Home » AirGreen's Outstanding HVAC Projects in Greater Montreal, Laval, Longueuil, South Shore and North Shore » Installation of a Gree wall-mounted heat pump in Sainte-Dorothée, Laval
Project

Installation of a Gree wall-mounted heat pump in Sainte-Dorothée, Laval

Installation of a Gree wall-mounted heat pump in Sainte-Dorothée, Laval. AirGreen offers a complete HVAC service, combining energy efficiency and aesthetics.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a Gree wall-mounted heat pump in Sainte-Dorothée, Laval
Installation of a Gree wall-mounted heat pump in Sainte-Dorothée, Laval
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

A residential project combining energy efficiency and aesthetics

At AirGreen , we understand that every wall-mounted heat pump installation must meet both technical requirements and the aesthetic expectations of the homeowners. In this project in Sainte-Dorothée, Laval , we installed a Gree outdoor unit on a raised support to ensure optimal performance and discreet integration along the wall of the house.

Client context and needs

The client, a single-family home owner, was looking for a heating and cooling solution adapted to Laval's hot summers and harsh winters. Their goal was twofold: to improve their comfort while reducing their energy consumption. The wall-mounted heat pump represented the best compromise, offering both high efficiency and faster installation than a central system.

Technical details of the installation

  • Machine type : Wall-mounted heat pump (mini-split)

  • Brand : Gree

  • Outdoor installation : unit mounted on a galvanized steel support to raise it off the ground and prevent the accumulation of snow and moisture.

  • Refrigeration connections : sheathed and fixed with a gray capping matching the house cladding for a discreet aesthetic finish.

  • Condensate drainage : gravity system, optimized to prevent any water returning to the unit.

  • Power supply : secure connection via an external box and dedicated circuit breaker, in accordance with the standards of the Quebec Electrical Code.

Constraints and solutions provided

  1. Limited space between the house and the fence
    The narrow side strip made it impossible to place the unit on the floor. We therefore opted for a raised wall mount , guaranteeing both sufficient airflow and optimal clearance for maintenance.

  2. Protection against moisture and snow
    The north-facing location required an installation at sufficient height to avoid snow accumulation. The chosen solution ensures reliable operation even during periods of intense cold.

Benefits of the Gree heat pump

The Gree range is renowned for its stable performance and durability, making it particularly suited to Quebec's climatic conditions. Customer benefits include:

  • Year-round comfort : efficient heating down to -25°C and effective air conditioning in summer.

  • Energy savings : Inverter technology reduces electricity consumption compared to a traditional heating system.

  • Eligibility for subsidies : several programs such as LogisVert Hydro-Québec or Chauffez Vert can reduce the cost of acquisition and installation.

Why choose AirGreen for your HVAC installation in Laval?

  • Local expertise : hundreds of heat pump installations in Greater Montreal, adapted to the climatic and architectural realities of each neighborhood.

  • Personalized approach : we analyze the specific constraints of each residence in order to offer tailor-made solutions.

  • Careful and durable work : aesthetic integration, compliance with safety standards, and follow-up after installation to ensure customer peace of mind.

Conclusion

This installation in Sainte-Dorothée perfectly illustrates our commitment: to offer sustainable, efficient HVAC solutions that are perfectly integrated into the residential environment. Thanks to the Gree heat pump , our client now benefits from optimized comfort, both winter and summer, while enjoying real savings on their energy bill.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    GrantsAssistance programs in effectAirGreen checks your model before quoting an amount.PermitsYour city’s rulesLocation, distances, noise: what changes from city to city.InstallationOur installation serviceGreater Montréal and Montérégie.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    Book my free estimate514 316-2973
    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment