Installation of a Gree Multi GEN2 TripleZone Heat Pump in Côte Saint-Luc
Discover how AirGreen installed a highly efficient Gree Multi GEN2 TripleZone Heat Pump in Côte Saint-Luc, providing exceptional heating and cooling for maximum home comfort.
- City
- Region
- Equipment
- Brand
- Challenges
- Published
The job on one screen
The article, chapter by chapter
At AirGreen, we pride ourselves on delivering top-notch HVAC solutions to our clients across Montreal, Laval, Longueuil, North Shore, and South Shore. Recently, we completed an impressive installation of a Gree Multi GEN2 TripleZone Heat Pump in Côte Saint-Luc. This project showcases our commitment to providing efficient, high-quality heating and cooling systems tailored to the specific needs of our customers.
Innovative Technology for Optimal Comfort
The Gree Multi GEN2 TripleZone Heat Pump is a cutting-edge system designed to offer superior performance in both heating and cooling. With a 36,000 BTU compressor, this model is perfect for homes that need consistent temperature regulation across multiple rooms. The installation included three 12,000 BTU indoor units, ensuring that each zone within the home could be independently controlled for maximum comfort.
Energy Efficiency at Its Best
One of the standout features of the Gree Multi GEN2 is its impressive energy efficiency. With a SEER rating of 22.0, this heat pump reduces energy consumption, leading to significant cost savings for the homeowner. Additionally, it is Energy Star® certified, which means it meets strict energy efficiency guidelines set by the U.S. Environmental Protection Agency and the Department of Energy.
Installation Details
The installation process for the Gree Multi GEN2 TripleZone Heat Pump in Côte Saint-Luc was meticulously planned and executed by our expert team. Here are some key aspects of the installation:
- Location: Côte Saint-Luc
- Machine Type: TripleZone Heat Pump
- Brand: Gree
- Model: Multi GEN2
- Compressor Size: 36,000 BTU
- Indoor Unit Size: Three 12,000 BTU units
- Eligibility for LogisVert Grant: $3,696 from Hydro-Québec
- Cooling Capacity: 36,000 BTU
- Heating Capacity: Efficient down to -30°C
- Exterior Unit Dimensions: 40.19 x 16.81 x 32.56 inches
- Serial Number (Exterior): MULTI36HP230V1EO
- WiFi: Included for convenient control
- AHRI Certification: 210278979
- Sound Pressure Level: 63.0 dB(A) for quiet operation
- Gas Type: R-410A
- Warranty: 12 years for compressor and parts
- Voltage: 220V
The Installation Journey
The homeowners in Côte Saint-Luc were seeking an efficient and reliable heating and cooling solution that could handle the harsh Quebec winters and hot summers. After consulting with our team, they chose the Gree Multi GEN2 TripleZone Heat Pump for its advanced features and robust performance.
Site Assessment and Preparation
Our first step was a thorough site assessment to determine the optimal placement of the outdoor unit and the three indoor units. The exterior unit was installed on a sturdy bracket against the brick wall, ensuring stability and proper airflow. We carefully planned the routing of refrigerant lines and electrical wiring to maintain the aesthetic appeal of the property while ensuring the system's efficiency.
Installation of Indoor Units
The three 12,000 BTU indoor units were strategically placed in different zones of the home to provide balanced temperature control. Each unit was mounted with precision, ensuring they were securely fixed and optimally positioned for maximum coverage.
Connecting and Testing
Once the units were installed, our team connected the refrigerant lines, electrical wiring, and WiFi modules. We conducted rigorous testing to ensure the system was operating correctly and efficiently. The Gree Multi GEN2's intelligent defrost and self-diagnosis features were particularly beneficial, as they reduce energy loss and quickly identify any performance issues.
Customer Satisfaction and Feedback
The homeowners were thrilled with the installation, especially appreciating the quiet operation and precise temperature control offered by the Gree Multi GEN2. They were also pleased with the energy savings and the convenience of controlling the system via WiFi.
Why Choose AirGreen?
At AirGreen, we are dedicated to providing exceptional HVAC solutions that enhance the comfort and energy efficiency of your home. Here’s why you should choose us for your next HVAC project:
- Expertise: Our team consists of highly trained professionals with extensive experience in HVAC installations.
- Quality Products: We use only the best equipment, like the Gree Multi GEN2, to ensure long-lasting performance and satisfaction.
- Customer Service: We prioritize our customers' needs and provide personalized solutions tailored to their specific requirements.
- Efficiency: Our installations are designed to maximize energy efficiency, helping you save on utility bills while reducing your carbon footprint.
Conclusion
The installation of the Gree Multi GEN2 TripleZone Heat Pump in Côte Saint-Luc is a testament to AirGreen's commitment to excellence. By choosing us, you are investing in top-quality HVAC solutions that promise comfort, efficiency, and reliability. Contact us today to learn more about how we can enhance your home's heating and cooling systems.
The job tools
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
How the job unfolds
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What we check on a job like this one
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Good habits, once the unit is in place
Six simple habits that keep the unit going. Your list stays on this device.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
The right pages, at the right time
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
An on-site estimate, the right capacity, the right equipment.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).