Installation of a Fujitsu RLXFZH DoubleZone Heat Pump in Verdun, Montreal
Experience the future of home comfort with our latest Fujitsu DoubleZone Heat Pump installation in Verdun—tailored efficiency, and stylish integration!
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Pioneering Heating and Cooling Installation in Verdun
In the heart of Verdun, Montreal, AirGreen has once again showcased its expertise in the field of HVAC solutions by completing an exemplary installation of the Fujitsu RLXFZH DoubleZone Heat Pump. This particular project not only enhances indoor comfort but also aligns with our commitment to energy efficiency and top-tier technology.
Premier Features of the Fujitsu RLXFZH DoubleZone Heat Pump
The Fujitsu RLXFZH model is a prime example of sophisticated HVAC technology, equipped with a dual-capacity compressor delivering a total of 36,000 BTU. This setup includes one interior unit at 12,000 BTU and another at 24,000 BTU, efficiently catering to varied heating and cooling needs across different zones within the property.
Enhanced Energy Efficiency and Comfort
This system is renowned for its 20.0 SEER efficiency, ensuring significant energy savings while maintaining optimal comfort. Certified by Energy Star® and with an AHRI number of 8908615, this heat pump is designed to perform exceptionally, even during Montreal’s severe winters, with heating capabilities down to -26°C.
The installation qualifies for the $2568 LogisVert Grant provided by Hydro-Québec, making it an economically attractive choice for homeowners looking to reduce both their carbon footprint and energy expenses.
Installation Highlights: Combining Functionality and Aesthetics
Installed in a charming residence in Verdun, this Fujitsu heat pump complements the architectural aesthetics while providing state-of-the-art climate control. The interior units are strategically placed to blend with the decor, maintaining the integrity of the home’s design while delivering unparalleled comfort.
Quick and Efficient Installation
Our team of certified technicians completed the installation swiftly, ensuring minimal disruption to the homeowners. The strategic placement of the units, combined with the sleek design of the Fujitsu model, integrates seamlessly into the living space, emphasizing functionality without compromising style.
The AirGreen Advantage
Choosing AirGreen means opting for a partner that values sustainability, efficiency, and customer satisfaction. Our installations are carried out by professionals who ensure that each setup is tailored to the specific needs of our clients, backed by a comprehensive 10-year warranty on the compressor, parts, and labor.
Why Our Clients Trust Us
- Expert Installation: Precision and attention to detail in every project.
- Customer-Centric Solutions: Tailored to meet individual comfort and efficiency needs.
- Extended Warranty: Peace of mind with a decade-long guarantee.
In Conclusion
The Fujitsu RLXFZH DoubleZone Heat Pump installation in Verdun is a testament to AirGreen’s commitment to quality and customer satisfaction. This project not only enhances the comfort and efficiency of the residence but also serves as a benchmark for modern, eco-friendly heating and cooling solutions in Montreal.
At AirGreen, we take pride in enhancing the quality of life for our clients by providing them with the best in HVAC technology and service. Trust us to bring comfort to your home, efficiently and stylishly.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).