Installation of a Sharp ZU1 Mini Split Heat Pump in Kirkland, Montreal
Discover the difference with AirGreen’s Sharp ZU1 installation in Montreal—efficient, quiet, and perfect for harsh winters. Make comfort a priority in your home.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Embracing Efficiency and Comfort in Every Season
Nestled in the quaint suburb of Kirkland, Montreal, a remarkable transformation in home climate control unfolded with the installation of the Sharp ZU1 Mini Split Heat Pump. AirGreen, a leader in providing top-tier HVAC solutions across Montreal, Laval, Longueuil, North Shore, and South Shore, was at the helm of this installation, showcasing our commitment to enhancing indoor environments through cutting-edge technology and sustainable practices.
Why the Sharp ZU1 Stands Out
The Sharp ZU1 model, acclaimed for its 18,000 BTU cooling and heating capacities, is designed to offer unrivaled comfort even under the most demanding weather conditions. This particular installation was eligible for the generous $2,640 LogisVert Grant from Hydro-Québec, reflecting its exceptional energy efficiency and environmental friendliness. The key features of this unit include:
- Efficiency: With an impressive 24.0 SEER efficiency rating, the Sharp ZU1 is among the top performers in energy conservation.
- Advanced Refrigerant: Utilizing the eco-friendly R-32 refrigerant, it significantly lowers greenhouse gas emissions and reduces electrical consumption by about 10%.
- Extreme Weather Compatibility: Engineered to function optimally even at -27°C, ensuring reliable heating during harsh Canadian winters.
- Innovative Technologies: Incorporating Plasmacluster and Coanda airflow technologies, it offers superior air purification and even distribution of heated or cooled air.
Unique Installation Challenges and Solutions
The installation in Kirkland posed unique challenges due to the specific architectural nuances and the homeowner’s need for a discreet yet effective system. The AirGreen team meticulously planned the placement of both the interior and exterior units to optimize performance without compromising the home’s aesthetic.
- Strategic Placement: Ensuring that the outdoor unit was positioned away from common areas to minimize noise, maintaining a peaceful home environment with a sound pressure level of only 52 dB(A) for the outdoor unit and 25/49 dB(A) for the indoor unit.
- Integration with Home Aesthetics: The units were installed to blend seamlessly with the exterior and interior decor, ensuring that the technological addition did not detract from the home's charm.
The Benefits of Sharp ZU1 Installation
The benefits of installing the Sharp ZU1 Mini Split Heat Pump in this Kirkland home extend beyond simple temperature control:
- Health and Air Quality: Thanks to the Plasmacluster technology, the system provides a natural air purification process that eliminates airborne viruses, allergens, and molds, significantly enhancing indoor air quality.
- Energy Consumption Monitoring: With integrated WiFi connectivity, homeowners can track and optimize their energy usage, contributing to both cost savings and environmental sustainability.
- Long-Term Reliability: The model comes with a comprehensive 10-year warranty on the compressor, parts, and labor, ensuring peace of mind for years to come.
Customer Satisfaction and Future Outlook
The homeowner's feedback post-installation has been overwhelmingly positive. They have noted a significant improvement in home comfort levels and are particularly impressed with the system’s quiet operation and the ability to monitor and adjust settings remotely. The installation not only meets their current needs but also aligns with their environmental values, making it a worthy investment in sustainable living.
Why Choose AirGreen for Your HVAC Needs?
At AirGreen, we prioritize customer satisfaction, environmental sustainability, and technological innovation. Our team of certified professionals ensures that each installation is performed with meticulous attention to detail and tailored to the unique needs of our customers. We believe in providing solutions that are not only effective but also environmentally responsible, aligning with global standards and future regulations.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What the unit delivers when it is cold
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).