Humidistat HONEYWELL HumidiPRO H6062A1000/U | Montreal, Laval, Longueuil, South Shore & North Shore
Every winter, two situations come up again and again in Québec homes.
Quick facts
Every winter, two situations come up again and again in Québec homes. At the start of the cold season, the air gets dry: irritated throat, static electricity, hardwood floors that shrink. Then, during a deep freeze, condensation or frost appears at the bottom of the windows because indoor humidity is too high for the outdoor temperature. The Honeywell HumidiPRO H6062A1000/U is a digital humidistat designed to handle both. It controls central humidifiers and dehumidifiers, and it automatically adjusts the humidity level based on the outdoor temperature.
Humidity matched to the season
Outdoor compensation, the key to protecting windows
The HumidiPRO comes with an outdoor temperature sensor. In automatic mode, it uses this reading to adjust the indoor humidity setpoint: the colder it is outside, the lower the setpoint goes, to limit condensation on the glass. This outdoor temperature compensation (window protection) works within a range of 10 to 60% RH. You don't have to change the setpoint every time the weather changes: the unit takes care of it. Automatic outdoor sensor detection makes start-up easier.
Humidify or dehumidify, in manual mode
For those who prefer to choose for themselves, manual mode lets you set humidification and dehumidification between 10 and 90% RH. In summer, the unit can therefore control a central dehumidifier to keep the basement or the whole house at a comfortable level. Dehumidifier compressor protection prevents restarts that are too close together, which is easier on the equipment.
Installer settings
The HumidiPRO offers relative humidity and outdoor temperature calibration, adjustable high and low setting limits and a 4 to 6% RH differential. These settings let our technicians adapt the unit to your home, your windows and your equipment, then limit the range the occupants can select.
An easy-to-read display
The large backlit digital screen clearly shows the humidity level and the setpoint. Intuitive programming makes the settings accessible without a manual. The 86 x 114 x 33 mm housing, in Premier White, stays discreet.
Installation and everyday use
The HumidiPRO runs on 24 VAC, 50/60 Hz. It mounts on the wall, in a living area, or on the return duct, near the equipment. Wall mounting makes it easy to check and adjust the humidity level; duct mounting suits those who prefer to keep the controls together in the mechanical room. The choice depends on your home and your preferences.
During an AirGreen installation, our technicians:
- check the central humidifier or dehumidifier and its 24 VAC connection;
- choose the location of the HumidiPRO: wall or return duct;
- install the outdoor sensor on a shaded wall, away from heat sources;
- connect everything and confirm that the outdoor sensor is detected;
- calibrate the readings if needed and set the limits and differential;
- explain the automatic and manual modes to you.
The HumidiPRO can be installed with a new humidifier just as well as to replace an old mechanical humidistat. In the latter case, the difference is often clear: the old rotary knob was rarely readjusted over the winter, whereas the HumidiPRO adapts on its own.
Who it's for
This control suits homes with a central humidifier connected to a furnace or forced-air system, homes with a central dehumidifier, and those that have both. It's especially relevant for owners of well-insulated homes and newer, more airtight construction, where indoor humidity varies more.
The HumidiPRO is a standalone control, independent of the thermostat. So it works just as well in a home heated by a forced-air furnace as with a dual energy system with a central heat pump, as long as the central humidifier or dehumidifier is controlled at 24 VAC. Your current thermostat stays in place, and humidity control becomes more precise without changing your heating habits.
Comfort and savings
Properly humidified air feels warmer. At the same temperature, you feel better in a home with balanced humidity than in a very dry one, which often lets you get by with a more moderate heating setpoint. By protecting windows from condensation, the HumidiPRO also helps preserve frames, sills and interior finishes over the winter. In summer, dehumidification adds to comfort and takes some load off the air conditioning.
Maintenance
The HumidiPRO needs no special maintenance: just dust the housing from time to time. The humidifier, on the other hand, does need maintenance: replace the evaporator pad every season and check the drain. For a dehumidifier, clean the filter and check the drainage. We can include these checks in your system's annual maintenance.
Technical specifications
- Type: digital humidistat for central humidifiers and dehumidifiers
- Automatic mode: humidification with outdoor compensation (window protection), 10 to 60% RH
- Manual mode: humidification and dehumidification, 10 to 90% RH
- Differential: 4 to 6% RH
- Power: 24 VAC, 50/60 Hz
- Display: large backlit digital screen
- Sensors: built-in relative humidity sensor; outdoor temperature sensor (included), automatic detection
- Functions: dehumidifier compressor protection, RH and outdoor temperature calibration, adjustable high and low limits, intuitive programming
- Mounting: wall or return duct
- Dimensions: 86 x 114 x 33 mm (3 7/16 x 4 1/2 x 1 5/16 in.)
- Colour: Premier White
- Contents: HumidiPRO control, outdoor sensor, mounting hardware
Why AirGreen
AirGreen is a family HVAC business, holding an RBQ licence, that has been installing heating, cooling, humidification and ventilation systems in the Montréal area for more than 15 years. We know the challenges of a Québec winter, from the dry air of December to the frosted windows of February. Our Boucherville showroom is open to you.
For the sale and professional installation of the Honeywell HumidiPRO H6062A1000/U, contact AirGreen. We serve Montréal, Laval, Longueuil, the North Shore and the South Shore.
Key facts: HONEYWELL HumidiPRO H6062A1000/U
Four things to know, then its ID card in twelve answers. “—” means the manufacturer does not publish it.
The HONEYWELL HumidiPRO H6062A1000/U or its closest sibling?
The most useful comparison: the model right next to it in our catalogue.
Installed and set up by our technicians, in five steps
What we do at your place, in order. The on-site estimate is free.
- 01CompatibilityExisting system and thermostat checked before ordering.
- 02MountingInstalled in the most representative spot.
- 03ConnectionWiring or wireless pairing, depending on the model.
- 04SettingsSet-up in the thermostat or the app.
- 05TestOperation checked with you.
HONEYWELL HumidiPRO H6062A1000/U specifications
From the manufacturer’s sheet. Type a word: the list filters as you write.
No line matches. Try another word.
Frequently asked questions about the HONEYWELL HumidiPRO H6062A1000/U
Short answers, no detours.
What is the warranty?
1 year, per the manufacturer’s information.
Does AirGreen install it?
Yes. We sell and install this product in Montréal, Laval, Longueuil, the South Shore and the North Shore. The on-site estimate is free.
No question matches. Call us at 514 316-2973.
Your thermostat, installed and set up by our technicians
We check your system and wiring, install the thermostat, connect it and program it with you. One visit, one installed price.
