. Recently, our team completed an impressive mini-split installation for a home in Saint-Bruno, featuring the cutting-edge Sharp ZU1 15,000 BTU wall-mounted heat pump. This installation is a perfect example of how we bring comfort, efficiency, and reliability to our customers’ homes—especially as we head into another frigid Quebec winter.
Why Sharp ZU1? A Game-Changer in Home Comfort
The Sharp ZU1 heat pump offers an exceptional blend of performance, affordability, and eco-friendliness. This unit is capable of both cooling and heating, making it perfect for homes in Quebec’s climate where we experience extreme temperatures, from hot summer days to harsh winters. One of its most standout features is its ability to operate at outdoor temperatures as low as -27°C—a critical advantage for homeowners looking for reliable heating during Quebec’s brutal cold spells.
But there’s more: the Sharp ZU1 is the first mini-split in its class to use the revolutionary R-32 refrigerant, which is not only greener and more energy-efficient but also complies with the new government standards coming into effect in 2025. This ensures that your HVAC system is future-proof and aligned with evolving energy-efficiency regulations. And, with Energy Star® certification, it guarantees that your home stays warm while keeping energy consumption in check.
Highlights of the Installation
For this particular project in Saint-Bruno, the homeowner was looking for a heating and cooling solution that could handle the challenging weather conditions of Quebec while keeping energy bills low. The Sharp ZU1 was the perfect choice.
- Cooling Capacity: 15,000 BTU
- Heating Capacity: Functions seamlessly even at -27°C
- Efficiency Rating: An impressive 24.0 SEER
- Noise Levels: Quiet operation with just 23 dB(A) indoors—perfect for maintaining a peaceful home environment
- Admissible for the LogisVert Grant: The Sharp ZU1 model qualifies for the highest $2,172 LogisVert grant from Hydro-Québec, making it the most attractive option for a 15,000 BTU unit in the province.
The Installation Process: A Seamless Experience
For this project, we took great care to ensure that the installation was executed to perfection. Our experienced team arrived at the home in Saint-Bruno early in the morning, equipped with all the necessary materials to install the Sharp ZU1 wall-mounted heat pump. The exterior unit was mounted securely on the brick wall, and meticulous attention was given to running the piping and wiring in a way that is both functional and aesthetically pleasing.
Given the extreme weather conditions in Quebec, we ensured that the Sharp ZU1 heat pump was installed with its defrost mode and multiple drainage holes fully operational to avoid any freezing issues in the harsh winter months. The anti-corrosive coating on the outdoor unit also guarantees a longer lifespan, even with the wear and tear of Quebec's harsh winters.
Superior Features of the Sharp ZU1
One of the standout features of this heat pump is Plasmacluster technology, a unique air purification system that eliminates airborne bacteria, mold, and viruses, ensuring that the air in your home is not only comfortable but also healthy. This technology is exclusive to Sharp, making it a go-to option for customers who want clean air circulating through their home.
- Airflow Control with Coanda Effect: The Sharp ZU1’s Coanda effect ensures that the airflow reaches every corner of the room without blowing directly onto the occupants, making it a more comfortable option for daily use.
- Inverter Technology: This mini-split comes equipped with Sharp's inverter technology, allowing the system to run more efficiently, reduce energy waste, and maintain a steady indoor temperature.
- Multizone Capability: With its multi-space function, the Sharp ZU1 can distribute air to several rooms, making it ideal for homes with multiple floors or larger spaces.
Energy Efficiency and Environmental Responsibility
At AirGreen, we care deeply about the environment, and the Sharp ZU1 aligns with our mission of delivering eco-friendly solutions. The R-32 refrigerant used in this model is not only more efficient but also reduces the appliance's carbon footprint by about 10%, compared to older models that rely on R-22 or R-410A refrigerants. This means homeowners can enjoy a more sustainable lifestyle without sacrificing comfort or performance.
A Smart Home HVAC Solution
This model also comes with integrated Wi-Fi connectivity, enabling homeowners to control their heat pump remotely via a smartphone app. Whether you're at home or away, you can easily adjust the temperature, check energy consumption, or even set schedules for the unit—all with a few taps on your phone. Plus, with the app's real-time temperature and humidity monitoring, the Sharp ZU1 ensures you're always aware of the comfort levels in your home.
Conclusion: A Successful Project in Saint-Bruno
Our latest installation of the Sharp ZU1 15,000 BTU mini-split heat pump in Saint-Bruno is a testament to our commitment to providing reliable, energy-efficient, and environmentally friendly HVAC solutions to homeowners throughout Greater Montreal. The Sharp ZU1 is more than just a heat pump; it’s a long-term investment in home comfort, energy savings, and air quality.
If you’re considering a heat pump for your home, don’t hesitate to contact AirGreen. Whether you’re in Montreal, Laval, Longueuil, the North Shore, or the South Shore, we’re here to help you find the perfect solution tailored to your needs.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What the unit delivers when it is cold
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).