Installation of a Tosot LomoPlus Mini Split in Senneville
Discover seamless comfort—Tosot LomoPlus in Senneville by AirGreen, where innovation meets tranquility.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Unveiling Excellence in Climate Control: A Deep Dive into the Latest HVAC Marvel
AirGreen is proud to announce a noteworthy addition to our extensive portfolio of high-quality HVAC installations across Montreal and its surrounding regions. Our latest project in the serene town of Senneville showcases the cutting-edge Tosot LomoPlus UltraHeat 24,000 BTU Mini Split, a testament to our commitment to delivering top-tier comfort solutions.
The Heart of the Installation
Situated in a charming Senneville residence, this installation was not just about enhancing the home's climate control but also about integrating a system that speaks volumes of efficiency, reliability, and modern aesthetics. The chosen Tosot LomoPlus UltraHeat model is renowned for its robust performance, especially in the challenging extremes of the Canadian climate.
Key Features and Benefits:
- Energy Efficiency: Boasting an impressive 21.5 SEER rating, this unit is Energy Star® certified, ensuring that homeowners enjoy reduced energy consumption and lower utility bills.
- Advanced Technology: Equipped with GREE’s two-stage Inverter technology, the LomoPlus operates effectively up to 80% heating capacity even at -30°C, providing reliable warmth during the harshest winters.
- Intelligent Features: From intelligent defrost systems that only activate as needed, to memory functions that restore settings post-power outage, every aspect of the LomoPlus is designed with user convenience in mind.
- Sound Levels: With interior noise levels as low as 34 dB(A), the unit operates almost silently, ensuring it never interrupts the peaceful ambiance of your home.
Installation Specifics
The location of the installation, Senneville, is known for its picturesque landscapes and tranquil living environment. The homeowner chose the Tosot LomoPlus for its unobtrusive design that blends seamlessly with the interior décor. The system’s compact dimensions and quiet operation were crucial in maintaining the aesthetic and sonic harmony of the living space.
Installation Highlights:
- Eligibility for Grants: The installation qualified for a $1,860 LogisVert Grant by Hydro-Québec, making it not only an environmentally sound choice but also a financially savvy one.
- Professional Installation: Our skilled technicians ensured flawless installation, from strategic placement to optimal configuration, guaranteeing maximum efficiency and performance.
- Custom Configurations: Optional WiFi capabilities were included, allowing the homeowner to control the system remotely, adding a layer of convenience and modernity.
A Symphony of Comfort and Style
The Tosot LomoPlus installation in Senneville stands as a symbol of AirGreen's dedication to delivering comfort without compromise. By integrating advanced HVAC technology with thoughtful installation practices, we ensure that each client enjoys a tailored experience that enhances both their home environment and lifestyle.
Customer-Centric Approach
We understand that selecting the right HVAC system is a significant decision. Our team at AirGreen not only focuses on the technical installation but also provides comprehensive support and advice, helping clients make informed choices that truly fit their needs and preferences.
Why Choose AirGreen?
- Expertise and Reliability: With years of experience and a focus on continuous training, our professionals are equipped to handle any HVAC challenge.
- Customized Solutions: Each installation is approached with a unique perspective, tailored to the specific requirements and desires of the client.
- Guaranteed Satisfaction: We stand by the quality of our work and the performance of the systems we install, ensuring peace of mind and comfort for years to come.
Conclusion
The successful installation of the Tosot LomoPlus UltraHeat Mini Split in Senneville is more than just a testament to AirGreen’s expertise. It is a commitment to enhancing the quality of life for our clients through innovative, efficient, and reliable climate control solutions. For those seeking a blend of top-tier technology, aesthetic integration, and environmental consciousness, AirGreen remains your trusted partner in providing HVAC solutions that not only meet but exceed expectations.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).