Project

Installation of a Sharp ZU1 Wall-Mounted Heat Pump in Dollard-des-Ormeaux, Montreal

Transform your home with the Sharp ZU1 Heat Pump—enjoy purified air, smart control, and unmatched energy efficiency.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a Sharp ZU1 Wall-Mounted Heat Pump in Dollard-des-Ormeaux, Montreal
Installation of a Sharp ZU1 Wall-Mounted Heat Pump in Dollard-des-Ormeaux, Montreal
–chapters in this story
3 minreading time
–type of installation
2024year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

Unveiling Superior Comfort and Efficiency

Nestled in the serene community of Dollard-des-Ormeaux, Montreal, a recent installation by AirGreen exemplifies our commitment to delivering cutting-edge climate control solutions. Our latest project involved the meticulous setup of the Sharp ZU1 Wall-Mounted Heat Pump, renowned for its robust performance and energy efficiency. This installation not only reinforces our expertise in HVAC systems but also highlights our dedication to enhancing home comfort with sustainable technology.

Project Overview and System Specifications

At the heart of this installation is the Sharp ZU1, a model celebrated for its 24,000 BTU capacity and superior energy efficiency, marked by an impressive 22.0 SEER rating. Designed to perform in the harsh Montreal climates, the ZU1 operates effectively down to -27°C, ensuring warm, comforting air through the coldest months. The system features:

  • Eco-Friendly R-32 Freon: A step ahead in environmental conservation, reducing greenhouse gases significantly.
  • Plasmacluster Ion Technology: Ensures air purification, eliminating airborne viruses and allergens, providing a healthier indoor environment.
  • Wi-Fi Connectivity: Allows homeowners to manage their heating and cooling settings remotely, adding convenience and efficiency.
  • Coanda Airflow Control: Optimizes air distribution, ensuring even temperatures throughout every room.
  • Advanced Noise Reduction: Maintains a quiet operation with sound pressure levels as low as 25 dB(A) indoors, ensuring peace and quiet.

Challenges Overcome

The installation presented unique challenges, primarily due to the structural nuances of the home in Dollard-des-Ormeaux. Our skilled technicians navigated these with precision, ensuring that the outdoor unit was placed to minimize noise and maximize efficiency, while the indoor unit was strategically positioned to leverage the Coanda effect for optimal air distribution. The result is a seamlessly integrated system that complements the aesthetics of the home while providing top-tier functionality.

Client-Centric Approach and Custom Solutions

AirGreen's approach to this installation was distinctly client-centric. Prior to installation, a detailed assessment of the home's layout and the client’s specific needs was conducted. This allowed us to customize the HVAC solution to provide maximum comfort and efficiency tailored to the unique characteristics of their space. Additionally, the integration of Wi-Fi connectivity enables the homeowner to adjust settings on the go, a feature particularly appreciated for its convenience and energy-saving potential.

Benefits Delivered

This installation not only optimized the home’s thermal comfort but also enhanced its energy efficiency, which will be reflected in lower utility bills and reduced environmental impact. The Sharp ZU1 with its high SEER rating and the innovative R-32 refrigerant offers a sustainable solution that aligns perfectly with the current eco-conscious market trends. Moreover, the system’s eligibility for the $2688 LogisVert grant by Hydro-Québec substantiates its efficiency and compliance with local energy conservation initiatives.

Sustaining Customer Satisfaction

Post-installation, our team provided comprehensive guidance on maintaining the system, ensuring long-lasting performance and efficiency. The 10-year warranty on the compressor, parts, and labor from Sharp, underscores the reliability and trust in our products and services.

Testimonials and Client Feedback

Feedback from the residents of Dollard-des-Ormeaux has been overwhelmingly positive. The homeowners praised the discreet yet powerful performance of the system, noting significant improvements in air quality and comfort within their home. Such endorsements are a testament to AirGreen's commitment to quality and customer satisfaction.

Conclusion: A Commitment to Excellence

At AirGreen, each installation is a step towards perfecting indoor living environments through sustainable and innovative climate control solutions. Our installation of the Sharp ZU1 in Dollard-des-Ormeaux is a showcase of our expertise and commitment to providing superior comfort and efficiency to our clients.

The unit

The unit on this job, in figures

The range as published on airgreen.ca: pick a size to see its capacity in deep cold.

The range, size by size
SizeHeating at −8 °CHeating at −15 °CColdest certified pointCOP at −15 °CSEERHSPFIndicative LogisVert aid
Sharp ZU1 12 00014,50012,000−27 °C: 7,2002.1122.011.0$1,740
Sharp ZU1 15 00018,10015,300−27 °C: 10,1002.124.011.0$2,172
Sharp ZU1 18 00022,00018,000−27 °C: 11,5002.224.011.0$2,640
Sharp ZU1 24 00022,40019,000−27 °C: 12,3002.222.011.0$2,688
14,500Its full nominal heating at −8 °C

According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.

7,200Still 7,200 BTU/h at −27 °C

According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.

17,100A 17,100 BTU/h reserve in mild weather

At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.

Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Before / afterThe cost of the same heat

Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):

Before · baseboards11.142¢/kWh
After · heat pump–

Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.

Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment