Installation of a Sharp BU DoubleZone Heat Pump in South Shore of Montreal
Experience next-level comfort and purity with the Sharp BU Heat Pump – where technology meets eco-conscious efficiency.
- City
- Region
- Equipment
- Brand
- Challenges
- Published
The job on one screen
The unit’s data sheet
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp BU 24 0002 Zones (Dual Zone) | 25,000 | 21,200 | −27 °C: 14,600 | 2.3 | 24.0 | 11.5 | $3,000 |
| Sharp BU 24 0003 Zones (Triple Zone) | 25,000 | 21,200 | −27 °C: 14,600 | 2.3 | 24.0 | 11.5 | $3,000 |
Among the year’s most efficient according to ENERGY STAR, on top of its cold-climate certification.
Minimum certified capacity (NEEP): it slows down instead of stopping when a single room calls.
NEEP still lists 14,600 BTU/h at a COP of 1.84 at −17 °F.
Global warming potential of R-32, versus 2,088 for R-410A (ENERGY STAR).
Among the year’s most efficient according to ENERGY STAR, on top of its cold-climate certification.
Minimum certified capacity (NEEP): it slows down instead of stopping when a single room calls.
NEEP still lists 14,600 BTU/h at a COP of 1.84 at −17 °F.
Global warming potential of R-32, versus 2,088 for R-410A (ENERGY STAR).
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
The article, chapter by chapter
The Perfect Fusion of Technology and Comfort: Sharp BU Heat Pump Installation
When it comes to enhancing the comfort of your home with high-tech HVAC solutions, the recent installation of the Sharp BU DoubleZone Heat Pump on the South Shore of Montreal by AirGreen exemplifies innovation and efficiency. Let's delve into the details of this particular project that not only promises remarkable thermal control but also demonstrates our commitment to eco-friendly practices and cutting-edge technology.
Project Overview and Installation Details
Located in the picturesque South Shore of Montreal, this installation featured the Sharp BU model, a state-of-the-art DoubleZone Heat Pump. Designed for versatility, it comprises two indoor units with capacities of 12,000 BTU and 18,000 BTU, respectively, making it an ideal solution for maintaining a balanced climate across multiple rooms.
Technical Specifications and Features:
- Model: Sharp BU
- Type: DoubleZone Heat Pump
- Energy Star® Certification: Yes
- Connectivity: WiFi Enabled
- Efficiency Rating: 24.0 SEER
- Warranty: Comprehensive 10-year warranty on compressor, parts, and labor directly from the manufacturer
- Voltage Requirement: 220V
- Noise Level: 50.0 dB(A) at the exterior unit
- Environmental Consideration: Uses R-32 refrigerant gas with lower global warming potential
- Performance: Capable of cooling down to 24,000 BTU and heating up to the challenging temperature of -27°C
- Physical Dimensions: 33.47 x 13 x 27.94 inches for the exterior unit
Enhanced Comfort with Plasmacluster Technology
One of the highlights of the Sharp BU model is its Plasmacluster Ion Technology, which offers an innovative approach to air purification. By emitting a balance of positive and negative ions, similar to those found in natural environments, it effectively neutralizes harmful microorganisms and allergens in the air. This feature is crucial for families concerned with indoor air quality and seeking relief from allergies and asthma.
Sustainable Features and Energy Efficiency
Embracing the R-32 refrigerant, this heat pump moves forward with an eco-friendly footprint. R-32 not only has a lower global warming potential but also enhances the system’s efficiency, which can be seen in reduced energy bills and a lesser environmental impact. This aligns with the $3,000 LogisVert Grant from Hydro-Québec, highlighting the unit’s energy efficiency and compliance with environmental standards.
Unique Installation Aspects
The installation process was tailored to integrate seamlessly with the existing architecture and electrical setups of the home. Special attention was given to the placement and secure mounting of both indoor and outdoor units to ensure optimal performance and minimal aesthetic disruption. The innovative Coanda Effect utilized by the heat pump aids in distributing air evenly throughout the space, enhancing the overall comfort and experience.
Why Choose AirGreen for Your HVAC Needs?
Opting for AirGreen means selecting a partner who understands the intricate balance between technology and user comfort. Our team of certified professionals ensures that every installation is executed flawlessly, with a focus on customer satisfaction and technical excellence. The Sharp BU installation on the South Shore is just one example of how we customize our solutions to meet the specific needs and preferences of our clients.
Conclusion: A Commitment to Quality and Comfort
The Sharp BU DoubleZone Heat Pump installation is a testament to AirGreen's dedication to providing superior HVAC solutions that are both effective and environmentally responsible. By choosing such advanced systems, our customers enjoy a significant improvement in their living spaces, making their homes sanctuaries of comfort and health.
The job tools
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
How the job unfolds
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What we check on a job like this one
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Good habits, once the unit is in place
Six simple habits that keep the unit going. Your list stays on this device.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
The right pages, at the right time
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
An on-site estimate, the right capacity, the right equipment.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).