Project

Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie

AirGreen installs a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie: short cooling path, gravity drain, and discreet finish. An HVAC system designed for four-season comfort and efficiency.

By AirGreen Climatisation & Chauffage Admin8 min read
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
–chapters in this story
8 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

An intervention designed for immediate comfort, seasonal efficiency and aesthetic discretion

Client context and objectives

In a bright apartment in the Rosemont–La Petite-Patrie neighborhood, our team is installing aSharp wall-mounted heat pump to provide four-season heating and cooling . The client wanted:

  • a quiet and efficient device under low load for summer nights;

  • stable additional heating during cold spells;

  • discreet integration on a white wall without visible cables;

  • easy maintenance and quick filter access.

We are working in a home with standard ceilings. The interior head is positioned at the top, with sufficient clearance under the ceiling to optimize air intake and blowing range.

Why the Sharp wall-mounted heat pump here?

The new generation Sharp ranges (R-32 refrigerant) focus on:

  • flexible inverter compressors in modulation;

  • management electronics which limit overconsumption in mid-season;

  • high-density exchangers promoting efficiency at low temperatures;

  • intuitive front maintenance (removable pre-filter, controlled card access).

For a typical Montreal apartment, this approach balances acoustic comfort , seasonality , and operating costs . The brand also offers compatible multi-zone options if you want to upgrade to a second unit later.

Sizing and layout: precision before drilling

The choice of BTU/h capacity is based on three factors: actual surface area and volume, solar exposure, and insulation level. Here, the open living space requires a central supply line to supply the adjacent area (kitchen/hallway). We consider:

  • High installation , clear of approximately 6–8 cm below the ceiling to avoid the “air cushion” effect;

  • Minimum horizontal distance to the outer wall (short refrigeration path to reduce losses and load drops);

  • Standard working height allowing safe maintenance without dismantling furniture.

This configuration increases controlled stratification in heating (warm blown air which gradually descends) and extends the range in air conditioning.

Refrigeration path and condensate management

The layout uses a single bore through the exterior wall behind the head, to maintain an interior without visible capping . Outside, the lines are protected by UV-treated, facade-colored trunking . Condensate drainage operates by gravity , which simplifies operation and eliminates the noise or maintenance of an additional pump. When the minimum gradient is not achievable, we offer a quiet compact pump; here, the configuration allows for direct gravity, therefore less maintenance.

Electricity and protection

The heat pump is connected to a dedicated circuit breaker with an external safety circuit breaker (disconnector), in accordance with current standards. We check:

  • cable gauge and size according to the nominal intensity of the group;

  • grounding and polarity;

  • acceptable voltage drop for the effective length;

  • cleared service point for future maintenance.

Refrigeration quality: the steps that make the difference

A sustainable HVAC installation relies on rigor invisible to the naked eye:

  1. Calibrated flares : tightening torque respected to avoid micro-leaks.

  2. Deep vacuum (≤ 500 microns) with lift control; this step improves compressor longevity.

  3. Nitrogen leak test before vacuuming.

  4. Fluid release and functional test in cold and hot mode.

  5. Measurements : supply/return temperature, absorbed current, and internal static pressure to check free air circulation.

Finish and discretion

Inside, the wall remains clean : no visible pipes, careful horizontal alignment, and uniform distance from the ceiling. The Sharp unit, with its clean lines, fits the decor without weighing down the room. Outside, the matching trunking avoids direct exposure of the insulation and guarantees durability against the freeze/thaw cycles typical of Montreal and the North Shore/South Shore .

Real comfort: what the customer feels

  • Air conditioning : the shutter directs a laminar flow over the living area. At half power, the unit remains very quiet , perfect for nighttime use.

  • Heating : Sharp defrost algorithm limits interruptions; the warm feeling is regular, without “yo-yo”.

  • Air quality : the filters are removed from the front; we explain to the customer a simple monthly HVAC maintenance (vacuum and rinse).

Grants and Eligibility

Some high-performance R-32 wall-mounted heat pumps may be eligible for Quebec programs (depending on the exact model, efficiency, and low-temperature operating range). During the technical visit, we confirm the presence of required certifications and provide, where applicable, the documentary support necessary for the aid application. Our team monitors the evolution of the criteria in order to recommend an optimized solution for Montreal, Laval, Longueuil, the North Shore, and the South Shore .

Preventive maintenance: the recipe for lasting performance

To preserve seasonal yield :

  • Clean the pre-filters every 4–6 weeks during peak periods.

  • Keep one meter clear in front of the indoor unit.

  • Outdoors, ensure a clearance of 30–60 cm around the condenser; in winter, prevent snow accumulation.

  • Schedule annual HVAC maintenance (inspection, pressures, coil cleaning, electrical check).

Regular maintenance prevents compressor overload, reduces consumption and extends the life of the equipment.

Salient technical details of this installation

  • Type : wall-mounted heat pump ( mini-split ).

  • Brand : Sharp (R-32 generation).

  • Layout : interior load-bearing wall, uniform clearance under ceiling.

  • Route : direct crossing to the outside, short lines protected by UV ducting.

  • Condensate : gravity (controlled slope).

  • Tests : deep vacuum, leak test, dual hot/cold commissioning.

Common Pitfalls to Avoid (and How We Get Around Them)

  • Drilling too low : creates “elbows” and distorts the drain slope; we place the template and check before drilling.

  • Unnecessary refrigeration length : reduced efficiency; we optimize the positioning to keep it as short as possible.

  • Insufficient clearance under the ceiling : recycles hot air; we respect a minimum clearance to ensure the range.

  • Non-dedicated wiring : triggers; we provide a compliant dedicated circuit .

  • No micron tests : invisible on the day but costly later; controlled vacuum is systematic at AirGreen.

Result: immediate comfort and predictable savings

Upon switching on, the room quickly reaches the set temperature with a low noise level. In summer, fine modulation prevents short cycles; in winter, the electrical backup is less used, which reduces the energy bill. The installation meets the customer's specifications : visual sobriety , efficiency , and ease of maintenance - the DNA of AirGreen.

And after?

We support the client with:

  • an annual maintenance reminder ;

  • season-by-season usage advice ;

  • the ability to add a second head if a remote room proves difficult to temper.

For residential projects in Montreal, Laval, Longueuil, on the North Shore and the South Shore , our team offers a clear quote, rapid planning , and execution in accordance with best practices.


Frequently Asked Questions (excerpt)

Does the Sharp heat pump heat in very cold weather?
Recent R-32 ranges maintain good performance at low temperatures depending on the specific model. We validate this range during selection to ensure comfort in cold weather.

Is an annual maintenance really necessary?
Yes. Dirty coils and saturated filters increase consumption and reduce lifespan. Annual HVAC maintenance ensures efficiency.

Can we add a second room later?
Depending on the external compressor and the series chosen, a multi-zone upgrade is possible. We check compatibility before the initial choice to avoid any limitations.


The AirGreen commitment

At AirGreen , we combine accurate diagnosis , careful installation , and after-sales support . The result: a Sharp wall-mounted heat pump that blends into your home, reduces your energy costs, and significantly improves your daily comfort —now and for winters to come.

Natural keywords: heat pump , wall-mounted heat pump , HVAC installation , HVAC maintenance , Montreal , Laval , Longueuil , North Shore , South Shore .

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment