Installation of a Sharp wall-mounted heat pump in Saint-Laurent
Saint-Laurent — Installation of a Sharp wall-mounted heat pump above a patio door: short cooling path, gravity drain, and clean finish for four-season comfort. AirGreen HVAC installation service.

In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Four-season comfort for a condo with patio door and balcony
In the Saint-Laurent district, we are installing a Sharp wall-mounted heat pump in a condo with a balcony . The indoor unit is positioned above a sliding patio door , a common configuration in modern buildings. Our goal: to provide precise, quiet, and energy-efficient heating and cooling without compromising brightness or access to the balcony.
Client context and needs
The owner wanted:
-
Stabilize the temperature of the living room facing outwards, subject to solar gains in summer and losses through glazing in winter .
-
Reduce operating costs compared to basic electric heating.
-
Preserve the aesthetics of the main wall and the ergonomics of opening the patio door.
After calculating the thermal loads and checking the electrical panel, we selected a Sharp wall-mounted heat pump with a power suitable for an open living area (living room/dining room/kitchen). The equipment chosen is a recent R-32 model from the Sharp residential range, compatible with extreme cold and Inverter .
Interior installation: above the patio door, optimal diffusion
Placing the unit at the top of the wall , centered on the bay window, promotes:
-
reduced heat stratification in winter thanks to vertical sweeping;
-
an effective air barrier in front of the glass surface during heat peaks;
-
even circulation in the room, without direct blowing onto the occupants.
We adjust the vanes for a wide sweep and program an automatic speed to adjust the flow to the actual need, limiting ambient noise.
Refrigeration path and condensate evacuation
The vertical technical cover runs along the right upright of the patio door: it protects the insulated copper piping , the power/communication cable and the condensate drain . The route is deliberately short (≈1.5 to 2 m) to limit pressure losses and maximize efficiency.
Drainage is by gravity towards the outside, with a constant slope and anti-drip nozzle; we install a vapor barrier at the wall passage to prevent any migration of humidity into the insulation.
Drilling, sealing and finishing
We make a single hole as close as possible to the equipment, respecting the slope of the drain. The crossing is lined with a sleeve , an elastomeric sealant on the inside and a clean collar . On the outside, the capping is UV-stable and resistant to freeze-thaw to maintain its appearance throughout the seasons.
Outdoor installation on balcony
In most condominiums with balconies, the best practice is to install the condenser :
-
on anti-vibration pads to prevent the transmission of low frequencies to the slab;
-
with sufficient rear clearance for air intake;
-
out of the snow removal path and protected from falling ice from the upper floor.
We add a discreet snow shear when the balcony's orientation exposes the unit to snow accumulation. A watertight disconnect is installed nearby, and the dedicated line is calibrated according to the inverter's starting currents.
Sizing and expected performance
The choice of power is based on:
-
the open area (living room + dining room),
-
the U-value of the glazing,
-
infiltration via the patio door,
-
the orientation and the presence of trees/hedges which cushion the winter wind.
The machine maintains a high COP at low temperatures and provides heating down to -25°C (or even -30°C depending on the sub-range) . In air conditioning, the dehumidification mode maintains a comfortable humidity level without overcooling.
Noise, vibrations and acoustic comfort
In addition to anti-vibration pads, we configure:
-
Night Silent mode ,
-
progressive scanning to avoid flow rate jolts,
-
a ventilation curve adapted to evenings on the balcony (reduction of direct airflow towards the opening).
Result: a very low interior noise level , compatible with teleworking and quiet evenings.
Control and usage scenarios
The supplied infrared controller is supplemented, if necessary, by a Wi-Fi module . We program three practical scenes:
-
Return home : rapid climb in winter, then eco maintenance.
-
Night : reduced temperature, fan slowed down.
-
Heatwave : priority to dehumidification to keep the room cool without excessive cold.
HVAC Maintenance and Longevity
To keep the heat pump efficient:
-
Clean filters every 4 to 6 weeks during peak usage;
-
Annual inspection : pressures, blowing temperature, electrical tightening, condition of insulation, condensate test;
-
Condenser clearance : no objects within 30 cm, check after snow episodes.
Our HVAC maintenance contracts include these points and extend the life of the equipment.
Security, co-ownership and compliance
In condo in Saint-Laurent, we coordinate:
-
the schedule with the union for access to the balcony;
-
compliance with facade regulations (color of hoods, visibility from the street);
-
protection of surfaces (balcony floor, railings) during work.
All connections are made to the manifold , deep vacuum with vacuum micron , and additional charge if the length exceeds the manufacturing base.
Savings and subsidies
High-efficiency R-32 wall-mounted heat pumps are generally eligible for programs in effect in Quebec when performance thresholds are met. We provide:
-
proof of performance coefficients ,
-
the detailed invoice with serial numbers,
-
the installation certificate required for aid applications.
On a daily basis, the combination of inverter + good sealing of the refrigeration path results in:
-
a significant reduction in kWh compared to electric baseboards alone,
-
stable comfort without sudden variations.
What the customer gains
-
Immediate comfort in the living area, summer and winter;
-
Silence compatible with co-ownership life;
-
Controlled aesthetics : discreet capping, clean drilling, integration above the patio door;
-
Added value to the condo thanks to a recent and efficient system.
The AirGreen signature
We operate in Montreal, Laval, Longueuil, on the North Shore and the South Shore , with a team of technicians who know the specific features of Saint-Laurent buildings: balcony access, co-ownership schedules, winter protection. Each site is delivered clean , documented and ready for annual maintenance.
Planning a heat pump installation in a similar condo? We offer a quick technical visit , clear sizing , and careful commissioning that maximizes performance from day one.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).
