Project

Installation of a Gree wall-mounted heat pump in Brossard

In Brossard, AirGreen installed a Gree Inverter R32 wall-mounted heat pump on a single-family home, providing 4-season comfort, a discreet outdoor installation and a significant reduction in heating and cooling costs.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of a Gree wall-mounted heat pump in Brossard
Installation of a Gree wall-mounted heat pump in Brossard
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

In Brossard, on Montreal's South Shore, a family owning a single-family home wanted to modernize their heating and air conditioning system. Their goal: to be comfortable during both summer heat waves and the bitter cold of winter, while reducing their electricity bill.

We recommended the installation of a Gree Inverter wall-mounted heat pump with R32 , a high-performance and discreet residential system, perfectly suited to the climatic realities of Greater Montreal.


A typical South Shore residential project

The house is typical of Brossard's residential neighborhoods: pale vinyl siding, a brick corner wall, a small lawn, and a nearby driveway. The client had limited space on the side of the house, which necessitated a compact, unobstructed, and safe outdoor installation.

Before starting the work, we have:

  • analyzed the orientation of the facade and the prevailing winds;

  • checked the necessary clearances around the future condenser;

  • planned the routing of the refrigeration lines and the condensation drain in a clean and discreet manner.

The goal was to integrate the Gree heat pump harmoniously, without harming either the aesthetics of the house or daily movement around the yard.


Why a Gree R32 wall-mounted heat pump?

The Gree wall-mounted range with Inverter technology uses R32 refrigerant, category A2L , as indicated on the outdoor unit's label. This choice offers several tangible advantages for a Brossard homeowner:

  • High energy efficiency : the inverter compressor modulates continuously, which helps to avoid energy-intensive on/off cycles.

  • Cold weather performance : Gree R32 models maintain very good heating capacity even in temperatures well below freezing, ideal for Quebec winters.

  • Reduced environmental impact : R32 has a lower global warming potential (GWP) than the old R410A, making it part of a more responsible approach.

  • Acoustic comfort : the fan and compressor are housed in a well-insulated casing, significantly reducing noise both outside and inside.

In this project, we configured the system as a single-zone wall-mounted heat pump , dedicated to the main living area of ​​the house (open-plan living room, dining room and kitchen).


Details of the outdoor unit installation

The photo shows the Gree outdoor unit installed against the side wall of the house. Several technical choices were made to guarantee reliability and longevity:

  • Wall-mounted : The condenser is securely fixed to metal brackets anchored to the wall. This raises it off the ground to protect it from the accumulation of snow, ice, and debris.

  • Clearance around the fan : the area in front of the grille is clear to ensure optimal air circulation, essential for the proper functioning of the heat pump.

  • Condensate management : a PVC drainage pipe runs down under the unit, allowing for the clean removal of summer condensation water.

  • Protected refrigeration connections : refrigerant lines and wiring are grouped, protected and routed to the house in an orderly manner, which facilitates future maintenance and avoids direct exposure to the elements.

  • Intelligent positioning : we have placed the unit away from falling ice from the roof and at the edge of the passage area, in order to limit the risk of impact and vibration.

As with all our installations, we checked the level of the supports, carried out a rigorous vacuuming, checked for leaks and validated the operating pressures before commissioning.


Interior comfort and performance in all seasons

Inside, the Gree wall-mounted unit diffuses air gently and evenly, without harsh drafts. Thanks to the precise modulation of Inverter technology:

  • In summer , the house stays cool even on hot and humid days, thanks to effective dehumidification;

  • In mid-season , the heat pump ensures stable comfort while consuming very little energy;

  • In winter , the system takes over a large part of the heating, reducing the use of electric baseboard heaters and therefore the Hydro-Québec bill.

The customer has already noticed that the temperature is much more constant from room to room, and that the feeling of heaviness and summer humidity has disappeared.


Results for the Brossard family

Since the Gree wall-mounted heat pump was installed, the homeowners have benefited from:

  • four-season comfort in the main rooms;

  • a good reduction in the electricity bill , particularly in winter;

  • a quieter house , with the wall-mounted head operating at very low speed most of the time;

  • modern and environmentally friendly equipment , thanks to the R32 refrigerant and high energy efficiency.

The discreet installation of the outdoor unit on the side of the house also helps to preserve the aesthetics of the front facade and the backyard.


AirGreen: Your Gree heat pump specialist in Brossard

At AirGreen, we assist homeowners in Brossard and throughout the South Shore in choosing and installing their wall-mounted or central heat pump .

For each project, we:

  • Let's analyze the reality of the house (insulation, orientation, available space);

  • Let's properly size the heat pump's power;

  • We offer the best options from recognized brands like Gree , favouring Inverter models over R32;

  • Let's carry out a clean, safe and compliant installation;

  • We offer rigorous after-sales service (maintenance, troubleshooting, usage advice).

If, like this family from Brossard, you wish to improve your comfort while reducing your energy costs, we would be delighted to study your project and offer you the most suitable solution for your home.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment