Installation of an Elios Moovair (R-32 range) wall-mounted heat pump in Côte-des-Neiges–Notre-Dame-de-Grâce
AirGreen installs a Moovair wall-mounted heat pump (R-32) in NDG: 12,000 BTU, condensate pump , discreet capping, rigorous commissioning. Four-season comfort and energy savings, serving Greater Montreal .

Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Four-season comfort in an urban NDG living room: a compact, elegant installation ready for Montreal winters
Client context and objectives
At AirGreen , we are working on a renovated apartment in Côte-des-Neiges–Notre-Dame-de-Grâce . The owner wanted a discreet HVAC solution to cool the living room in the summer and support the heating in the off-season, without major renovations or wasted space. Priorities: silence , efficiency , aesthetics , and reliability in extreme cold.
We offer a wall-mounted Elios Moovair heat pump (R-32 range) , 12,000 BTU configuration - sized after a simplified load calculation (surface area, orientation, insulation, internal inputs). This capacity typically covers 400 to 600 sq. ft. in an open living area, with a comfortable margin for peaks.
Why the Moovair (R-32) range meets the need
-
R-32 refrigerant : better seasonal efficiency than R-410A and reduced charge for the same power.
-
Seasonal efficiency : Competitive SEER/SCOP, ideal for reducing annual consumption.
-
Operation in cold weather : maintaining useful capacity around −25°C , essential for Montreal , Laval , Longueuil , North Shore and South Shore .
-
Acoustics : very low interior noise level, suitable for open living spaces and terraced apartments.
-
Design : minimalist facade integrated into the decor; compact size above the wall elements.
Key words : heat pump , wall-mounted air conditioner , HVAC installation , HVAC maintenance , Montreal , Laval , Longueuil , North Shore , South Shore .
Installation process — clean, fast, controlled
Preparation and tracing
We validate the location at height (~2.20 m) for optimal air diffusion above the furniture and away from heat sources. The installation template is fixed with a laser; we identify the shortest cross to the outside and the route of the connections.
Drilling and passing lines
-
Wall crossing to the required diameter with controlled negative angle.
-
Installation of insulated refrigerant connections, communication cable, and power supply.
-
Discreet white capping near the outlet for a neat finish and easy maintenance.
Condensate management: compact and quiet pump
Since gravity drainage is not possible (horizontal path imposed by the architecture), we install a condensate pump under the interior head. Advantages:
-
No visible gutters and no additional drilling in the baseboard;
-
Safety (level sensor with safety stop);
-
Easy maintenance (accessible hatch).
Connection, vacuuming and commissioning
-
Calibrated flares and tightening torques respected;
-
Deep vacuum with micronmeter until stable;
-
Leak check and R-32 refrigerant charge according to actual length;
-
Settings: blowing mode, sweeping , and set temperature;
-
Measurements of blowing temperature, intensity, and delta T under load.
Aesthetic result and thermal comfort
The wall head integrates into the decor (frames, wall light). The wiring is contained; the condensate box remains compact and harmonized. In use:
-
Responsive and homogeneous cooling of the living room in summer;
-
Efficient additional heating in autumn and spring;
-
Low noise level , ideal for teleworking and home cinema.
Sizing tips for similar spaces
-
9,000 BTU : Well-insulated bedrooms/offices up to 350 sq. ft.
-
12,000 BTU : Living rooms 400–600 sq ft, open plan.
-
18,000 BTU and up : large open areas, high ceilings or multiple doors.
A load calculation by our advisors remains the reference to avoid over-sizing (short cycles, discomfort) or under-sizing (noise, wear).
Technical points to remember about this pose
-
Controlled working height , clearances respected for air intake and maintenance.
-
Short link length (better efficiency).
-
Discreet path via capping and ceiling; no visual impact.
-
Condensate pump with high level cut-off to prevent any risk of flow.
-
Dedicated power supply and compliant protections.
HVAC Maintenance: The Key to Performance
To maintain performance and longevity:
-
Filters : clean every 4 to 8 weeks during the season.
-
Evaporator battery : gentle dusting; avoid corrosive products.
-
Condensate pump : check the tank and float at the start of summer.
-
Outdoor unit (if accessible): minimum clearance of 30 cm, cleaning of the fins.
-
Annual AirGreen inspection : pressure/consumption check, condensate test, electrical check.
Regular HVAC maintenance reduces consumption by up to 10–15% and extends equipment life.
Energy subsidies and savings
Depending on the Energy Star configuration and performance at −25°C , a wall-mounted heat pump like the Moovair (R-32) may be eligible for assistance in effect in Quebec (municipal/provincial programs). We support our customers in:
-
Check eligibility;
-
Prepare evidence (model, serial numbers, photos);
-
Optimize the usage strategy (stable setpoint, automatic ventilation, seasonal programming).
Common Mistakes to Avoid (and How We Prevent Them)
-
Installation too low → air recirculation and discomfort: we respect the manufacturer's clearances.
-
Improvised gravity drain without slope → risk of infiltration: here, pump sized and tested.
-
Connections too long → loss of capacity: layout designed for compactness .
-
Absence of controlled vacuum → humidity in the circuit: we aim for a deep vacuum measured with a micron meter.
What the customer actually gains
-
Immediate summer/winter comfort in the living area.
-
Lower bills compared to traditional air conditioning and electric baseboard heaters.
-
Real estate value : modern, aesthetic, and sought-after equipment in NDG.
-
Peace of mind : guaranteed AirGreen installation and local after-sales service.
What if your project is different?
We cover Montreal , Laval , Longueuil , North Shore and South Shore for various needs: apartments, plexes, houses, offices. Depending on the configuration, we also offer multi-zone , ceiling cassettes , or central systems (R-32/R-454B) when relevant.
Technical sheet — NDG installation (summary)
-
Type : single-zone wall-mounted heat pump
-
Brand : Elios Moovair (R-32)
-
Installed capacity : 12,000 BTU
-
Condensate management : compact pump under the head
-
Finish : minimalist white capping , ceiling path
-
Installation height : ~2.20 m
-
Commissioning : deep vacuum, leak tests, delta T measurements
Your project with AirGreen
We combine thermal diagnostics , grant advice , high-quality HVAC installation and maintenance for lasting comfort. Let's talk about your space: a technical visit is enough to validate the BTU capacity , the routing of the lines , and the safest drainage strategy .
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
