Project

Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie

In Rosemont–La Petite-Patrie, we installed a Gree wall-mounted heat pump to provide year-round comfort in a home heated by electric baseboard heaters. Discreet, quiet, and energy-efficient, it now provides summer air conditioning and a significant portion of the winter heating, with a clean and professional interior finish.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
Installation of a Gree wall-mounted heat pump in Rosemont–La Petite-Patrie
–chapters in this story
5 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

In this typical Rosemont–La Petite-Patrie apartment in the heart of Montreal, we installed a Gree wall-mounted heat pump to offer our clients four-season comfort while reducing their electricity bill.


The context: a home heated by electric baseboard heaters

The apartment is heated primarily by electric baseboard heaters, controlled by a wall thermostat visible beneath the unit. Like many apartments in the area, wall space is limited: doors, hallways, and other openings restrict installation options.

The client's objective was clear:

  • to effectively air-condition the living room and the hallway leading to the other rooms;

  • add efficient heating for the mid-season and a good part of the winter;

  • maintain a clean aesthetic, without visible ducts or conduits inside.

The Gree wall-mounted heat pump emerged as an ideal solution: compact, quiet and capable of heating even in cold weather.


Choosing the Gree wall-mounted heat pump

We opted for a new generation Gree wall-mounted heat pump , single-zone type, with a capacity of around 12,000 BTU, perfectly suited to a medium-sized open area.

Some key features of this Gree range:

  • operation in heating mode down to very low outside temperatures;

  • Inverter technology to precisely follow demand without overconsumption;

  • modern refrigerant with low environmental impact;

  • very low noise level, both inside and outside.

The discreet display on the right-hand side (setpoint temperature) allows the customer to check the setting at a glance without cluttering the room's design.


A wall-mounted installation designed for comfort

The indoor unit was installed high up, centered on the wall between a bedroom door and a hallway. This position is not accidental:

  • it allows the blown air to spread widely throughout the main room;

  • the airflow can be directed towards the corridor in order to send coolness or heat to other rooms;

  • Avoid blowing directly onto the sofa or dining table, for comfort without drafts.

Motorized louvers direct airflow downwards and forwards, ensuring good temperature stratification in the room. Inside, there are no visible pipes: the refrigerant lines and condensate drain run directly behind the unit, through the exterior wall. The result: a completely clean and minimalist wall .

The original thermostat for the electric baseboard heaters is retained at the bottom of the wall: the baseboard heaters remain available as a supplement or backup, but it is now the Gree that provides most of the heating and air conditioning.


Technical details of the installation

As with all our installations, we have applied best HVAC practices:

  • Dedicated power supply from the panel, with appropriate circuit breaker and external circuit breaker near the compressor.

  • Passage of refrigerant lines through the wall to the outdoor unit, with discreet casing on the outside to protect the pipes and wiring.

  • Nitro leak test followed by deep vacuuming to guarantee the absence of moisture and air in the refrigeration circuit.

  • Drain slope settings to ensure condensate drainage in air conditioning mode, without risk of dripping or backflow.

  • Complete commissioning : checking pressures, blowing temperature, remote control calibration, explaining modes to the customer (heating, air conditioning, dehumidification, ventilation, eco mode, etc.).

The outdoor unit, installed on anti-vibration supports outside the dwelling, was positioned to facilitate maintenance and snow removal while limiting the transmission of noise into the interior.


Comfort, savings and silence in everyday life

From the very first days, the occupants noticed:

  • a noticeable decrease in humidity and heat during summer heat waves;

  • a gentle and constant warmth in autumn and in the heart of winter, without the sudden fluctuations like with baseboards;

  • a reduction in electricity consumption , since the Gree heat pump recovers energy from outside rather than producing heat solely by electrical resistance;

  • very quiet operation: the fan at low speed is barely perceptible in the room.

Thanks to the remote control and the display on the front panel, setting it up is simple: a set temperature, a mode, and the Gree wall-mounted heat pump takes care of the rest.


Why entrust your Gree heat pump project to AirGreen?

In Rosemont–La Petite-Patrie, as elsewhere in Greater Montreal, we support our clients from start to finish:

  • needs analysis and capacity sizing in BTU;

  • advice on the best indoor/outdoor location;

  • installation compliant with Quebec standards, by certified technicians;

  • assistance for grant programs where applicable;

  • After-sales service and maintenance to ensure the longevity of the system.

If you live in Montreal, Laval, the North Shore or the South Shore and are considering installing a Gree wall-mounted heat pump to improve your comfort in summer and winter, we would be happy to advise you .

Contact us for a free evaluation: we will find, as here in Rosemont–La Petite-Patrie, the most efficient and discreet solution for your home.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment