Installation of a Sharp BU Double Zone Heat Pump in Town Mount-Royal
Discover how the Sharp BU Double Zone Heat Pump transforms home comfort with innovative features and expert installation by AirGreen.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Elevating Home Comfort with Advanced Technology
In Town Mount-Royal, a residential area known for its prestigious homes and discerning homeowners, AirGreen has recently completed an exemplary installation of the Sharp BU Double Zone Heat Pump. This installation not only exemplifies cutting-edge technology in HVAC systems but also reflects the meticulous attention to detail that AirGreen is renowned for.
The Essence of the Sharp BU Double Zone Heat Pump
The Sharp BU Double Zone Heat Pump, a model celebrated for its robust performance and innovative features, was chosen for a prestigious home in Town Mount-Royal. This system, designed to provide optimal comfort through its 24,000 BTU compressor capacity, incorporates two indoor units of 12,000 BTU and 18,000 BTU, respectively, making it exceptionally efficient in creating a balanced indoor climate.
Key Features and Innovations
- Plasmacluster Technology: This feature offers a superior air purification process by emitting positive and negative ions, effectively neutralizing airborne pathogens and allergens, which is crucial in maintaining a healthy indoor environment.
- R-32 Refrigerant: Known for its low environmental impact, this refrigerant ensures enhanced efficiency and reduced global warming potential, supporting sustainable living.
- Coanda Effect: Utilizing this natural phenomenon, the heat pump optimizes air distribution throughout the room, ensuring a uniform and comfortable environment without direct drafts.
- Self-Cleaning Function: Maintains cleanliness and efficiency in the system, prolonging its life and ensuring consistent performance.
Installation Insights: A Story of Precision and Expertise
The installation in Town Mount-Royal was not just about setting up an HVAC system; it was about integrating a solution tailored to the unique architectural elements and aesthetic needs of the home. AirGreen’s technicians demonstrated their expertise in handling the sophisticated requirements of the Double Zone Heat Pump, ensuring that the installation was seamless and the interior integrity of the home was maintained.
Challenges Overcome
- Architectural Integration: The units were installed in a manner that complemented the existing decor, maintaining the home’s elegant aesthetic.
- Custom Configuration: The system was set up to allow for dual-zone control, giving the homeowners the flexibility to adjust settings according to different room usages and personal preferences.
Benefits Delivered
- Enhanced Comfort: The dual-zone capability allows for personalized climate control across different areas of the home, ensuring comfort for all occupants.
- Energy Efficiency: With a SEER rating of 24.0, this heat pump is among the most efficient on the market, leading to considerable savings on energy bills.
- Healthy Living Environment: The advanced filtration and air purification technologies ensure that the air quality inside the home is continually optimized.
A Testament to Quality and Durability
With a 10-year warranty on the compressor, parts, and labor, coupled with the inclusion of an extended warranty, homeowners can enjoy peace of mind knowing their investment is protected. The system’s durability and reliability are further endorsed by its AHRI Certification (213927543), ensuring that it meets or exceeds industry standards for performance and energy efficiency.
Why Choose AirGreen?
Choosing AirGreen means opting for a partner who understands the value of comfort and the importance of a sustainable and healthy indoor climate. Our commitment to quality installation, backed by expert knowledge and responsive customer service, makes us the preferred choice for HVAC solutions in Montreal, Laval, Longueuil, and beyond.
Conclusion: Elevating Standards in Home Comfort
The installation of the Sharp BU Double Zone Heat Pump in Town Mount-Royal is a prime example of how advanced technology and professional expertise come together to deliver not just an HVAC system, but a comprehensive home comfort solution. It stands as a testament to AirGreen’s commitment to excellence and customer satisfaction.
The unit on this job, in figures
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp BU 24 0002 Zones (Dual Zone) | 25,000 | 21,200 | −27 °C: 14,600 | 2.3 | 24.0 | 11.5 | $3,000 |
| Sharp BU 24 0003 Zones (Triple Zone) | 25,000 | 21,200 | −27 °C: 14,600 | 2.3 | 24.0 | 11.5 | $3,000 |
Among the year’s most efficient according to ENERGY STAR, on top of its cold-climate certification.
Minimum certified capacity (NEEP): it slows down instead of stopping when a single room calls.
NEEP still lists 14,600 BTU/h at a COP of 1.84 at −17 °F.
Global warming potential of R-32, versus 2,088 for R-410A (ENERGY STAR).
Among the year’s most efficient according to ENERGY STAR, on top of its cold-climate certification.
Minimum certified capacity (NEEP): it slows down instead of stopping when a single room calls.
NEEP still lists 14,600 BTU/h at a COP of 1.84 at −17 °F.
Global warming potential of R-32, versus 2,088 for R-410A (ENERGY STAR).
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).