Project

Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie

In Rosemont–La Petite-Patrie, AirGreen installed a Sharp Eco Inverter wall-mounted heat pump on a brick facade, with raised wall brackets and discreetly integrated piping, next to an electric vehicle charging station. A clean, efficient solution perfectly suited to Montreal's climate.

By AirGreen Climatisation & Chauffage Admin6 min read
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
–chapters in this story
6 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

In this project in Rosemont–La Petite-Patrie , our AirGreen team was called in to modernize the comfort of a typical Montreal brick house. The homeowner wanted an efficient, discreet heating and cooling solution that would fit with his already energy-conscious lifestyle – as you can see in the photo, an electric vehicle charging station is installed nearby.

We recommended and installed a Sharp Eco Inverter wall-mounted heat pump , from the same family as the Sharp ZU1 series, known for its reliability, performance in cold climates and optimized electricity consumption.


Context: a brick house in Rosemont–La Petite-Patrie

The building is a red brick duplex/triplex , very representative of the residential landscape of Rosemont–La Petite-Patrie. The client's main challenges:

  • Making the house comfortable both during summer heatwaves and during the first autumn cold spells ;

  • Reduce reliance on existing heating to lower energy bills;

  • Maintain a clean and tidy facade , without massive installations or visible conduits.

The Sharp wall-mounted heat pump perfectly meets these requirements, combining visual discretion , energy efficiency and four-season versatility .


Choosing the Sharp Eco Inverter wall-mounted heat pump (type ZU1)

For this project, we opted for a Sharp Eco Inverter wall-mounted heat pump , with power adapted to the needs of the main living area (in the 12,000 BTU range, comparable to a Sharp ZU1 ).

Why the Sharp brand for this residence?

  • Inverter technology : the compressor continuously modulates its power, which avoids frequent on/off cycles, reduces consumption and increases the machine's lifespan.

  • Heating performance : ideal for mid-season and milder winter days, the heat pump relieves the main heating system.

  • Quiet operation : a crucial point in urban residential environments, both for the occupants and for the neighbors.

  • Air quality : the presence of Ion Plasmacluster technology (visible on the unit's label) allows for better filtration and treatment of indoor air for a healthier environment.

This combination makes the Sharp Eco Inverter a solution perfectly suited to the needs of a Rosemont–La Petite-Patrie homeowner seeking to combine comfort, efficiency and respect for the environment.


Details of the outdoor installation: stability, protection and aesthetics

The photo clearly shows the Sharp condenser attached to the brick wall, slightly raised above the ground.

1. Elevated wall installation

We installed the condenser:

  • On sturdy wall brackets , sized to support the weight of the unit over time;

  • At a height that protects it from the accumulation of snow, ice and dirt, while also facilitating access for maintenance;

  • With anti-vibration pads and anchors , in order to limit the transmission of vibrations in the structure of the house.

This configuration ensures excellent stability and minimizes perceived noise inside.

2. Discreet management of pipes and cables

The refrigeration lines , power cable, and condensation drain were:

  • Assembled behind a vertical protective cover coordinated with the color of the facade (the visible brown column);

  • Transported in an orderly and safe manner, avoiding excessively tight angles and respecting the recommendations of the manufacturer Sharp;

  • Connected to the indoor unit located upstairs, while limiting the visual impact on the facade.

The result: a clean installation that blends harmoniously with the brickwork , with no visible cables or exposed pipes.

3. Coexistence with the electric charging station

To the left of the Sharp unit, an electric vehicle charging station is visible. It was essential to:

  • Respect the necessary electrical clearances around the terminal;

  • Position the heat pump so as not to interfere with the daily use of the refill;

  • Protect existing cables and junction boxes.

Our technicians therefore coordinated the installation of the Sharp condenser and the presence of the terminal to offer a functional, safe and aesthetic space.


Indoor comfort: air conditioning and heating adapted to the Montreal climate

Once the Sharp outdoor unit was installed, we put the indoor wall head (not visible in the photo) into service, ideally placed to cover the main living area.

In air conditioning mode

In summer, the Sharp wall-mounted heat pump allows you to:

  • To quickly cool down rooms even during Montreal heat waves;

  • To maintain a stable temperature thanks to Inverter modulation;

  • Dehumidifying the air greatly improves the feeling of comfort.

Residents thus benefit from a cool and pleasant environment, without aggressive drafts or sudden temperature changes.

In heating mode

During the autumn and spring, the Sharp Eco Inverter takes over to:

  • To provide economical supplementary heating , reducing the need for the main heating system;

  • To provide uniform comfort in the covered area, without cold zones;

  • Contributing to a reduction in energy bills , which is particularly important given the rise in energy costs.

In winter, it effectively complements the existing system on milder days, thus optimizing overall energy use.


An installation by AirGreen: safety, cleanliness and monitoring

At AirGreen, every project is custom-designed. For this Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie, we have:

  • Checked the available electrical capacity , particularly in the presence of the charging station;

  • Sized and fixed the wall brackets while respecting the masonry structure;

  • Perform a complete evacuation of the refrigeration circuit before charging it with the appropriate gas, according to Sharp specifications;

  • Performed the functional, pressure and leak tests;

  • Guided the customer on the use of the remote control, operating modes and proper maintenance practices.

We also recommend regular maintenance (filter cleaning, external inspection, parameter checks) to maintain the high level of performance of the Sharp wall-mounted heat pump and extend its lifespan.


Conclusion: A Sharp heat pump perfectly integrated into Rosemont–La Petite-Patrie

This Sharp Eco Inverter wall-mounted heat pump installation demonstrates how it is possible to combine:

  • Four-season comfort ;

  • Energy efficiency ;

  • Respect for the aesthetics of a typical brick house in Rosemont–La Petite-Patrie;

  • And harmonious coexistence with other equipment such as an electric charging station.

If you live in Rosemont–La Petite-Patrie or elsewhere in Greater Montreal and are considering installing a Sharp wall-mounted heat pump , our AirGreen team is here to assist you – from analyzing your needs to commissioning and after-sales service.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment