Project

Installation of two Gree wall-mounted heat pumps in Mercier–Hochelaga-Maisonneuve

In Mercier–Hochelaga-Maisonneuve, AirGreen installed two Gree wall-mounted heat pumps on the brick facade of a duplex with an above-ground pool. Each unit now has its own heating and cooling system, providing year-round comfort and reduced energy bills.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of two Gree wall-mounted heat pumps in Mercier–Hochelaga-Maisonneuve
Installation of two Gree wall-mounted heat pumps in Mercier–Hochelaga-Maisonneuve
–chapters in this story
5 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

In this typical brick duplex in Mercier–Hochelaga-Maisonneuve , the owners wanted to make each unit comfortable year-round… without altering the already well-used backyard, complete with a deck and above-ground pool. Our AirGreen team therefore installed two Gree wall-mounted heat pumps , one for each unit, optimizing both energy efficiency and space utilization.


A backyard with a swimming pool and a brick facade

The red brick rear facade, metal balconies, and above-ground pool create a setting very representative of Montreal plexes. The constraints were clear:

  • limited floor space due to the swimming pool;

  • need to maintain good circulation around the pelvis;

  • obligation to respect electrical and mechanical safety clearances;

  • The client wished to have a clean, aligned and discreet installation on the brick wall.

We chose to install the Gree outdoor units directly on the facade, on robust and raised metal supports, in order to keep them clear of snow in winter and pool splashes in summer.


Two Gree wall-mounted heat pumps, one per dwelling

Each unit is served by its own Gree wall-mounted heat pump (single-zone mini-split system), which allows for:

  • independent temperature control for each family;

  • a better distribution of electricity costs;

  • great flexibility of use according to lifestyle habits.

We opted for capacities around 12,000 BTU per unit, an ideal size for typical medium-sized apartments in this area. The Gree wall-mounted heat pumps in this range offer:

  • a very efficient inverter compressor , which modulates its power rather than running at full speed and then stopping;

  • efficient heating even in cold weather, which is essential in Montreal's climate;

  • a quiet air conditioning mode, appreciated in bedrooms and living rooms overlooking the courtyard.


Discreet wiring and cable trays that match the brickwork

In the photo, you can see a long horizontal conduit running through the brick facade. It houses the refrigeration lines and part of the wiring for both systems. We ran it at a uniform level, below the windows, in order to:

  • minimize visual impact;

  • to facilitate possible future interventions;

  • protect the pipes from mechanical impacts and weathering.

The vertical downpipes to the outdoor units are also channeled and then neatly connected to the rear of each Gree condenser. The result: a technical installation that remains tidy and consistent with the existing architecture.


Respecting clearances around the above-ground pool

Installing two outdoor heat pumps near a swimming pool requires special attention:

  • respect safety clearances in relation to water and electrical equipment;

  • position the units high enough to limit the risk of repeated splashing;

  • ensure good air circulation around each condenser to avoid hot air recirculation in air conditioning mode.

We therefore placed the two Gree units on wall brackets at the correct height, spacing them sufficiently apart from each other and from the pool. Each condenser has ample clearance at the front and sides, ensuring optimal performance and increased compressor lifespan.


Four-season performance for every apartment

Thanks to these two Gree wall-mounted heat pumps, the occupants now benefit from:

  • efficient air conditioning in summer, even during heat waves, without resorting to noisy window units;

  • economical heating in spring, autumn and a good part of winter, greatly reducing the use of electric baseboard heaters;

  • precise temperature control in each dwelling, via remote control and programmable modes.

Gree heat pumps are designed to withstand Quebec winters: protected compressor housing, automatic defrosting, and intelligent outdoor fan speed control. Homeowners thus benefit from a profitable investment that lowers energy bills while increasing comfort and the value of their property.


A clean, planned and coordinated construction site

As with all our projects, we have:

  • planned the installation according to the availability of the occupants and the neighborhood;

  • protected the swimming pool and terrace during the works;

  • drilled holes in the walls in a targeted way to limit repairs;

  • tested each Gree system in heating and air conditioning modes before leaving the construction site.

We finally took the time to explain to the occupants the best practices: regular cleaning of the filters of the wall units, clearing of the outdoor units in winter, and modes to favor to maximize savings.


AirGreen, your Gree wall-mounted heat pump specialist in Montreal

Whether you own a multi-unit building with a pool in Mercier–Hochelaga-Maisonneuve , a duplex in Rosemont, or a condo in the Southwest, we can assist you with:

  • an analysis of your heating and air conditioning needs;

  • choosing the right Gree wall-mounted heat pump model;

  • a professional and aesthetically pleasing installation on a brick or other type of facade;

  • maintenance and after-sales service.

Our mission: to offer you four-season comfort adapted to the climate of Greater Montreal, with reliable and well-installed systems.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment