Installation of a Sharp Eco Inverter wall-mounted heat pump in LaSalle
AirGreen installed a Sharp Eco Inverter wall-mounted heat pump in LaSalle. A powerful and discreet HVAC solution for heating and cooling, suitable for homes in Greater Montreal.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
An energy efficiency project perfectly integrated into a LaSalle pavilion
At AirGreen , we recently completed a Sharp Eco Inverter wall-mounted heat pump installation in a residential area of LaSalle , on the island of Montreal. This project perfectly illustrates the combination of increased comfort, energy savings, and careful integration into the environment of a typical pavilion in the area.
Why choose a Sharp Eco Inverter heat pump?
The client wanted to replace an aging wall-mounted air conditioner with a more efficient, four-season solution. After a thorough needs analysis, we recommended the Sharp Eco Inverter :
-
Heating and air conditioning capacity : adapted to the ground floor area of the bungalow (approximately 1,100 sq. ft.).
-
Inverter technology : fine power regulation, reduced consumption and quiet operation.
-
Plasmacluster System : Improves indoor air quality through advanced ionization.
-
Compatibility with grant programs : eligible for energy incentives offered to residents of Montreal, Laval, Longueuil, as well as the North Shore and the South Shore.
Technical details of the installation
The installation was carefully planned to minimize visual impact and optimize system performance. Here are the main steps and specific features:
-
Raised outdoor stand : The compressor has been installed on a sturdy aluminum base, ensuring protection against moisture and snow.
-
Refrigerant pipes : hidden under a discreet white cover, providing a clean and aesthetic finish on the side facade of the house.
-
Gravity drainage : the condensate system has been configured for natural flow, avoiding the need for an additional pump.
-
Proximity to the electrical panel : the power supply has been connected directly, limiting load losses and improving reliability.
-
Limited working at height : the outdoor unit has been fixed at a safe height, sufficient to clear the fan from the ground and respect ventilation clearances.
Challenges and solutions on the construction site
As is often the case with homes built decades ago in LaSalle, we encountered fragile wall plaster. To prevent further cracking during drilling, we used specialized drill bits and sealed the pipe passages with a high-performance sealant. This ensures optimal insulation and increased durability, even in the face of the freeze-thaw cycles typical of Montreal's climate.
Benefits for the customer
Thanks to this new Sharp Eco Inverter heat pump , the owner now benefits from:
-
Stable comfort, summer and winter, in his LaSalle pavilion.
-
Significant energy savings thanks to automatic power modulation.
-
Healthier indoor air, enhanced by Plasmacluster technology.
-
A discreet, solid installation designed to last.
AirGreen: local HVAC expertise
Each installation we carry out in Greater Montreal is adapted to the specific requirements of the building and the client's expectations. Whether in Montreal , Laval , Longueuil , on the North Shore or the South Shore , our teams ensure that each project meets the highest quality standards, in terms of energy performance and aesthetics.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
