Project

Installation of a GREE Livo wall-mounted heat pump in Rosemont–La Petite-Patrie

Installation of a GREE Livo R32 wall-mounted heat pump in Rosemont by AirGreen. Four-season comfort, performance down to -25°C, and discreet installation in a typical Montreal duplex.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a GREE Livo wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a GREE Livo wall-mounted heat pump in Rosemont–La Petite-Patrie
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

An elegant and efficient solution for four-season comfort in a typical Montreal duplex

In this charming duplex in Rosemont–La Petite-Patrie , our technicians installed a GREE Livo R32 wall-mounted heat pump , a model renowned for its energy efficiency and proven reliability in Montreal's climate. The goal of this project: to offer our customers optimal comfort, summer and winter, while reducing their energy consumption.

An installation perfectly integrated into the interior environment

The interior head, carefully installed in a main room on the central wall, ensures even air distribution . The precise positioning, at an ideal height below the ceiling, allows for a smooth airflow without hindering circulation. The refrigerant pipes were discreetly routed through the wall, then protected on the outside by white capping to match the facade , ensuring a clean and durable finish.

Model choice: GREE Livo R32, a modernized classic

GREE's Livo R32 model is one of the most popular lines for Montreal homes. Its high efficiency down to -25°C , its inverter technology and its R-32 refrigerant fluid guarantee stable, quiet and environmentally friendly performance. Available in capacities from 9,000 to 24,000 BTU, the Livo line adapts to all residential volumes, whether it is a condo, a duplex or a single-family home.

Technical details and installation steps

  1. Site analysis : Our experts checked the insulation, furniture layout and access to determine the optimal location for the interior head.

  2. Drilling and installation : the passage of the exterior wall was carried out with a gravity drainage angle to avoid any accumulation of water.

  3. Refrigeration and electrical connection : the connections were run over a short distance, limiting pressure losses and optimizing efficiency.

  4. Commissioning and calibration : after a leak and pressure test , we started the heat pump and checked the blowing temperature, humidity level and noise level.

Energy subsidies and savings

Thanks to its Energy Star certification, the GREE Livo R32 is eligible for Quebec grant programs , including Rénoclimat and Chauffez vert , which encourage the replacement of old electric or oil heating systems. This installation will allow our customers to reduce their annual energy costs by 30 to 40% while enjoying constant comfort.

An installation by AirGreen: expertise, precision and aesthetics

At AirGreen, we pride ourselves on delivering neat, durable, and aesthetically pleasing installations. The Rosemont project perfectly illustrates our approach: combining technical excellence , visual discretion , and personalized support . Each installation is preceded by a thorough study and followed by a complete demonstration to ensure optimal use of the system.


Why choose AirGreen for your GREE heat pump installation in Montreal?

  • Local expertise : hundreds of successful installations in the greater Montreal, Laval and Longueuil areas.

  • Certified technicians : trained in the latest R-32 technologies and Quebec electrical standards.

  • Exemplary after-sales service : full warranty and annual maintenance available.

  • Grant support : we help our clients maximize their savings through current government programs.


Conclusion: Smart comfort for all seasons

This installation of a GREE Livo wall-mounted heat pump in Rosemont once again demonstrates AirGreen's ability to offer HVAC solutions that are energy-efficient, quiet, and sustainable . Thanks to R-32 technology and our expertise in residential installation, our customers now benefit from consistent indoor comfort, regardless of the season.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment