Installation of a Sharp ZU1 wall-mounted heat pump on a balcony in Rosemont–La Petite-Patrie
AirGreen installed a Sharp ZU1 wall-mounted heat pump on a condo balcony in Rosemont–La Petite-Patrie, a compact and efficient solution perfectly suited to the Montreal urban context.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
As part of a recent residential project in Rosemont–La Petite-Patrie , our AirGreen team installed aSharp wall-mounted heat pump , a perfect choice for the masonry urban condos typical of this Montreal neighbourhood. This type of environment—narrow balconies, brick façades, and aesthetic and acoustic constraints—requires a precise approach, both technically and in terms of regulations.
A sensible choice for a Montreal condo: the Sharp wall-mounted heat pump
The client wanted a discreet, high-performance, and energy-efficient solution capable of providing comfort in both summer and winter without taking up too much outdoor space. The Sharp ZU1 wall-mounted heat pump was the obvious choice.
This model is known for:
-
its high-efficiency inverter technology ,
-
Its silent operation is essential in dense urban environments.
-
its compatibility with Quebec winters,
-
Its compact size makes it ideal for installation on a condo balcony.
Sharp's ZU1 range, using R-32 refrigerant, offers an excellent balance between energy performance, reliability and compliance with current environmental standards.
Installation details observed on the construction site
The installation was carried out on a concrete balcony , directly adjacent to a brick facade, a very common situation in Rosemont–La Petite-Patrie. Here are the main technical elements we took into account:
-
Sharp outdoor unit installed on a raised aluminium base , ensuring stability, adequate drainage and vibration reduction.
-
Respecting minimum clearances around the condenser for optimal air circulation, despite the limited space.
-
Strategic positioning to limit the visual impact and preserve the use of the balcony.
-
Careful routing of refrigeration lines , with appropriate protection against weather and temperature variations.
-
Special attention is paid to noise levels , a key issue in co-ownership.
This type of installation clearly demonstrates that a wall-mounted heat pump can be seamlessly integrated into an urban condo without compromising on performance.
Four-season comfort and energy efficiency
The Sharp ZU1 , available in capacities from 12,000 to 24,000 BTU , is perfectly suited to the typical size of Rosemont condos. It allows you to:
-
efficient and even cooling during heat waves,
-
reliable heating in autumn, spring and winter , reducing dependence on electric heating,
-
controlled energy consumption , thanks to the Sharp Inverter.
For the occupants, this translates into consistent comfort, better indoor air quality and real savings on the electricity bill.
Why AirGreen for a Sharp heat pump installation in Rosemont?
At AirGreen , we are intimately familiar with the realities of Montreal's real estate market: condominium regulations, architectural constraints, limited access, and neighborhood requirements. Each installation is custom-designed.
Our added value:
-
specific expertise in urban residential HVAC ,
-
Expertise in Sharp products, including the ZU1.
-
attention to detail, both aesthetic and technical.
-
comprehensive support, from assessment to commissioning.
This project in Rosemont–La Petite-Patrie illustrates our ability to deliver clean, efficient and sustainable installations, even in complex spaces such as condo balconies.
An ideal solution for condos in Greater Montreal
The Sharp ZU1 wall-mounted heat pump is a particularly relevant option for condo owners in Montreal, Laval, or on the South and North Shores. It combines discretion, performance, and longevity—three essential criteria in urban environments.
Whether it's for a project similar to Rosemont–La Petite-Patrie or elsewhere in Greater Montreal, our team is ready to support you with the same rigor.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What the unit delivers when it is cold
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).